Page 5 - VERSION CONTROL; Version; the device micro program
User Manual VERSION CONTROL Version Date Major changes to previous version 1.0 31.12.2001 Initial version of the manual corresponding to version 1.2 of the device micro program 1.1 23.10.2003 New function description corresponding to software release V1.6 Corrected Connecter description 9.1 Changed ...
Page 6 - GENERAL
User Manual 1 GENERAL INFORMATION • High-speed symmetrical data transmission over one physical copper twisted pair with the 135 Ohm impedance according to ETSI TS 101 135. • ITU-T G.991.2 (G.shdsl) line encoding. • Line rate in the range from 72 Kbit/s to 2320 Kbit/s in 2 wire mode Line rate in the ...
Page 7 - ORDER INFORMATION
User Manual ORDER INFORMATION MDS932AE-10BT Modem AccessDSL Discovery, G.shdsl, 10/100Base-T Bridge, VLAN, Adapter 220 Vac MDS933AE-10BT Modem AccessDSL Discovery, G.shdsl, 1 or 2 pairs, up to 4.6Mbps, 10/100Base-T Bridge, VLAN, Adapter 220 Vac MDS932AE-FXS Modem AccessDSL Discovery, G.shdsl, 10/100...
Page 8 - DESCRIPTION OF THE DEVICE; Exterior design Desktop models
User Manual 2 DESCRIPTION OF THE DEVICE 2.1 Exterior design Desktop models The front panel of the device has 3 LEDs: LOCAL informs the user about the status of the local device. The following four statuses are possible «blinking red» informs the user about malfunctioning of the modem’s hardware and ...
Page 9 - is implemented using an external power supply unit
User Manual The back panel of the MDS932AE-10BT and MDS933AE-10BT modem has: • The grounding bolt of the modem (option); • The “AC12V” power connector. The connection of the modem to the 220 V power supply is implemented using an external power supply unit; • the “Monitor” connector to control the m...
Page 10 - Exterior design rack card models
Page 12 - RULES; The standalone delivery set
User Manual 3 RULES OF SWITCHING 3.1 The standalone delivery set The delivery set includes: • the subscriber access device (a modem) • the power supply source (an AC adapter) • the cables for the line connections 3.2 The rack-card delivery set The delivery set includes: • the subscriber access devic...
Page 13 - After entering the password the following menu will appear.; The modem is ready to be configured.
User Manual To update the information on the screen use the “Enter” key. The following menu will appear on the screen. Input Password: Please enter your programmed password. The unit will be delivered with the default password “admin” After entering the password the following menu will appear. Disco...
Page 14 - COMMAND; rules; It is necessary to input item number, for choising menu item,; main; The main menu is the following:
User Manual 4 THE COMMAND SYSTEM 4.1 Basic rules After the command is typed, press <enter>. The <Backspace> key is used to edit commands. It is necessary to input item number, for choising menu item, You can use “PageUP”, “PageDown” and “Space” keys, for scrolling list of available value...
Page 15 - Performance management submenu
User Manual 4.3 Performance management submenu Upon activation of the performance management submenu the following message will be displayed. Performance Management 1.Loop Status... 4.EtherNet Status... Select item number or ESC to Upper level menu>> 4.3.1 Loop Status submenu Upon activation o...
Page 16 - Configuration management submenu
User Manual 4.3.2 Ethernet Status submenu Upon activation of the performance management submenu the following message will be displayed. Performance Management->EtherNet Status Link:Link down Link Speed:---- Link Duplex:---- Used Entries:0 Tx Packets:0 Rx Packets:0 Fwd Packets:0 Drop Packets:0 Sp...
Page 17 - In this menu you can setup the unit to one of the following states:
User Manual 4.4.1 DSL Setup In this menu you can setup the DSL link. When you have selected that menu, the following will appear: Configuration Management->DSL Setup 1.[Loop 1 Operation Mode]:Slave 2.[Loop 1 Auto/Fixed]:Fixed 5.[Loop 1 Fixed Connection Speed]:2312K(36N) 6.[Loop 1 Annex]:A/B 7.[Lo...
Page 18 - Annex you have to setup, and then use the A / B configuration.
User Manual 4.4.1.4 Fixed Connection Speed (only if Fixed is selected) • In the Fixed Connection Speed menu, you can specify your desired speed in the range of 72 kbps to 2312 kbps for 2wire units and 144 kbps to 4624 kbps for 4wire models 4.4.1.5 Annex • With the Appendix menu you can choose betwee...
Page 19 - Ip settings; Security management submenu
User Manual 4.4.2 Ethernet Setup submenu Configuration Management->EtherNet Setup 1.[Speed]:Auto 2.[Duplex Mode]:Auto 3.[Disable Mac Filter]:No 4.IP Address>>192.168.5.105 5.Subnet Mask>>255.255.255.0 6.Gateway Address>>192.168.5.1 Select item number or ESC to Upper level menu&g...
Page 20 - TECHNICAL
User Manual 5 TECHNICAL SPECIFICATIONS The main technical specifications of modems of the Black Box family are presented below in the table. Line interface. Standard ETSI 101 135 Number of pairs 1 Line rate 2 wire models 4 wire models 72 – 2312 Kbit/s 144 – 4624 Kbit/s Communication range for cables...
Page 21 - STORAGE; and the relative humidity of air
User Manual 6 STORAGE CONDITIONS The equipment of the Black Box family while being packed should withstand all means of transport at a temperature in the range form -50 о С to +50 о С and the relative humidity of air up to 100% at 25 о С . The equipment can also withstand air-transport at a low air ...
Page 22 - TERMS TO TRANSPORT; motor transport with an enclosed truck body
User Manual 7 TERMS TO TRANSPORT The equipment of the Black Box family should be packed and transported by: • motor transport with an enclosed truck body; • enclosed railroad cars; • unpressurized airplanes and helicopters (up to 10000 m at an air pressure of 170 Torr); • river transport (in holds)....
Page 23 - CONNECTOR’S; Connector; female
User Manual 8 CONNECTOR’S DESCRIPTION 8.1 DSL Connector Type: RJ-45, 8 pin Number Signal Assignment 1,2 NC - 3 LB,a Ttp (4W model only) 4 LA,a tip 5 LA,b ring 6 LB,b ring (4W model only) 7,8 NC - RJ-45 1 8 8.2 Monitor Connector Type: Sub-D9, female Number Signal Assignment 1 NC - 2 TXD Transmit data...
Page 24 - PC and Hub Connectors
User Manual 8.3 PC and Hub Connectors Type: RJ-45 Number PC assignment HUB assignment 1 Tx+ Rx+ 2 Tx- Rx- 3 Rx+ Tx+ 4 NC NC 5 NC NC 6 Rx- Tx- 7 NC NC 8 NC NC 1 8 RJ-45 8.4 Line1 and Line2 Connector Type: RJ-11, 4 pin Number Signal Assignment 1 NC - 2 LA,a tip 3 LA,b ring 4 NC - RJ-11 1 4 Version: 1....
Page 25 - DESCRIPTION OF INTERFACE CABLES; cable
User Manual Version: 1.2 Page. 25 of 25 9 DESCRIPTION OF INTERFACE CABLES 9.1 Ethernet cable Side А Color of wire Side B 1 white/green 1 2 green/white 2 3 white/orange 3 4 blue/white 4 5 white/blue 5 6 orange/white 6 7 white/brown. 7 8 brown/white 8 9.2 DSL cable Side А Color of wire Side B 1 white/...
