Black Box PSD-8 - Manual
Black Box PSD-8 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FCC STATEMENT; FEDERAL COMMUNICATIONS COMMISSION
- Page 4 – TRADEMARKS
- Page 6 – CHAPTER 2: Introduction
- Page 7 – Configuring the PSD Printed Circuit Board
- Page 8 – CHAPTER 3: Installation
- Page 12 – CHAPTER 4: Operation and Troubleshooting; Operation and Troubleshooting; Changing Setting During Operation
- Page 14 – CHAPTER 5: Technical Guide; Figure
- Page 17 – © Copyright 1998. Black Box Corporation. All rights reserved.
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
Web site: www.blackbox.com • E-mail: [email protected]
CUSTOMER
SUPPORT
INFORMATION
SEPTEMBER 1998
TL304A
TL305A
PSD-4
PSD-8
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
FCC STATEMENT 1 FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and usedproperly, that is, in strict accordance with the manufacturer’s instructions, may cause i...
TRADEMARKS 3 TRADEMARKS USED IN THIS MANUAL AS/400 is a registered trademark of International Business Machines Corporation. Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.
CHAPTER 2: Introduction 5 2. Introduction The Programmable Sharing Device enables up to 4 (TL304A) or 8 (TL305A) modems or terminals to sharea master modem, multiplexor, or computer port in an asynchronous or synchronous multipoint environment.(Asynchronous and synchronous equipment cannot be mixed ...
