AprilAire 8336 - Manual
AprilAire 8336 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Features; Replacing Existing Thermostat; Table 1; O or R
- Page 3 – Installing the Model 8336 Thermostat; For new installations, mount thermostat on inside wall, 4-5 feet; Figure 1
- Page 4 – plastic anchors do not require a drilled hole for drywall.; Align base with plastic anchors and feed wires; Mounting Holes
- Page 5 – figure 4; C Switch
- Page 6 – Differential
- Page 7 – To Test Thermostat
- Page 8 – Symptom Remedy
- Page 9 – If problems with thermostat cannot be solved, call:
- Page 10 – Wiring Diagrams
- Page 16 – Limited Warranty; Your Research Products Corporation Aprilaire; Products For Better Indoor Air Quality
IMPORTANT SAFETY INFORMATION
WARNING:
• Always turn off power at the main power source by unscrewing
fuse or switching circuit breaker to the off position before installing,
removing, cleaning, or servicing thermostat.
• Read all of the information in this manual before installing or
programming this thermostat.
• This is a 24V AC low-voltage thermostat. Do not install on voltages
higher than 30V AC.
• All wiring must conform to local and national building and electrical
codes and ordinances.
• Do not short (jumper) across terminals on the gas valve or at the
system control to test installation. This will damage the thermostat
and void the warranty.
1
2 Heat / 2 Cool Digital
Heat Pump
MODEL 8336
User’s Manual
Installation and
Operation
ELECTRONIC THERMOSTATS
®
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Features • Multi Stage heating and cooling control. • Zone system compatible as a master thermostat. • Multi-Colored LED indicators for system status. • Low battery indicator. • Fahrenheit/Celsius display option. • Adjustable from 45°F (4°C) to 90°F (32°C). • Accuracy within ± 1 degree. • Adjustable...
4. After labeling wires, remove wires from terminals. 5. Remove existing thermostat base from wall. 6. Refer to the following section for instructions on how to install thermostat. Installing the Model 8336 Thermostat NOTE: For new installations, mount thermostat on inside wall, 4-5 feet above the f...
5. Place thermostat against the wall at desired location. Make sure wires will feed through opening on base of thermostat. 6. Mark placement of mounting holes. See Fig. 3. Set base aside. figure 3 7. Drill the marked holes using a 3/16" drill bit. NOTE: Enclosed plastic anchors do not require a ...
