Audiovox GMRS100 - Manual

Audiovox GMRS100

Audiovox GMRS100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
Page: / 24

Table of Contents:

  • Page 2 – PLACE THE RUBBER COVERS ON JACKS WHEN NOT IN USE.; CAUTION
  • Page 3 – Battery Charging Contacts
  • Page 4 – Model GMRS100 DISPLAY; Roger Beep Tone Indicator: This icon appears when the Roger Beep; tone is on, and disapppears when the tone is not in use.; Transmit Indicator: Icon appears when the unit is in the transmit; is set to desired output power.; Battery Level Indicator: Icon appears flashing to indicate low; battery charge level.; LO
  • Page 5 – Boom Microphone/Headset; Powering the transceiver:; DO NOT PLACE GMRS100 TRANSCEIVERS IN THE CHARGING
  • Page 6 – Installing the batteries:; Then lift cover at
  • Page 8 – GMRS100 OPERATIONAL MODES
  • Page 9 – volume. The display will indicate the current volume level (V; followed by; Do not transmit if you hear conversation.; ) will appear in the upper left corner of the
  • Page 11 – Operating Modes and Features; - Press and hold the Power On/Off button for 2 seconds to turn on; on the display while the button is pressed.; Channel Selection
  • Page 13 – Transmit Power Selection Mode (GMRS Channels Only); To access the transmitter power selection function:; Roger Beep Tone
  • Page 14 – To enable and disable the Roger Beep tone:; VOX Selection Mode; - From GMRS/FRS standby mode, press and hold the MODE button; for 3 seconds, or until the VOX icon appears on the display.; - To terminate VOX operation, press and hold the MODE button for at; Call Ringer Selection Mode; - From GMRS/FRS standby mode, press the PTT button twice in quick
  • Page 15 – Channel Scan Operation; To enable the channel scan mode:; Button SCAN will appear on the LCD display.; order to find an active main channel.
  • Page 16 – Battery Alert; When the battery icon (; NOTES FOR GOOD COMMUNICATION; • Do not operate the transceiver unless you are licensed to do so.
  • Page 17 – • Do not attempt to modify or in any way increase the output of this; atmospheres as sparks in such areas could result in an explosion.; • Do not place your radio in front of a vehicle’s air-bag. If the air-bag
  • Page 18 – Troubleshooting; P r o b l e m
  • Page 20 – NOTE: Channels 1 through 7 are shared with FRS radios.; Main Channel Frequencies:
  • Page 21 – Continuous Tone Coded Squelch System Tone; CTCSS; oF
  • Page 22 – 0 DAY / 12 MONTH LIMITED WARRANTY
  • Page 23 – THIS PAGE LEFT BLANK INTENTIONALLY
  • Page 24 – P rinte d in C hina
Loading the manual

128-XXXX

1 of 24

General Mobile Radio Service (GMRS)

Model: GMRS100

Released:

3 -1 0 -0 3

Owner's Manual

MODE

LO

HI

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - PLACE THE RUBBER COVERS ON JACKS WHEN NOT IN USE.; CAUTION

128-XXXX 2 of 24 NEVER ATTEMPT TO CHARGE ALKALINE OR DRY CELL BATTERIES, ASBATTERIES MAY BURST CAUSING PERSONAL INJURY AND DAMAGETO THE PRODUCT. WHEN RECHARGING NICKEL METAL HYDRIDE (Ni-MH) BATTERIES WITH THE SUPPLIED AUDIOVOX CHARGER AND WALLADAPTER, USE ONLY AUDIOVOX-APPROVED RECHARGEABLE BATTER-I...

Page 3 - Battery Charging Contacts

128-XXXX 3 of 24 3 1. Battery Cover2. Monitor (M) Button3. Detachable Carry Clip4. Push-To-Talk (PTT) and Func- tion Confirmation Button 5. Antenna6. External Speaker (SP)/ Microphone (MIC)/CHG Jack 7. Built-in Speaker Model GMRS100 (FCC License Required) 8. Liquid Crystal Display (LCD)9. Built-in M...

Page 4 - Model GMRS100 DISPLAY; Roger Beep Tone Indicator: This icon appears when the Roger Beep; tone is on, and disapppears when the tone is not in use.; Transmit Indicator: Icon appears when the unit is in the transmit; is set to desired output power.; Battery Level Indicator: Icon appears flashing to indicate low; battery charge level.; LO

128-XXXX 4 of 24 4 Model GMRS100 DISPLAY 1. Roger Beep Tone Indicator: This icon appears when the Roger Beep tone is on, and disapppears when the tone is not in use. 2. Transmit Indicator: Icon appears when the unit is in the transmit mode (PTT button activated or VOX mode active). 3. Busy Indicator...

Other Audiovox Models