APC 5000I - Manual
APC 5000I – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Handling Safety; pluggable equipment; WARNING! Battery Safety; This equipment contains potentially hazardous voltages.; Replacement and Recycling of Batteries
- Page 5 – Table of Contents
- Page 7 – Introduction; About Your New UPS; Unpacking; Inspection; rails to support the unit in a rack.; How to Unpack the UPS; Read this
- Page 8 – Installation; Installing your UPS requires six steps:; Position the UPS; Placement; Installing the UPS in a rack involves a four-step process:
- Page 10 – Hardwire the Electrical Connection; screw which holds it in place.; Wire Input Panel; cable or conduit connector.
- Page 11 – Install the Batteries; Graphics are not drawn to scale. They are shown for reference only.; Repeat steps 3 through 5 to add the remaining battery packs.; Connect Power and Equipment to the UPS; Do not plug laser printers into the UPS.; Connect Power to the UPS; black communication cable between UPS and computer. See the
- Page 12 – Initial Startup; Rear Views; press the button. Press it once to set the UPS’s sensitivity to; reduced; . Press it again to set the sensitivity to; low; the button a third time to reset
- Page 13 – Low Battery Warning Interval; The initial setting.
- Page 14 – Operating Instructions; Switch On — Switch Off; immediately powered while the UPS beeps and performs a self-test.; On Battery; Replacing the Battery; Replace Battery
- Page 15 – Specifications; Cold start is; not; a normal condition.; Press and hold the on/test button until the UPS beeps.; voltage bar graph has a margin of error of; Storage
- Page 16 – Please read the cautions in; Smart UPS Safety Guide; , at the front of this manual. Once the battery is disconnected,; Pull the front battery out of the UPS by pulling the clear label,; Batteries must be recycled
- Page 17 – User Configuration Items; How to Determine On-Battery Run Time; UPS battery life differs based on usage and environment.
- Page 19 – Regulatory Agency Approvals
- Page 20 – Troubleshooting; APC Contact Information
- Page 21 – If the UPS requires service do not return it to the dealer!; in transit is not covered under warranty.; Limited Warranty; Internet
- Page 22 – Remove batteries to reduce UPS weight.
- Page 23 – Appendix B: Transporting Your Smart-UPS; requires; remain in the UPS they do not have to be removed.
990-7032A, Revision 3 7/01
APC Smart-UPS
Uninterruptible Power Supply
Model 5000I
User’s Manual
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
990-7032A, Revision 3 7/01 Smart UPS Safety Guide English This Safety Guide contains important instructions that should be followed during installation and maintenance of the APC equipment and batteries. It is intended for APC customers who setup, install, relocate, or maintain APC equipment. Handli...
990-7032A, Revision 3 7/01 i Table of Contents Introduction ................................................................................................................................................................................................1 Unpacking .......................................
990-7032A, Revision 3 7/01 1 Introduction About Your New UPS This Uninterruptible Power Supply (UPS) is designed to prevent blackouts, brownouts, sags and surges from reaching your computer and other valuable electronic equipment. This UPS also filters out small utility line fluctuations and isolate...
