Black Box LE071A - Manual - manualsarea.com

Page 2 - FCC STATEMENT; FEDERAL COMMUNICATIONS COMMISSION

1 FCC STATEMENT FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with themanufacturer’s instructions, may cause interference to radio c...

Page 3 - MODULAR PARALLEL ADAPTERS AND MODULAR MEDIA UNITS; Contents; Chapter

2 MODULAR PARALLEL ADAPTERS AND MODULAR MEDIA UNITS Contents Chapter Page 1. Specifications ....................................................................................... 3 2. Introduction......................................................................................... 4 2.1 Availab...

Page 4 - CHAPTER 1: Specifications; — Conforms to the IEEE

3 CHAPTER 1: Specifications Connectors — LE071A, LE073A: (1) RJ-45 male; LE171: (1) RJ-45 female, LE072A, LE074A: (1) BNC male; LE172: (1) BNC female; LE075A: (1) AUI male; LE175: (1) AUI female Size — 4.1"H x 2.4"W x 1"D (10.4 x 6.1 x 2.5 cm) Weight — 0.2 lb. (0.1 kg) Standards — Confor...

Page 5 - Modular Parallel Adapters:; NOTE

4 MODULAR PARALLEL ADAPTERS AND MODULAR MEDIA UNITS 2. Introduction 2.1 Available Models The following models of the Adapters and the Media Units areavailable: Modular Parallel Adapters: • LE071A: Modular Parallel Adapter w/SPC for 10BT • LE072A: Modular Parallel Adapter w/SPC for BNC • LE073A: Modu...

Page 6 - CHAPTER 2: Introduction

5 CHAPTER 2: Introduction 2.2 Features The Adapters offer the followingfeatures: • Fits any Ethernet cable type via modular snap-on media units • Supplied with drivers for Novell ® NetWare ® (ODI™), Microsoft ® LAN Manager, 3Com ® 3+Open™ (NDIS), ArtisoftLANtastic and Packet TCP/IP • Powered by the ...

Page 7 - through

6 MODULAR PARALLEL ADAPTERS AND MODULAR MEDIA UNITS 3. Installation IMPORTANT! Make sure the computer isturned off while performingthe install procedure. 3.1 Attach the Media Unit To attach the Media Unit to theAdapter, hold the Adapter with thelogo facing up, press the top andbottom of the unit tog...

Page 8 - Fig. 3-2. Connecting an Unshielded Twisted Pair Cable to the Media

7 CHAPTER 3: Installation 3.2 Connect the Network Cable Connect the network cable unit asillustrated for each model below. 3.2.1 LE071A AND LE073A For the Modular Parallel Adapterw/SPC for 10BT (LE071A) and theModular Parallel Adapter w/EPS for10BT (LE073A), refer to Fig. 3-2 . Fig. 3-2. Connecting ...

Page 10 - CHAPTER 3: Installation; After connecting the connector,

9 CHAPTER 3: Installation NOTE B o t h e n d s o f t h e T -connector must be attachedt o n e t w o r k c a b l i n g . I f t h eA d a p t e r i s a t t h e e n d o f anetwork segment, the end ofthe T-connector not attached to the network must have a50-ohm terminator installed. 3.2.3 LE075A For the ...

Page 12 - . Plug the other end of the

11 CHAPTER 3: Installation 3.5 Install the AC Power Adapter If the SPC is not used, plug the ACpower adapter cable into the smallround socket at the back of theModular Media Unit, as shown in Fig. 3-6 . Plug the other end of the AC adapter cable into any standardelectrical outlet. The red LED willth...

Page 13 - Software Setup and Operation

12 MODULAR PARALLEL ADAPTERS AND MODULAR MEDIA UNITS 4. Software Setup and Operation The \ODI subdirectory contains thefollowing DOS ODI files for use withNovell NetWare and other networkoperating systems using the ODIspecifications: • LSL.COM — The Novell Link Support Layer program • SETODI.COM — P...

Page 14 - ODI Driver for Novell NetWare; CHAPTER 4: Software Setup and Operation

13 • .\ETHERNET\POCKET\ PROTOCOL.INI—Sampleinitialization file • .\NIF\SETDOS.NIF— Configuration file used by thesetup program The \MSLANMAN.OS2\DRIVERSsubdirectory contains the drivers andfiles for Microsoft LAN ManagerOS/2 workstation. • .\ETHERNET\POCKET\ SETNDIS.OS2—Driver forMicrosoft LAN Manag...

Page 16 - reverse; Microsoft LAN Manager; LAN M

15 4.2.3 O PERATION To start work on the NetWareworkstation, run the STARTNETbatch file. Then log into thenetwork. The STARTNET.BAT file includes the following set of commands: LSLSETODIIPXODINETXF: If you wish, you may enter these commands in the AUTOEXEC.BATfile in the order shown. To unload the O...

Page 19 - In the “Network Settings”; Complete the installation by

18 MODULAR PARALLEL ADAPTERS AND MODULAR MEDIA UNITS 7. In the “Network Settings” window, choose “OK.” From thenext window choose “RestartComputer.” The content of the Modular ParallelAdapter OEMSETUP.INF file is: [disks]A:=., “Modular Parallel Adapterinstall” [netcard]ms$sndis=“Modular ParallelAdap...

Page 20 - SERVER

19 CHAPTER 4: Software Setup and Operation 4.5.2 C ONFIGURATION (O PTIONAL ) SETAILAN accepts the followingstandard command line switches: HELP, XEROX, IEEE, MPX,PACKET_SIZE, REMOVE,VERBOSE, “?” and “@.” In addition to the standardcommand line switches, SETAILANaccepts the following: UNIDIR,LPTn, EP...

Page 21 - CAUTION

20 MODULAR PARALLEL ADAPTERS AND MODULAR MEDIA UNITS Hardware related switches are:UNIDIR, EPP, DISABLELINK andLPTn. The Network Drivers diskettecontains the SETDIAG self-testdiagnostic utility program, whichtests the adapter and reports theresults of the tests. CAUTION B e s u r e t h a t t h e n e...

Page 23 - RAM T; Once activated, all tests are run in

22 MODULAR PARALLEL ADAPTERS AND MODULAR MEDIA UNITS 5.1.1 A DVANCED RAM T EST The diagnostics portion of theSETDIAG program activates a briefRAM test. However, to thoroughlytest the Adapter’s RAM, several time-consuming tests are required. TheAdvanced RAM Test option in theSETDIAG main menu activat...

Page 24 - CHAPTER 6: Error Messages; Adapter failed to initialize correctly.

23 CHAPTER 6: Error Messages If problems occur during operationof your Adapter, one of the messagesbelow will be displayed. Errormessages can be recognized by thebeep and the word FATAL thatprecedes the message. All othermessages on the screen are forinformation only. The following is alist of commo...

Page 25 - Chapter 4; Customer Service Information

24 MODULAR PARALLEL ADAPTERS AND MODULAR MEDIA UNITS While we trust that your Adapter willoperate reliably over a long periodof time, if you encounter anyproblems while using it, pleaseperform the following steps beforecontacting Black Box. 1. Make sure that your adapter is properly installed, power...

Black Box LE071A - Manual

Table of Contents:

Summary

Other Black Box Models