Blaze BLZ-ICEMKR-50GR User Manual

Page 2 - TABLE OF CONTENTS; Page

1 TABLE OF CONTENTS Page ICE MAKER SAFETY ......................................................................................... 2 IMPORTANT SAFEGUARDS ........................................................................ 3 - 5 TECHNICAL INFORMATION ...............................................

Page 3 - ICE MAKER SAFETY; Your safety and the safety of others are very important.; appliance. Always read and obey all safety messages.; IMPORTANT SAFETY INSTRUCTIONS

2 ICE MAKER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can injure or ...

Page 4 - CALIFORNIA PROPOSITION 65 WARNING; Before the ice maker is used, it must be properly positioned and; IMPORTANT SAFEGUARDS; Before operating, pull all panels back into place.

3 CALIFORNIA PROPOSITION 65 WARNING WARNING: This product can expose you to chemicals including Chromium (hexavalent compounds), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to: www.P65Warnings.ca.gov Before the ice ...

Page 5 - SAVE THESE INSTRUCTIONS; Electrical Connection

4 50°F (10°C) and below 100°F (38°C). This unit MUST be installed in an area protected from the elements, such as wind, rain, water spray or drips.  The ice maker is designed to be installed in an outdoor kitchen, but must not be placed directly adjacent to a grill or other source of high heat. A m...

Page 6 - Extension Cord; TECHNICAL INFORMATION

5 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. The ice maker should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating label on the appliance....

Page 7 - COMPONENT LOCATIONS

6 COMPONENT LOCATIONS Water distribution tube Evaporator (ice mold) Water trough Float Ice storage bin Control panel Front louver panel Door Caster Ice scoop Water supply hose Power cord Water inlet Drain outlet Drain hose

Page 8 - ICE MAKER INSTALLATION; Unpacking; Remove packaging materials.; Cleaning and Maintenance; Location requirements; INSTALLATION CLEARANCES:; Excessive Weight Hazard

7 ICE MAKER INSTALLATION Unpacking Remove packaging materials. IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice maker. Remove tape and glue from your ice maker before using.  To remove any remaining tape or glue. Tape or glue residue can also be easily removed...

Page 9 - It is required that a water filter be used.; Leveling the Ice Maker

8  This ice maker should be properly installed by qualified personnel.  To ensure proper ventilation for your ice maker, the front of the unit must be completely unobstructed.  When installing the ice maker under a counter, follow the recommended spacing dimensions shown. Allow at least 4" (1...

Page 10 - and wall or cabinet.; Electrical requirements; you have the proper electrical connection:; Recommended grounding method

9 IMPORTANT: Do not kink or pinch the power supply cord between the icemaker and wall or cabinet. Electrical requirements Before you move your ice maker into its final location, it is important to make sure you have the proper electrical connection: A standard electrical supply (115V AC only, 60Hz, ...

Page 11 - Leveling the ice maker; Adjust the height of the; Reversing the door swing; flathead screwdriver, Phillips screwdriver

10 Leveling the ice maker It is important for the ice maker to be leveled in order to work properly. Otherwise water will not flow properly through the evaporator (ice mold). The ice production will be less than normal, and may be noisy. The unit can be raised or lowered by rotating the plastic shea...

Page 12 - Water Supply; Professional installation is recommended.; Connecting the water line:

11 3. Remove the door hinge 2 and place it on the opposite top side. Separate the axis from the hinge 2 and set it aside. 4. Swap the door handle. 5. Keep the handle apart from the hinge side. Align the door on the bottom hinge 1 and replace axis on the hinge 2. Tighten it firmly. 6. Push the plug b...

Page 13 - Drain; Connecting the drain line:

12 2. Find a ½-in. to ¾-in. vertical cold water pipe near the installation location. The distance should be less than 6 feet. The water supply hose provided with the ice maker is about 6 feet long. 3. A shut-off valve must be installed to the main water supply. If the water pipe has a plain piece of...

Page 14 - Installation Types; Mobile installation:; on a platform depending on your installation requirements.

13 IMPORTANT: This ice maker is not a freezer. Insufficient drainage will cause a high rate of melting in the ice storage bin. Installation Types This ice maker has been designed for Mobile (free-standing) installation. However, it can also be Enclosed (as under a cabinet) or Built-in (sealed to the...

Page 15 - OPERATION; Final Check List before Operation

14 OPERATION Final Check List before Operation 1. Have all packing materials and tape been removed from the interior and exterior of the ice maker? 2. Did you clean the ice storage bin? 3. Have the installation instructions been followed, including connecting the machine to water and electricity? 4....

Page 16 - Freeze; How the machine uses the water

15 to the ice storage bin. 4. When the ice storage bin is full, the sheet of cubes will not fall completely and will hold the bin-full probe open. The machine stops making ice automatically. 5. The unit will start making ice again after the ice cubes are removed. Then the bin-full probe swings back ...

Page 18 - Do not touch the power plug when your hands are wet.; CLEANING AND MAINTENANCE; Important Note; There are 5 things to keep clean:

17 bin. 5. Pull off the drainage tube of the water trough to drain off all water. 6. Leave the door open to allow for circulation and to prevent mold and mildew. 7. Leave water supply line and power cord disconnected until ready to reuse. IMPORTANT:  Do not touch the power plug when your hands are ...

Page 21 - Ice-making system cleaning

20 1. Shut off the water supply. 2. Disconnect the water hose from the distribution tube. 3. Gently take out the distribution tube. 4. With a brush, clean the tube with a dilute solution of warm water and a mild detergent such as dishwashing liquid. After removing the dirt and lint from the surface,...

Page 22 - Description of LEDs and buttons:

21 the ice making system thoroughly.  NOTE: Ice Maker Cleaner Solution in the water bin during the rinse is not needed. 6. Prepare a sanitizing solution made of 1 ounce of household bleach and 2 gallons of hot water (95ºF to 115ºF). Wipe the entire bin inside and outside, covering the entire surfac...

Page 23 - Ice Size Adjustment Guide:

22 for 3 minutes, then the unit will restart and return to the ice making mode. 2. Ice (Green) LED : Ice making indicator light When this is lit, the unit is working in the ice making mode controlled by a temperature probe on the evaporator. When the green LED flashes, the unit is working in the ice...

Page 24 - MAJOR FUNCTIONS; The operating procedure is completely automatic.; TROUBLESHOOTING; Before Calling for Service; Troubleshooting Guide; Problem

23  When the machine is in the cleaning stage or ice full stage, the ice size adjustment mode cannot be accessed. MAJOR FUNCTIONS 1. The operating procedure is completely automatic. 2. When the ice storage bin is full of ice cubes, the machine stops making ice automatically. It starts making ice ag...

Page 26 - LIMITED WARRANTY; Year Warranty; Warranty claim procedure; : If you require parts for your refrigerator, please

25 LIMITED WARRANTY Manufacturer warrants to the original purchaser at the original site of delivery with proof of purchase of each Refrigerator that when subject to normal residential use, it is free from defects in workmanship and material for the periods specified below.This warranty excludes ref...

Blaze BLZ-ICEMKR-50GR - User Manual

Table of Contents:

Was this manual helpful?

About this manual

Summary

Ask a question