APC 5000T - Manual

Table of Contents:

• Page 3 – Handling Safety; pluggable equipment; WARNING! Battery Safety; This equipment contains potentially hazardous voltages.; Replacement and Recycling of Batteries; User’s Manual
• Page 5 – Table of Contents
• Page 7 – Inspection
• Page 8 – Installation; Position the UPS; Placement; APC Contact Information; must be put into position before the batteries are installed.
• Page 10 – Back; Load the UPS into the Rack; Rack Mount Options
• Page 11 – Connect the Batteries; UPS case so you must install the batteries before connecting them.; Grasp the top edge of the bottom front cover and; tilt
• Page 13 – Connect Power and Equipment to the UPS; Use your equipment’s power cords to connect to the UPS.; Connect Power to the UPS and Accessories; Software Installation: Instruction Sheet; Initial Startup; Rear Views
• Page 14 – press the button. Press it once to set the UPS’s sensitivity to; reduced; . Press it again to set the sensitivity to; low; the button a third time to reset
• Page 15 – Operating Instructions; Switch On — Switch Off; immediately powered while the UPS beeps and performs a self-test.; On Battery; Replacing the Battery; Replace Battery
• Page 16 – Specifications; Cold start is not a normal condition.; Press and hold the on/test button until the UPS beeps.; voltage bar graph has a margin of error of
• Page 17 – Storage; Storage Conditions; Model Number
• Page 18 – Battery Replacement Procedure - Tower Units; Disconnect the front battery pack:; when removing the top set.
• Page 19 – Battery Replacement Procedure - 3U Rack Mount Units; Grasp the tab and gently pull the battery out of the UPS.; Be careful removing the batteries - they are heavy.
• Page 20 – Battery Replacement Procedure - 5U Rack Mount Units; Pull the front battery out of the UPS by pulling on the clear label,; The 5000 VA model has four sets of batteries
• Page 21 – User Configuration Items; How to Determine On-Battery Run Time; UPS battery life differs based on usage and environment.
• Page 23 – U Units
• Page 24 – Troubleshooting; for a location near you.; Voltage
• Page 25 – If the UPS requires service do not return it to the dealer!; Review the problems discussed in; in transit is not covered under warranty.; Mark the RMA# on the outside of the package.; North America; Limited Warranty; Service
• Page 26 – Appendix A: XL Information; XL Installation; This UPS; Secure the connector clamp.; Do not stack battery packs. Stacking results in a tipping hazard.
• Page 27 – Smart-UPS Battery Protocol; Use PowerChute®; plus
• Page 29 – Remove batteries to reduce UPS weight.
• Page 30 – requires; remain in the UPS they do not have to be removed.; Graphics are not drawn to scale. They are shown for reference only.