Page 2 - hanks for buying a BISSELL Vacuum; We’re glad you purchased a BISSELL vacuum. Everything we know about
2 T hanks for buying a BISSELL Vacuum 2 w w w . b i s s e l l . c o m We’re glad you purchased a BISSELL vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL vacuum is well made, and we back it with a limited...
Page 3 - MPORTANT SAFETY INSTRUCTIONS; To reduce; IMPORTANT
3 w w w . b i s s e l l . c o m I MPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, including the following: READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM. WARNING: To reduce the risk of fire, electric shock, or injury: ■ Use indoors only...
Page 4 - roduct view
4 w w w . b i s s e l l . c o m Ergonomic Loop Handle Pet Contour Tool ™ Power Switch Clean Filter Indicator Easy Empty ™ Dirt Container Headlight Height Adjustment Knob Foot Window Washable Pre-Motor Filter Scuff Resistant Bumper Carry Handle Lock ‘n Seal ™ Lever HEPA Media Post Motor Filter Wide C...
Page 5 - Attach handle to vacuum; ssembly
5 w w w . b i s s e l l . c o m The only tool you’ll need to assemble your vacuum cleaner is a Phillips screwdriver. Attach handle to vacuum 1 . Locate the handle and cord wrap. Remove the screw packet taped to the handle. 2. Stand the vacuum upright and from the rear of the unit, slide the base of ...
Page 6 - Attach vacuum hose and tools; left; Power switch
Attach vacuum hose and tools 1. Line up the tabs on the base of the Twist ‘n Snap hose with the corresponding notches on the hose collar as shown. 2. Turn the Twist ‘n Snap hose to the left to lock the hose into place. 3. Connect the curved hose wand to the hose. Grasping the curved hose wand, slide...
Page 7 - perations; Before cleaning under low furniture, check
Handle positions Press the handle release pedal, located on the lower left side of the vacuum, with your foot to place your vacuum into one of three cleaning positions. 1. Upright – For storage and above floor cleaning with tools. 2. Normal Cleaning – Press handle release pedal once. Position used f...
Page 8 - right
Transporting cleaner 1. To move your cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward. 2. The cleaner can also be moved by using the carry handle. Clean filter indicator The clean filter Indicator tells you when the air flow...
Page 9 - Special on-board tools; Hair, string and small objects can block
Special on-board tools Your vacuum is not only a powerful carpet and rug cleaner, it’s also a versatile above floor vacuum cleaner when you select one of the special tools. 1. Raise the handle to the upright position. 2. Grasp the curved hose wand handle to separate from hose wand base. 3. Attach to...
Page 10 - Power cord usage; To maximize cleaning performance, check; aintenance and care
Power cord usage 1. To use your vacuum, remove the cord and plug it into an electrical outlet. For your convenience, there are two quick release cord wraps for easy cord removal. There is also a cord clip that is part of the upper cord wrap where you can attach the cord when vacuuming. 2. When you a...
Page 11 - Empty dirt container; Unplug the vacuum from electrical outlet.
Empty dirt container The dirt container needs to be emptied when the dirt reaches the “Full” line on the container. 1. Unplug the vacuum from electrical outlet 2. Slide the Lock ‘n Seal Lever to the “Unlock” position. 3. Grasp handle and pull the dirt container straight out to remove from the vacuum...
Page 12 - Check rotating floor brush and drive belt
Check rotating floor brush and drive belt You should check your vacuum cleaner’s rotating floor brush and drive belt regularly for wear or damage. You should also clean the brush and brush ends of strings, hair and carpet fibers. This type of debris can wrap around the brush and hamper its ability t...
Page 13 - Replace drive belt
13 w w w . b i s s e l l . c o m M aintenance and care Replace drive belt 1. Unplug the vacuum from electrical outlet. 2. With rotating floor brush removed from vacuum cleaner (Steps 1-4 of check rotating floor brush and drive belt), grasp old drive belt and remove from motor pulley. Discard the old...
Page 14 - Replace lightbulb; Maintaining Pet TurboBrushTM
14 w w w . b i s s e l l . c o m M aintenance and care Replace lightbulb 1. Unplug the vacuum from electrical outlet. 2. Using a flat bladed screwdriver, pry the tab on the left and right side out and pull out to remove the lens. 3. Remove the bulb from the socket by grasping the bulb and pulling ge...
Page 15 - Clearing clogs
15 w w w . b i s s e l l . c o m M aintenance and care Clearing clogs Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor, check for clogs. 1. Unplug the vacuum from electrical outlet. 2. Empty dirt container. 3. Check upper tank fo...
Page 16 - Cleaning the upper tank
16 w w w . b i s s e l l . c o m M aintenance and care Cleaning the upper tank 1. Grasp the inner cyclone and twist to the left or to the unlocked marking, until the locking tabs stop the rotation. Pull down from the upper tank to remove it. 2. Wipe out the inside of the upper tank and the inner cyc...
Page 17 - roubleshooting; Vacuum cleaner won’t run; Thank you for selecting a BISSELL product.; Please do not return this product to the store.
17 w w w . b i s s e l l . c o m T roubleshooting Vacuum cleaner won’t run Possible causes Remedies 1. Power cord not plugged in 1. Check electrical plug 2. Damaged power cord 2. Unplug, check for damage, replace as necessary Vacuum cleaner and tools won’t pick up dirt Possible causes Remedies 1. In...
Page 18 - For Australian inquiries:; BISSELL AUSTRALIA PTY LIMITED; For New Zealand inquiries:; Parex Industries Ltd.
18 B ISSELL Consumer Services If your BISSELL product should require service: In the UK, Australia or New Zealand, call BISSELL Consumer Services at the numbers below and we will give you the location of a BISSELL Authorized Service Center in your area. For all other countries, contact your local in...
Page 19 - eplacement parts - BISSELL vacuum; Item
19 R eplacement parts - BISSELL vacuum Below is a list of common replacement parts. While not all of these parts may have come with your specific model, they are available for purchase if desired. Please note, all attachments may not store on board your vacuum. Item Part No. Part Name 1 32074 Style ...
Page 20 - Limited One Year Warranty
20 W arranty - BISSELL Pet Hair Eraser ™ Vacuum ©2008 BISSELL Homecare, IncGrand Rapids, MichiganAll rights reserved. Printed in KoreaPart Number 110-4048Rev 5/08Visit our website at:www.bissell.com 20 w w w . b i s s e l l . c o m This warranty gives you specific legal rights, and you may also have...
