Axor 10100801 - Manual
Axor 10100801 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – HANSGROHE PRODUCT SERVICE; Spare parts
- Page 3 – WHO IS COVERED BY THE WARRANTY
- Page 4 – or exclusion may not apply to you.; Cleaning Recommendation for Hansgrohe Products; covered under the Hansgrohe warranty.
09/2005
HANSGROHE PRODUCT SERVICE
SINGEL LEVER LAV MIXER
Ref. No.: 10100801
Installation
Starck
Installation (1)
Attention:
The mixer must connected to angle valves with integrated filter.
The mixer can not used together with a continuous flow water heater.
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in position on the basin.
3. Slip the slide washer, washer and collar nut over the threaded base and tighten the
collar nut by hand.
4. Tighten screws.
5. Connect the connecting hose to the angle valves; cold right - hot left.
6. Install the battery (please see Exchange battery)
Large differences in pressure between the hot and cold water supply should be balanced.
Operation
The water temperature is adjusted by the adjusting lever.
swivel forward = hot water,
swivel backward = cold water.
Adjustment (2)
This mixer have following feature:
background fade-out with integrated range adjustment, that means the mixer is automati-
cally adjusted on to the local conditions (washbasin, brightness, reflection) by the sensory
mechanism.
Exchange battery (3)
The mixer operates with a 6 V Lithium-Battery
(DL 223A). The working life of the battery is 2 years by extremely operation. Over night
the current consumption is reduced by a economy mode.
Push a small hexagon socket screw key into the hole at the backside of the mixer and pull
the cover upwards. Take care to the O-ring.
Attention:
After installing the battery, the mixer may not activated for 1 min because of
adjusting itself.
Cleaning washbasin
(4)
Cover the infrared sensor by hand, after 4 s remove slowly the hand , the automatic
water stop is activated for 1 min.
adjusting lever
infrared sensor with
light emitting diode
(LED)
cover
1
2
3
7 7/8"
+3/8"
cold
hot
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
09/2005 HANSGROHE PRODUCT SERVICE Spare parts LED-Display LED off: normal operation LED light: replacing battery LED flashes every 2 s: water stop is activated Technical data Operation pressure: max. 117 psi Recommended pressure: 14.7 - 72.5 psi Test pressure: 232 psi Hot water temperature: max. 176...
09/2005 HANSGROHE PRODUCT SERVICE Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. („Hansgrohe“). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1...
09/2005 HANSGROHE PRODUCT SERVICE EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATIO...
