Ariston AW122 - Manual

5 Symbols Key Stop/Reset Spin Cycles (10 - 13 min.) Easy Iron (Anticrease Stop) Drain Only (No Spin) Fabric Softener Only Cycle Rinse Cycles (25 min.) Preset washing programs Program Clothing Type Description High Spin Recommendation COTTON 1 Sanitary Colorfast Items 120 minutesHeating element is us...

6 Washing Options Option What it does... How to set it... Note KNOBS TEMPERATURE Changes the preset wash water temperature of the selected program Rotate TEMPERATURE knob to the desired wash temperature Rinse water is always COLD • SPIN SPEED Changes/excludes the preset spin cycle of the selected pr...

7 HE Laundry Powder For best results, use HE (High Efficiency) detergent. HE laundry detergents dissolve more quickly in less water and won’t overfoam in front loading washers. About Using Bleach (Compartment 4) Bleach can only be used when HOT is selected on the TEMPERATURE knob If bleaching is neces...

8 When you should switch off the electricity and turn off the water faucets Unplug the washer and turn off the water faucets when not using it, when cleaning it and during maintenance activities. After washing is complete, always Turn off the water faucets to relieve pressure on the inlet hoses. Wipe th...

9 Maintenance and Care A) To winterize your washer-dryer With machine power OFF, pour ½ quart of RV- type antifreeze into washer drum Close door. Advance Program Dial to a ‘Spin’ position Press ON-OFF Button (IN). Wait 1-2 minutes Press ON-OFF Button (OUT ). Unplug washer-dryer from electrical outle...

10 Before you call our Customer Care Department, go through the following troubleshooting suggestions Troubleshooting Problem: Possible Causes / Solutions: The washer won’t start. The plug is not plugged into the socket, or not making contact. There has been a power outage. The fuse has blown. The d...

11 Spare Parts This washer is a complex machine. Repairing it yourself or having a non-authorized person try to repair it could cause harm to one or more persons and to the machine, and could invalidate the warranty. Always call Westland Sales first if you experience any problems with this machine. C...

12 Recessed, closet and alcove installation (Instructions) The machine may be installed in a recessed area, closet or alcove. The installation spacing is in inches and is the minimum acceptable. Additional spacing should be considered for easy installation, servicing and compliance with local codes ...

13 Tools and Par ts Assemble the necessary tools and supplies before beginning the washer installation. The parts supplied are in the drum. Tools needed for installation: 10mm Wrench, Screwdriver Parts Supplied U-Clamp Transit Bolt Hole Plugs (4) If You Have You’ll Need to Buy No access to Hot/Cold ...

14 Drain System Requirements The washer-dryer can be installed using the standpipe drain system, floor drain system or the sink drain system. To prevent siphoning, the outlet end of the drain hose (provided with unit) MUST be at least 20” (50.8 cm) above the base of the machine. Not more than 6” (15....

15 Elec trical Requirements • A 120-volt, 60-Hz., AC-only, 15 or 20-amp, fused electrical supply is required. Time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided. • This washer-dryer is equipped with a 6’ power supply c...

16 Remove the Transit Screws/Spacers First, position the washer so that the rear of the unit is within approximately 3 feet (90 cm) of the final location. There are 4 bolts in the rear panel of the washer that sup- port the suspension system during transportation. 1. Using a wrench, loosen each of th...

18 Installation Instructions ELECTRICAL SHOCK HAZARD Plug washer-dryer into a grounded 3 prong outlet. Do not remove ground prong. Do not use adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. WARNING ! Complete the Installatio...