Bolens 190-758 - Manual
Bolens 190-758 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SECTION 1: IMPORTANT SAFE OPERATION PRACTICES; GENERAL OPERATION
- Page 7 – SECTION 3: OPERATION; TO START ENGINE
- Page 8 – TO STOP ENGINE; SECTION 4: MAINTENANCE; ENGINE
- Page 13 – SECTION 7: TROUBLE SHOOTING GUIDE
- Page 16 – MANUFACTURER’S LIMITED WARRANTY FOR:
OPERATOR’S MANUAL
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
MTD PRODUCTS INC. P.O. BOX 368022 CLEVELAND, OHIO 44136-9722
8 HP TILLER
ATTACHMENT
Model Number
190-758
PRINTED IN U.S.A.
FORM NO. 770-8371A
Warning:
This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P.O. Box 368022 Cleveland, Ohio 44136-9722.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OFYOURSELF AND OTHERS. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUALBEFORE ATTEMPTING TO OPERATE YOUR UNIT. WHEN ...
7 Figure 13 14. There are two different types of seat safety switches. Refer to Figure 13A and Figure 13B. If the seat switch on your tractor is as shown inFigure 13A , assemble the adapter harness as follows. • On units with a one-piece fender, first remove the fender from the unit by removing for ...
8 3. Push the CHOKE lever down all the way. Setthe throttle in the FAST position. See Figure 15. NOTE: A warm engine requires less choking. 4. Grasp the recoil starter handle and pull backrapidly, extending rope fully. Return it slowly tothe engine. 5. After engine starts, move choke lever gradually...
