Basement Watchdog BWSP - User Manual
Basement Watchdog BWSP Pump – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – DANGER; POSITIVE; WARNING
- Page 3 – Introduction; You will also need to supply:; DO NOT; Replacement Part Numbers; Battery
- Page 4 – Installation will take a couple hours.
- Page 5 – Diagram A
- Page 6 – Diagram B; CAUTION
- Page 7 – Diagram C
- Page 8 – Do not cement them; Diagram D
- Page 9 – Battery Instructions; • The use of automotive batteries is NOT; PREPARING THE BASEMENT WATCHDOG; Fill each cell; Diagram E
- Page 10 – Fill each; Battery Maintenance
- Page 11 – Diagram F
- Page 13 – REFER TO THE PHOTOS AT LEFT; REPLACING THE BATTERY; REFER TO THE PHOTOS AT RIGHT; DO NOT
- Page 14 – Fuse; REFER TO THE PHOTOS BELOW; Water; NEVER ADD MORE ACID.; GOOD
- Page 15 – REFER TO PHOTOS AT RIGHT
- Page 16 – Power; If the power is on in the rest of the house,; Charging; obstruct the hole or an air lock; BE SURE; THE REMOTE TERMINAL
- Page 17 – Basement Watchdog WiFi Module; MAINTENANCE CHECK LIST
- Page 18 – Troubleshooting Guide
- Page 19 – LIMITED WARRANTY; What is Covered by this Warranty?; All parts and labor (excluding installation) for a period of:; What is NOT Covered by this Warranty?
- Page 20 – CHECK OUT THESE OTHER BASEMENT WATCHDOG PRODUCTS; AC PUMPS; What’s a Klunkless Check ValveTM?; WATER ALARMS; Minimize the risk of water damage
Instruction Manual
& Safety Warnings
IMPORTANT: Even if you have the Basement Watchdog Special
Backup Sump Pump System installed by someone else, you must read
and follow the safety information contained in this manual. Failure
to do so could result in property damage, serious injury, or death.
Battery Backup
Sump Pump
System
Table of Contents
Important Safety Warnings and
Instructions
Electrical Precautions
1
Battery Preparation
1
Battery Precautions
1
Introduction
Items Included in System
2
Additional Items Needed
2
System Specifications
2
Replacement Parts List
2
Pump & Pipe
Installation Instructions
Installation Options
3
Direct Discharge to Outside
4
Connection to Existing Discharge
5
Direct Discharge for Narrow Sumps
6
Connection to Existing Discharge for
Narrow Sumps
7
Battery Instructions
Preparation of the Battery
8,9
Control Unit Connections
Positioning the Float Switch
9
Connecting the Pump
9
Installing the Battery Fluid Sensor 10
Connecting the Battery
10
Connecting the Charger
10
Understanding the Warning
Lights and Alarms
Silencing the Alarm
During an Emergency
11
Battery Alarm
11
Cleaning Battery Terminals
11,12
Replacing the Battery
12
Fuse Alarm
13
Water Alarm
13
Pump Alarm
14
Replacing the Pump
14
Power Alarm
15
Charging
15
System Operating
15
Testing the System
Test-Reset-Silence Button
15
Testing the Float Switch
15
Using the Remote Notification
Remote Terminal
15
Remote Alarm
15
USB Data Port
16
Connect Modules
16
Maintenance Check List
16
Parts & Service Information
Technical Support
16
Troubleshooting Guide
17
Warranty
18
Other Products
19
This manual is for the systems that
have the BWSP-A backup controller,
which can accommodate maintenance
or maintenance free batteries.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Important Safety Warnings & Instructions SAVE THESE INSTRUCTIONS. This manual contains important SAFETY WARNINGS andOPERATING INSTRUCTIONS for the BasementWatchdog Special battery backup sump pumpsystem. You will need to refer to it beforeattempting any installation or maintenance. ALWAYS keep t...
Introduction The Basement Watchdog Special backup sumppump system is battery-operated. It is designed asan emergency backup system to support your mainAC sump pump, and it will automatically beginpumping any time the float switch is activated byrising water. Should any malfunction or emergencyoccur ...
Pump & Pipe Installation Instructions There are two basic methods that can be used toinstall the pump, a direct discharge to theoutside of the building, or a connection to anexisting discharge pipe. The same two optionsapply in very narrow sump pits where the backuppump must be mounted above the...
