APC AR8173BLK - Manual
APC AR8173BLK – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installing Data Cable Partitions; ensure a finished appearance.
- Page 3 – Seismic environments
- Page 4 – Bonding Data Cable Partitions and ladders
- Page 5 – 本マニュアル<各国の言語に対応する>は
- Page 8 – APC Worldwide Customer Support; Global support searching APC Knowledge Base and using e-support.; Customer Support Center by telephone or e-mail.
Data Cable Partitions–Installation
Overview
Data Cable Partitions separate power cables and data cables that are routed on the roofs of
NetShelter
®
enclosures or in an InfraStruXure
®
system. Each Data Cable Partition is one piece and
has openings for routing data cables in and out of enclosures.
Data Cable Partitions
NetShelter SX Enclosures.
InfraStruXure Power Distribution Unit (PDU).
InfraStruXure InRow
®
RC.
Included with each partition
Data Cable Partition
AR8162ABLK (600-mm wide)
AR8172BLK (750-mm wide)
Pass-through Data Cable Partition
AR8163ABLK (600-mm wide)
AR8173BLK (750-mm wide)
Data Cable Partition, InfraStruXure PDU
AR8182BLK (750-mm wide)
Pass-through Data Cable Partition,
InfraStruXure PDU
AR8183BLK (750-mm wide)
Data Cable Partition
AR8184 (300-mm wide)
8-in ground strap (1)
M6 serrated lock washer (4)
M6 flanged hex nut (2)
A
B
C
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Data Cable Partitions—Installation 2 Installing Data Cable Partitions Use the procedure in this section to install all of the Data Cable Partitions. You can install Data Cable Partitions on a NetShelter Enclosure or a PDU. 1. Squeeze the two sides of the Pass-through Data Cable Partition to insert t...
Data Cable Partitions—Installation 3 Seismic environments Note: For installations in environments with seismic requirements, install cage nuts and screws (provided with enclosure) in the holes on the roof that are aligned with the holes on the partition. ns 13 50 a
Data Cable Partitions—Installation 4 Bonding Data Cable Partitions and ladders To bond NetShelter Data Cable Partitions to one another: 1. Attach one end of an 8-in ground wire to a ground stud on the partition and secure the ground wire with two M6 washers and an M6 nut as shown. 2. Connect t...
