Ariens 920022 - Manual
Ariens 920022 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Assemble Handlebar
- Page 3 – Install Trigger Cable Assembly
- Page 4 – Install Discharge Chute
- Page 5 – Discharge Chute Crank
- Page 7 – Step Five: Install Remote
- Page 8 – Check Function of Dual Handle Interlock
- Page 9 – Check Track Tension
- Page 10 – Adjust Skid Shoes
- Page 11 – Check Auger Gearcase Oil
- Page 12 – Check Engine Crankcase Oil
- Page 13 – Fill Engine Fuel Tank
- Page 15 – Choke
- Page 16 – Rocker Switch
- Page 17 – Fuel Shut Off Valve
- Page 18 – Key
- Page 19 – Prime
- Page 22 – Note
- Page 23 – Warm up
- Page 24 – Step Thirteen: Stopping the Engine
- Page 25 – Additional Resources; Refer to Owners Manual and Engine Manual
Quick Start Guide
Compact 24 LET (920022 s/n 000101 & up)
•
Step 1: Assemble Handlebar
•
Step 2: Install Trigger Cable Assembly
•
Step 3: Install Discharge Chute
•
Step 4: Install Discharge Chute Crank
•
Step 5: Install Remote Deflector Cable
•
Step 6: Check Function of Dual Handle Interlock
•
Step 7: Check Track Tension
•
Step 8: Adjust Skid Shoes
•
Step 9: Check Auger Gearcase Oil
•
Step 10: Check Engine Crankcase Oil
•
Step 11: Fill Engine Fuel Tank
•
Step 12: Starting the Engine
•
Step 13: Stopping the Engine
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
IMPORTANT:
READ OPERATOR’S MANUAL AND ENGINE MANUAL
THOROUGHLY AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES
BEFORE OPERATING.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Step One: Assemble Handlebar 1. Remove the lower and loosen the upper hardware on the handlebar assembly. 2. Loosen the hardware on the shift rod. 3. Put the speed selector lever in the sixth forward position. 4. Rotate the handlebar into operating position. NOTE: Be careful not to damage cable spri...
Step Two: Install Trigger Cable Assembly NOTICE: Trigger cable assembly comes attached to the Sno-Thro unit. 1. Attach remote trigger cable assembly to upper handlebar assembly using one ¼” x 1- ½” oval head machine screw and one ¼” locking washer.
Step Three: Install Discharge Chute 1. Grease underside of discharge chute ring (if not already greased). 2. Remove mounting hardware from auger housing 3. Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed above. NOTE: Leave discharge chute pedes...
