Biobidet BB-2000 User Manual - Free PDF Download

Page 2 - MAINTENANCE; TABLE OF CONTENTS

2 PRODUCT INFORMATION Important SafeguardsOverview & PartsWireless Remote GETTING STARTED Functions & Features INSTALLATION Installation Guide MAINTENANCE Cleaning TipsRemoving The Nozzle TipRemoving The BB-2000Draining The Warm Water TankTroubleshooting GuideLED Flashing TroubleshootingSpec...

Page 3 - IMPORT; WATE R DOES I T; BE TT ER

4 PLEASE OBSERVE THE FOLLOWING PRECAUTIONS AND INSTRUCTIONS BEFORE INSTALLATION AND USE. • This product must be connected to a grounded 120V GFCI (Ground Fault Circuit Interrupt) outlet. Do not connect the power cord if it is damaged or broken. Do not plug the product into a loose electric outlet. •...

Page 5 - WIRELESS REMOTE

8 Remote Display Side Control Panel WIRELESS REMOTE PRODUCT INFORMA TION Stop Button Rear Wash Rear Wash Remote Signal Battery Life Water Temperature Seat Temperature Warm Water Heated Seat Deodorizer Front Wash Water Pressure Nozzle Position Dryer Turbo Wash Water Pressure Dryer On/Off Nozzle Posit...

Page 8 - BEFORE INSTALLATION; Remove Toilet Seat

INST ALLA TION GUIDE BEFORE INSTALLATION Do not plug the power cord in until installation is complete. Please contact our service center at 847.458.2334 for alternate fittings or assistance with this process. 1. Turn Off Water Turn off the water shut-off valve. Drain the toilet tank completely by fl...

Page 9 - Connect the Water Hoses

INST ALLA TION INST ALLA TION Adhesive Tape Wall 6. Plug It In! a. Remove the adhesive cover from the back of bracket and place the bracket where desired. b. Insert the supplied batteries (AAA) and close the battery cover. Ensure the batteries are inserted properly accordingly to polarity. Plug the ...

Page 10 - Cleaning the Nozzle; Cleaning the Strainer; Water Filter Maintenance

18 MAINTENANCE Cleaning the Nozzle Hold the “Rear Wash” button on the side panel for 3 seconds without occupying the seat to extend the nozzle for manual cleaning. After cleaning the nozzle, push the “Stop” button and the nozzle will retract. MAINTENANCE Cleaning the Strainer *Close shut-off valve C...

Page 11 - Draining the Warm Water Tank; Removing the Nozzle Tip

MAINTENANCE MAINTENANCE Draining the Warm Water Tank Before draining, unplug the power cord and wait 30 minutes until the unit has cooled down. Do not insert your finger into the drain hole. If you do not intend to use this product for an extended period of time,drain the water from this product’s w...

Page 12 - TROUBLESHOOTING GUIDE; LED Light is Flashing

23 22 Problem Cause Solution Water does not spray • The water tank is not filled. • The shut-off valve is closed. • Wait about one minute. Press the desired washing button once again. • Open the shut-off valve The unit is not operating • Disconnect the power cord. • The seat is not occupied. • Remot...

Page 13 - ARRANTY; WARRANTY SUMMARY; YEAR FULL WARRANTY

24 25 SPECIFICA TIONS Specifications BB-2000 Power Rating 120Vac, 60Hz, 1400W Water Inlet Pressure 0.04 ~ 0.74MPa (0.4 ~ 7.5 kgf/cm) Power Cord 4 feet Wash Device Rear Wash Max. 0.7l/min ( Max. 0.185 GPM ) Front Wash Max. 0.7l/min ( Max. 0.185 GPM ) Adjustable Water Pressure 5 Levels Warm Water Temp...

Page 14 - BIO BIDET INNOVATION LLC

This warranty does not apply to the following items: • Damage or loss sustained in a natural calamity such as fire, earthquake, flood, thunder electrical storm, etc. • Damage or loss resulting from any unreasonable use, misuse, abuse, negligence, or improper maintenance of the product. • Damage or l...

Page 15 - Customer Support; THANK

Customer Support T: 847.458.2334TOLL-FREE: 877.339.52147900 S IL Route 31 Crystal Lake, IL 60014 [email protected] THANK YOU! 03.07.24

Biobidet BB-2000 - User Manual

Table of Contents:

Was this manual helpful?

About this manual

Summary

Ask a question