Asus EK-FB ASUS Max4 Extreme - Acetal- Manual

All disclosures, notices and warranty conditions are being written on the back of the box.

Released on 18

h

of May, 2011.

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at

www.ekwaterblocks.com

for updates.

Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box or our home page.

The barb hose fittings require only a small amount of force to screw them in; otherwise the high flow fittings might break. These fittings do not need to be tightened with much force because the

liquid seal is made using o-rings. The use of an algaecide and corrosion inhibitors is always recommended for any liquid cooling system.

STEP 1: GENERAL INFORMATION

Sample photo of ASUS Maximus IV Extreme PCB design

STEP 2: PREPARING YOUR MOTHERBOARD

1. REMOVING STOCK COOLER.

Remove all 8 screws holding the original heat-

pipe cooler / backplate assembly to the motherboard’s circuit board.

2. CLEANING THE PCB.

Carefully detach the original stock cooler after removing

all

screws securing it to the board. Wipe off the remains (by using non–abrasive cloth or qtip,
as shown on sample photo) of the original thermal compound until the components and

circuit board are completely clean. EKWB does not recommend using any liquids for
removing paste.

3. APPLYING THERMAL COMPOUND

Apply thermal compound: lightly coat the NF200 (NB) and P67 PCH (SB chips with

for example Arctic Cooling MX-2 ™ or MX-4 ™ thermal grease. EKWB recommends
to apply thermal grease in cross form for best performance (see sample picture).

4. CUTTING THERMAL PADS.

Two (2) 90x15x1mm thermal pads are enclosed with your

EK-FB Max4 Extreme water block. You will have to cut the thermal pad in order to cover all

marked surfaces surface. (WARNING: DIMENSIONS ON PICTURES BELLOW ARE SCALED!)

5. PLACING THERMAL PADS ON MOTHERBOARD.

Place thermal pads you cut on PCB as shown on picture bellow.

(PLEASE REMOVE FOIL OF THERMAL PADS ON

BOTH SIDES PRIOR TO INSTALLATION.)

P67 Southbridge

NF200

bridge chip

CPU socket

Installation and mounting manual for

EK-FB ASUS Max4 Extreme

water block:

Mosfets

Apply thermal grease on
Northbridge (NF200) and
Southbridge (P67).

Place 1mm thermal pads here and make
sure all chips are covered.