APC 1609 - Manual - manualsarea.com

Page 3 - Front Panel; Connect Power and Equipment to the UPS; TVSS; Ensure that the branch circuit breaker is off prior; Do not

4 Front Panel Connect Power and Equipment to the UPS Hardwiring should be performed by a qualified electrician. Use appropriate size wires. 1. The UPS features a transient voltage surge-suppression ( TVSS ) screw located on the front panel. The TVSS screw is used for connecting the ground lead on su...

Page 4 - Connectors; Communication Port; The relays are connected from the common (COM) to the normally

5 Connectors Communication Port Contact Closure Port Output Contact Ratings: Emergency Power Off The emergency power off (EPO) feature is user configurable. EPO provides immediate de-energizing of connected equipment from a remote location, without switching to battery operation.Use a normally-open ...

Page 5 - Operation; UPS Display Panel; Display Panel Indicators and Function Buttons; Indicator; models

6 Operation Operation UPS Display Panel Display Panel Indicators and Function Buttons Indicator LED Indicator Title Description On-Line The UPS is supplying utility power to the connected equipment(see Troubleshooting ). AVR Trim The UPS is compensating for a high utility voltage (see Troubleshootin...

Page 6 - Feature; Automatic

7 Operation Diagnostic Utility Voltage The UPS has a diagnostic feature that indicates the utility voltage.The UPS starts a self-test as part of this procedure. The self-test does not affect the voltage display. Press and hold the button to view the utility voltage bar graph indicator. After a few s...

Page 7 - User Configurable Items; UPS settings; Settings are adjusted through PowerChute

8 User Configurable Items User Configurable Items UPS settings Settings are adjusted through PowerChute  software or optional Network Management Card. Function Factory Default User Selectable Choices Description AutomaticSelf-Test Every 14 days (336 hours) • Every 7 days (168 hours) • On start up o...

Page 9 - in the replacement battery literature.

10 Storage, Maintenance, Transport Storage, Maintenance, Transport Storage Store the UPS covered in a cool, dry location with the batteries fully charged.At 5° to 86° F (–15° to 30° C), charge the UPS battery every six months.At 86° to 113° F (30° to 45° C), charge the UPS battery every three months...

Page 10 - Troubleshooting; replace battery

11 Troubleshooting Troubleshooting Use this chart to solve minor installation and operation problems. Refer to Rockwell Automation Tech Support at 440-646-5800 for further support. Problem and/or Possible Cause Solution UPS will not turn on The battery is not connected properly. Check that the batte...

Page 13 - Service and Contact Information; Service; Review the problems discussed in; Contact Rockwell Automation

14 Service and Contact Information Service and Contact Information Service If the UPS requires service do not return it to the dealer. Follow these steps: 1. Review the problems discussed in Troubleshooting to eliminate common problems. 2. If the problem persists, contact Rockwell Automation Custome...

Page 14 - Safety Information -; SAVE THIS GUIDE; Handling Safety

Safety Information - SAVE THIS GUIDE This Safety Guide contains important instructions that should be followed during installation and maintenance of the equipment and batteries. It is intended for customers who setup, install, relocate, or maintain equipment. Changes and modifications to this unit ...

APC 1609 - Manual

Table of Contents:

Summary

Other APC Models