ATD ATD-8699 - Manual
ATD ATD-8699 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Assembly; Clean all dirt and oil from the yoke area.; Ball Joint Removal and Installation; the control arm from the vehicle.; be cut before attempting to remove the ball joint.
- Page 3 – Installation; joint is firmly seated.
- Page 4 – APPLICATION CHART
- Page 5 – JEEP
- Page 6 – Vehicle; FORD; I R
- Page 7 – RI; HONDA
ATD-8699
MASTER BALL JOINT SET
WARNING: TO HELP PREVENT PERSONAL INJURY
z
Always wear ANSI approved goggles when using this product. Normal use of this product is likely to expose the
user to dust and/or microscopic particles containing chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm. Always wear appropriates safety equipment and clothing when using this
product.
z
Study, understand, and follow all instructions provided with this product.
z
Before repairing vehicle, block the wheels to prevent the vehicle from moving.
z
Check the final alignment of the C-frame press and all tooling with components before exerting pressure to remove
or replace a ball joint.
OPERATING INSTRUCTIONS
Brake Anchor Pin Removal and Installation
1. Remove all lock ring retainers from the brake anchor pins.
2. Position the C-frame press over the brake spider as shown in Figure 1.
3. Tighten the forcing screw until the anchor pin is removed.
U-Joint Assembly and Disassembly
The basic C-frame press is used to service the U-Joints on most cars and light trucks.
The U-Joints can be serviced either on or off the vehicle.
Disassembly
1. Remove any external and/or internal lock rings.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2. Position the C-frame press around the drive shaft yoke, and tighten the forcing screw until the first bearing is removed. 3. Reposition the C-frame and remove the second bearing. Assembly 1. Clean all dirt and oil from the yoke area. 2. Align the replacement bearing and C-frame press as straight ...
Installation 1. Clean the control arm and coat the I.D. with a suitable lubricant. 2. Insert the replacement ball joint as straight as possible into the vehicle control arm. 3. Assemble the ball joint press component as shown in Figure 4. Position the receiving tube, and tighten the forcing screw. C...
ATD-8699 APPLICATION CHART R=Remove I=Install ATD-8699 Ball Joint Upper/ Lower Vehicle PR T8 69 7 -1 3 PR T8 69 7 -1 4 PR T8 69 7 -0 3 PR T8 69 7 -0 6 PR T8 69 7 -1 2 PR T8 69 7 -0 7 PR T8 69 7 -1 0 PR T8 69 7 -0 9 PR T8 69 7 -0 2 PR T 869 7-1 1 PR T8 69 7 -0 4 PR T8 69 7 -0 8 PR T8 69 7 -0 5 PR T8 ...
