Page 3 - Initial Start-Up Instructions
❏ ❏ Read all assembly, operating, and safety instructions. ❏ ❏ Complete and return the warranty card to register your log split-ter. ❏ ❏ Write the serial number and date-of-purchase in this manual. ❏ ❏ Assemble the log splitter. ❏ ❏ Make sure the oil filter is properly installed. (See “AssemblyProce...
Page 4 - Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Personal Protection . . . . . . . . . . . ...
Page 5 - CALIFORNIA PROPOSITION 65; WARNING
815-672-8596 3 Iron & Oak Accidents can often be avoided by being alert and recognizing potentially haz-ardous situations. Any individuals operating, maintaining, or repairing prod-ucts manufactured by Iron & Oak Commercial Products should have the nec-essary training, skills, and tools requ...
Page 6 - Introduction
The commercial BHVH2209, BHVH2209FC, and BHVH2609 Vertical/Horizontal LogSplitters are designed for tough applications in both vertical and horizontal positions.With 22 tons (model BHVH2209) or 26 tons (model BHVH2609) of splitting force, a 12second cycle time, and a 6 HP or an 9 HP engine either mo...
Page 7 - Safety
The following is a list of safety rules you must follow in order to use your log split-ter safely. Personal Protection ✔ To avoid personal injury or death, carefully read and understand all instruc-tions pertaining to the log splitter including the engine manufacturer’s oper-ating and maintenance in...
Page 8 - Operating Safety
Operating Safety ✔ ALLOW ONLY ONE (1) PERSON TO LOAD AND OPERATE THE LOG SPLIT-TER. ✔ Allow only adults to operate the log splitter. No one under the age of 18 shouldbe allowed to operate the log splitter. ✔ Always keep bystanders, including children and pets, at least twenty-five (25)feet away from...
Page 9 - Log Splitting Safety; Maintenance and Repair
✘ Only use your hand to operate the control lever. NEVER use your foot, knee, arope, or any other extension device. Log Splitting Safety ✔ Always keep your fingers away from any cracks that open in the log during thesplitting operation. ✔ ALWAYS make sure that both ends of the log you are splitting ...
Page 10 - Towing; Refueling
Towing ✔ ALWAYS check before towing to make certain your log splitter is correctly andsecurely attached to the towing vehicle. Be sure that the ball hitch you areusing is the proper size for the hitch coupler on the log splitter (see “Specifi-cation” section). Be sure the safety chains are properly ...
Page 11 - Preventing Fires; Important Notice
✔ Always store gasoline in an approved, tightly sealed container. Store the con-tainer in a cool, dry place. Do not store the container in a house or near anyheating appliance. ✘ Do not smoke or have open flames when refueling the engine. Donot spill fuel. If fuel should spill, quickly wipe up the s...
Page 12 - Qty; Assembly Instructions
Required Tools • 10” crescent wrench • Flat head screwdriver • Two 1/2’’ open end wrenches • Two 3/4” open end wrenches • Funnel • Pliers • Band Cutters Shipping List The following chart contains the list of parts that should be shipped as part of theBHVH2209, BHVH2209FC, or BHVH2609 Log Splitter. I...
Page 13 - Unpacking the Crate
Unpacking the Crate 1 . Cut the metal banding and remove the top, sides, ends, and protective plastic cover-ing of the packing crate. Do not removethe base unit or the rail assembly from thebottom pallet at this time. 2 . Carefully check the larger components on the shipping pallet for damage. If th...
Page 14 - Assembly Procedure; CAUTION
Assembly Procedure Some components are very heavyand can be damaged if mishan-dled. Also, to help prevent per-sonal injury, it is strongly recom-mended that two (2) people worktogether to uncrate and assemblethe log splitter. 1 . Remove and read all instructions andsafety recommendations beforeassem...
Page 15 - NOTE
Make sure the rail assembly is standing ona flat, level area. Have a helper steady therail to prevent it from tipping over. The railassembly weighs approximately 300pounds and will cause bodily injury if itfalls on someone. 3 . Carefully stand the rail assembly in an upright, vertical position. 4 . ...
Page 18 - Follow the “Start-Up Procedure”
14 . Coat the threads of the fitting with a hydraulic pipe sealant and attach thehigh-pressure hose from the bottomvalve fitting to the pump, as shown.Securely tighten the hose fitting. 15 . Remove the oil filter from the plastic cover and apply a thin coat of oil to therubber seal. Screw the filter...
Page 23 - safe operating area; Operation
Do not attempt to operate the log splitter without fully understandingall our instructions, safety precautions, and/or warnings. If any doubtor question arises about the correct or safe method of performing any-thing found in this or other Iron & Oak Products’ manuals, contact your Iron & Oa...
Page 24 - Operation – Horizontal Position
3 . Start the engine using the instructions from the engine manual. If the log splitter hasnot been running (cold engine), warm upthe engine and hydraulic system by run-ning the engine at half throttle for 3 to 4minutes, then advance the engine throttlecontrol to maximum speed. Operation – Horizonta...
Page 25 - could cause personal injury or even death.
b . Only using your hand, push the control lever forward (towards the log). If thelog moves, before it is contacted bythe splitting wedge, release the controllever and then reposition the log.Operate the log splitter only whenstanding in the safe operating area , shown in the picture. Make sure you ...
Page 27 - Operation – Vertical Position
Operation – Vertical Position Before loading and operating the log splitter,always wear protective gear, such as safetygoggles, face shield, hearing protection, tight-fitting gloves without draw strings or loose cuffs, and steel-toed shoes. 5 . Use the following photos for the correct and incorrect ...
Page 30 - Inspection and Maintenance
General Maintenance Check (before operating) The hydraulic system (hoses, cylinder, and pump) should be carefully inspected beforeeach use. Also, inspect the mechanical parts at the same time. Make sure all clamps,nuts, bolts, fittings, etc. are properly installed and tightened. Do not check for lea...
Page 31 - Hydraulic Oil Change
Hydraulic Oil Change Iron & Oak Commercial Products recommends an oil and filter change every 100 hoursof operation. Refer to the “Specifications” section, in this manual, for the type and quan-tity of oil. Important Notice Never run the log splitter unless the hydraulic oil tank is full. 1 . Dr...
Page 33 - Specifications
Mechanical Specifications (Model BHVH2209) Beam . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 inch heavy-duty, formed steel beamWedge . . . . . . . . . . . . . . . . . . . . 6” high carbon steel, compound angle (replaceable)Beam & wedge (DURO-GLIDE) . . . . . . . Formed ste...
Page 35 - Detent Adjustment Procedure; Troubleshooting
The following section will detail procedures for checking your log splitter, should youencounter a malfunction. We recommend that you do not attempt to make repairs to thelog splitter. In the long run, it is better to take your log splitter to a servicing lawn and gar-den dealer for repairs. Problem...
Page 36 - Decals
Make sure all decals are attached to the log splitter and/or engine andare legible at all times. N I NG AR WARNING Iron & Oak 34 815-672-8596 (3) Decals
Page 38 - Parts
Iron & Oak 36 815-672-8596 Item Part No. Description Qty 1 BR021249-09 W eldment, Base T ank 1 2 BR001209 Bolt, 5/16-18 x 3/4” long 4 3 BR007016 Fender 2 4 BR001325 Locknut, 5/16-18 4 5 BR008301B Seal, Inside 2 6 BR008301A Bearing, T apered Roller 4 7 BR008317 Hub, S tudded 2 8 BR008303 T ire, 4...
Page 40 - Standard Rail; not
Iron & Oak 38 815-672-8596 Standard Rail Item Part No. Description Qty 1 BR021264-08 W eldment, Rail 1 2 BR001208 Bolt, 1/2-13 x 1-1/2” long 2 3 BR021393-02 W eldment, Rail Rest 1 4 BR001404 Lockwasher , 1/2” 8 5 BR001304 Nut, /2-13 8 6 BR021396 Pin, Plunger 1 7 BR008151 S pring 1 8 BR001090 Pin...
Page 46 - Warranty
For one year from the date of purchase, Iron & Oak Commercial Products, Inc. willreplace for the original purchaser, or repair free of charge, all parts of the Iron & OakCommercial Products hydraulic log splitter, returned to our factory PREPAID and foundupon inspection by us to be faulty, d...
Page 47 - activate your Iron &; Iron & Oak Commercial Product; Iron & Oak Log Splitter W; SERIAL; ith DURO-GLIDE Feature; CITY
Import ant W arranty Information T o activate your Iron & Oak log splitter warranty , please fill out the information in the form below , clip out the form on the dotted line, insert into an envelope, and mail to: Iron & Oak Commercial Product s, Inc P .O. Box 577, S treator , IL 61364-0577 ...
Page 49 - Optional Attachments
Log Cradle (Part No. BR021180) ✔ Holds log in place on top of rail for faster splitting. ✔ Catches split logs - no more stooping to pick up the split pieces. ✔ Each shelf is infinitely adjustable up to 45 degrees to accommodate various sizes oflogs. ✔ Mounts easily to rail - all hardware included, r...
