ATD ATD-31167 - Manual
ATD ATD-31167 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – nstalling Hose Reel; mounting positions require different types of hardware.; ” chart below and; Typical Mounting Positions
- Page 4 – To lock; ADJUSTING RECOIL TENSION; While firmly holding onto edge of reel drum,
- Page 5 – REPLACING HOSE; Pull out entire length of hose and lock reel.; Make sure reel is securely locked in place.; hose in identical positions.
ATD-31167
1/2" X 50' RETRACTABLE
AIR HOSE REEL
Instruction Manual
Specifications
•
Spring driven, automatic rewind, with locking ratchet mechanism (eight locking positions per
revolution).
•
Brass connectors on hose and reel.
•
50 Feet of ½” rubber Hose
•
Incoming Air Connection: 1/2” NPT swivel
•
Hose Connections: Male 1/2” NPT
•
Maximum Pressure: 300PSI
•
Maximum
Air
Flow:
35CFM
Read and understand entire manual before assembling or using hose reel.
Failure to follow
instructions or warnings could result in personal injury and/or property damage.
Safety Rules
DO NOT EXCEED 300 PSI
incoming air pressure (from compressor)
Wear impact-resistant eye protection that meets
ANSI Spec.Z87.1 in work area at all times.
Do not release hose when rewinding. Hold hose end and allow hose to rewind slowly.
Never allow children to use hose reel. Keep children clear of work area at all times.
Warning
Do not over tighten reel. This may permanently damage the spring in the winding mechanism. Ideally, the
reel should be adjusted to wind up only as far as the desired height needed to reach the hose stop.
Exercise care when handling the hose reel during normal operation. This hose reel has a rotating spool
powered by springs under tension.
Mounting hardware and fasteners should be installed to maintain tightness under vibration and checked
periodically to ensure tightness.
Overhead installation mountings should be such that the reel is not supported by bolts in tension. A safety
chain or cable is strongly recommended to minimize damage and/or possible injury in the event of
mounting failure.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
I nstalling Hose Reel Note: Due to the infinite ways one would mount this reel, the mounting hardware is not included and must be purchased separately. Decide first where reel will be mounted before purchasing hardware. Different mounting positions require different types of hardware. Reel can be mo...
ADJUSTING THE HOSE BALL STOP The hose ball stop determines the length of hose that remains outside of reel. To adjust, pull hose out past desired position of hose ball stop and latch reel. Loosen both bolts and move ball stop to proper position. Tighten bolts. Operating Hose Reel 1. Slowly pull hose...
REPLACING HOSE 1. Secure and stabilize reel. In most cases, hose can be replaced with reel still mounted. 2. Disconnect incoming air supply. 3. Pull out entire length of hose and lock reel. Make sure reel is securely locked in place. 4. Unscrew hose clamps that secure hose to drum. Disconnect inlet-...
