Asus DSL-X11- User Manual

Asus DSL-X11

Asus DSL-X11– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
Page: / 77

Table of Contents:

  • Page 3 – Contents
  • Page 4 – Introduction; ADSL Standard Supports
  • Page 5 – LEDs
  • Page 6 – Rear Panel
  • Page 7 – Power switch, power on or power off the device.
  • Page 8 – Hardware Installation; Connection 1
  • Page 9 – Connection 2
  • Page 10 – Web Configuration Management; Logging In to the Router
  • Page 11 – and; The default user name and password of the common user are; user; and
  • Page 12 – LAN IP Address: The management IP address; DSL Router Device Information; Choose; Device Info; , the following page appears. Choose items to view the
  • Page 13 – Click; Advanced Setup; and the; Advanced system setup; Advance Setup; , if the modem is already configured, the
  • Page 18 – If this function is enabled, the WAN IP address obtained by; Use Static IP Address:; If this function is disabled, the modem obtains an IP; Retry PPP password on authentication error; The PPP Debug Mode enables connection; Next; and the following
  • Page 19 – and the following page appears.
  • Page 20 – To save the settings, click; Save
  • Page 27 – Encapsulation Mode; is set to
  • Page 30 – and the following page appears. This page shows all the
  • Page 37 – and the following page appears. In this page, you can modify the
  • Page 40 – Adjust the subnet mask if necessary.; Internet Group Management Protocol
  • Page 43 – Adding Virtual Servers; Step 1; To set up virtual servers for a service, choose
  • Page 44 – Step 2; Select a service or enter a custom server.; Step 3; Set; Server IP Address
  • Page 46 – Removing Port Triggering
  • Page 47 – Only one PC per public IP address can be set up as an Exposed Host.; Adding a DMZ Host; To set up a PC as a DMZ host, choose; Removing a DMZ Host
  • Page 48 – Clear the DMZ Host Address.; Security; and the following page appears. By default, the
  • Page 52 – Add; and the page for defining the IP filtering rule appears.; Filter Name; : Enter the name of incoming filter rule.; Protocol
  • Page 53 – : You can select WAN interfaces and PVC.; Request; Block all IP traffic from other PCS.; Configuration; The detailed configuration steps are as follows:
  • Page 54 – Content Filtering > Parental Control
  • Page 55 – button to display the following page.; to save and apply the settings.
  • Page 57 – Queue Configuration Status; selected network interface to the queue.; Queue Precedence; : Select an integer value for queue precedence. After you
  • Page 58 – QoS Classification; and the following page appears. In this page, you can
  • Page 59 – : Enable or disable this traffic class rule.; Assign Classification Queue
  • Page 60 – checkbox is selected, this; Automatic Assigned Default Gateway; from unselected
  • Page 63 – Enable Automatic Assigned DNS; check box is selected, this router
  • Page 66 – Figure 7 DSL settings; Advanced Settings
  • Page 67 – Diagnostics; to show the interface.; Rerun Diagnostic Tests; at the; Help; and follow the troubleshooting procedures.
  • Page 69 – Settings – Restore Default; Restore Default Settings; to restore DSL router settings to the factory
  • Page 71 – The log and display of the system events are above the set; Management; and the following page appears. This
  • Page 72 – Access Control – Services
  • Page 73 – The WAN information is not displayed in the bridge mode.; Access Control – IP Addresses; Access Control; to show the following interface.; Access Control – Passwords
  • Page 74 – Do not turn off your router during firmware updates. When
Loading the manual

DSL-X11

One Port ADSL Modem Router

User Manual

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - Contents

DSL-X11 User Manual i Contents 1 Introduction ........................................................................................................ 1 1.1 Features ................................................................................................ 1 1.2 ADSL Standard Supports............

Page 4 - Introduction; ADSL Standard Supports

DSL-X11 User Manual 1 1 Introduction The device is a well-designed high-speed ADSL modem/router. 1.1 Features Full rate ADSL router, support Router/ Bridge Provides 24Mbps downstream and 1Mbps upstream Maximum transmission range: 5.4 Kilometers One Ethernet port, 10/100 Mbps Auto-MDI/MDIX Friendly G...

Page 5 - LEDs

DSL-X11 User Manual 2 1.4 System Requirements Recommended system requirements are: Pentium 300 MHZ or above Memory: 128 MB or above 10 M Base-T Ethernet or above Win9X, Win2000, WinXP, WinMe, WinNT Ethernet Network Card Please collect the following information from your ADSL service provider. This i...

Other Asus Models