ATD 7563 - Manual
ATD 7563 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – General Safety Rules; WARNING
- Page 3 – Operating Instructions; Removal; Important: Keep the actuating screw well lubricated.
- Page 4 – Installation
‐
1
‐
ATD-7563
UNIVERSAL STRUT SPRING COMPRESSOR
Operation and Safety Instructions
CAUTION:
Carefully read through this entire operator’s manual before using your tool.
Pay close attention to the Rules for safety operation, warnings, and cautions.
If you use your tool properly and only for what it is intended for, you will enjoy
years of safe, reliable service
.
SAVE THIS MANUAL FOR FUTURE REFERENCE
Section Page
•
General safety rules -------------------------------------------------- 2
•
Operating Instructions ----------------------------------------------- 3 - 4
•
Replacement parts----------------------------------------------------- 5
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
‐ 2 ‐ General Safety Rules WARNING : When using this tool, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment. Read all warnings and instructions before using this tool. • Always wear ANSI approved safety goggles and ear protection whe...
‐ 3 ‐ Operating Instructions Removal Important: Keep the actuating screw well lubricated. 1. Refer to the vehicle service manual, and follow the manufacturer's recommended procedure to remove the Macpherson strut assembly from the vehicle. 2. Once removed, clamp the strut assembly in a vise. 3. M...
‐ 4 ‐ Spring Replacement 1. Place the tool and spring assembly on a workbench. Using a ratchet or impact wrench, SLOWLY AND CAREFULLY decompress the spring. 2. Remove the old spring from the strut tool. Install the new spring in the tool so that a maximum number of coils can be grabbed by the too...
