Attwood 6375D - Manual
Attwood 6375D – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Figure 1
3.
Attach power wires to suitable switch,
1
-amp fuse, and
power source.
4.
Apply marine sealant around base and wire hole. Use #8 screws
to fasten light to deck.
MAINTENANCE
Replace bulb with #90, 7.5 watt type (Attwood #9232):
1.
Remove light from deck. Remove cover retension screws, base
and lens. Replace bulb. (See Figure
1.)
2.
Reassemble and install light.
© 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
REQUIRED FOR INSTALLATION
•
Drill with
¹⁄₈
" (3mm) and
¹⁄₄
" (6mm) dia. bits.
•
Screwdriver and two #8 x
³⁄₄
" (19mm) stainless screws.
•
Suitable marine sealant.
•
2-conductor, 14-gauge wire for connection to switch and
power supply.
•
Fuse holder with 1.0-amp (maximum) fuse.
•
ON/OFF switch (Attwood Numbers: 7563, 7589).
LOCATION
1.
Position light on horizontal (
±
5
°
) deck surface at forward tip of
the bow on boat centerline.
2.
Ensure that there are no front or side obstructions within arc of
visibility (112.5
°
each side).
MOUNTING INSTRUCTIONS
1.
Align center of light with boat centerline. Use base to mark
mounting screw pilot holes. (See Figure
1.)
2.
Drill two
¹⁄₈
" (3mm) pilot holes. Beneath base, drill a
¹⁄₄
" (6mm)
diameter hole for power wires.
Co
v
e
r
•
•
Mounting
Scre
ws
(Not Supplied)
Co
v
er Retention
Scre
ws
•
Lens
•
Bulb
•
3
®
Zamak 1-Mile Combination
Sidelight
6375D
Installation Instructions
Attwood marine hardware, navigational lighting, bilge pumps, and other
marine accessories are specified more than any other brand by America
’s
best-known boat manufacturers as original equipment. Look to Attwood
for quality replacement parts and marine accessories.
SAVE THESE INSTRUCTIONS
Form Number 69305 Rev. B
03-10
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
