B&K ST3140 - Manual - manualsarea.com

Page 3 - Table of contents

Page 1 13000 rev 0005 Table of contents Safety Precautions Page 2 Purpose and function Page 3 Design and construction Page 3 Features Page 3 Rear panel view Page 4 Rear panel description Page 4 - 5 Control muting Page 5 - 6 Level controls Page 6 Outputs Page 7 Inputs Page 7 - 8 System installation P...

Page 4 - SAFETY PRECAUTIONS; PLEASE READ BEFORE INSTALLING

Page 2 13000 rev 0005 SAFETY PRECAUTIONS PLEASE READ BEFORE INSTALLING WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNITTO RAIN OR MOISTURE. The lightning flash with arrowhead, within an equilateral triangle, is intended to alert theuser of the presence of uninsulated “dangerous volt...

Page 6 - Rear Panel View; Rear panel description

Page 4 13000 rev 0005 Rear Panel View 1. AC fuse holder 4. Inputs 2. AC Input receptacle 5. Level controls 3. Speaker outputs 6. Amplifier control muting input/output NOTE: THE BALANCED INPUTS ARE NOT AVAILABLE ON THE ST3140 AMPLIFIER Rear panel description 1. AC fuse holder - Holds the AC Line fuse...

Page 7 - Control muting; DO NOT POWER MOTORS WITH THIS CIRCUIT.

Page 5 13000 rev 0005 5. Level controls - For adjusting the input level of each channel into theamplifier. There are level controls on the back of theamplifier. One level control for each channel. Explainedfurther on page 6. 6. Amplifier control muting input/output - To provide remote switching of m...

Page 8 - Level controls

Page 6 13000 rev 0005 )LJXUH& If the control function is desired, each unit in the system must remain connected at alltimes and the control must be enabled. To enable the control function, the CTRLENABLE button must be out for each controllable amplifier in the system. For moreinformation on the...

Page 9 - Outputs; Inputs

Page 7 13000 rev 0005 )LJXUH' Outputs Five way binding posts are provided. One pair for each channel. They are designed toaccept a banana-type plug or spade lug connector (shown below) and are color codedfor easy identification. The red (+) post should always be connected to the speakers (+)jack. Th...

Page 10 - System installation

Page 8 13000 rev 0005 Here is a typical input setup: System installation There will most likely be a number of cables involved in the installation of your homeentertainment system. Pre-planning is essential in order to maximize system efficiency. We recommend the following as a means of helping you ...

Page 11 - Making the connection

Page 9 13000 rev 0005 Making the connection Before doing anything, ensure that the power switch on the amplifier’s front panelis in the ‘off’ position. Again, it is recommended that you locate a separate ACpower outlet for the amplifier, one that is not shared by any other audio component in the sys...

Page 12 - Troubleshooting; PROBLEM; DO NOT USE A HEAVIER; Care and cleaning

Page 10 13000 rev 0005 Troubleshooting PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION No sound (‘on’ LED not illuminated) 1. Power cord not plugged in. 2. Power off at AC source. 3. AC power inlet fuse blownor faulty. 4. Control switch in the wrongposition. 1. Reconnect power cord. 2. Check AC switch or f...

Page 14 - B&K Components Ltd. 2100 Old Union Road, Buffalo New York 14227

Page 12 13000 rev 0005 Limited Warranty B&K Components Ltd., referred to herein as B&K, warrants your B&K equipment against all defects inmaterial and workmanship for a period of five years from the date of purchase. This warranty appliesonly to the original purchaser and only to equipme...

B&K ST3140 - Manual

Table of Contents:

Summary

Other B&K Models