APC 100-127 V - Manual

Smart-UPS X 2000/2200/3000 VA 4 Operation Connect Equipment to the UPS Note: The UPS will charge to 90% capacity in the first three hours of normal operation. Do not expect full battery runtime capability during this initial charge period. 1. Connect equipment to the outlets on the rear panel of the...

5 Smart-UPS X 2000/2200/3000 VA Display Interface Overview Using the display interface Use the U P and D OWN buttons to scroll through the main menu options. Press E NTER to view the sub-menus under each main menu option. Press E SCAPE to exit a sub-menu and return to a main menu. Menu Overview The ...

Smart-UPS X 2000/2200/3000 VA 8 Configuration UPS Settings Start-up Settings Use the display interface to configure these settings at initial start-up. The UPS will prompt for a response to each setting, if no response is given, the default setting will be used. Note: The unit will not turn on until...

9 Smart-UPS X 2000/2200/3000 VA General Settings Configure these settings at any time, using the display interface, APC PowerChute ® software, or a network management card. Function Factory Default Options Description High Transfer Point Low Voltage To avoid unnecessary battery usage, set the transf...

11 Smart-UPS X 2000/2200/3000 VA Switched Outlet Groups Overview The Switched Outlet Groups can be configured to independently turn off, turn on, shut down, put to sleep, and reboot connected equipment. The Switched Outlet Groups can be commanded to do the following: • Turn off: Disconnect from powe...

Smart-UPS X 2000/2200/3000 VA 12 Network Management Card Settings These settings are available only on units that have a Network Management Card (NMC). • NMC IP Address Mode • NMC Default Gateway Turn Off Delay 90 sec Set the value in seconds The amount of time that the Switched Outlet Groups will w...

13 Smart-UPS X 2000/2200/3000 VA Emergency Power Off EPO Overview The Emergency Power Off (EPO) option is a safety feature that will immediately disconnect all connected equipment from utility power. The UPS will immediately shut down and will not switch to battery power. Connect each UPS to the EPO...

Smart-UPS X 2000/2200/3000 VA 14 Troubleshooting Problem and Possible Cause Solution The UPS will not turn on or there is no output The unit has not been turned on. Press the ON button to turn on the UPS. The UPS is not connected to utility power. Ensure that the power cable is securely connected to...

15 Smart-UPS X 2000/2200/3000 VA Service and Support Service If the unit requires service, do not return it to the dealer. Follow these steps: 1. Review the Troubleshooting section of the manual to eliminate common problems. 2. If the problem persists, contact APC Customer Support through the APC We...

Smart-UPS X 2000/2200/3000 VA 16 Smart-UPS Factory Warranty LIMITED WARRANTY American Power Conversion (APC) warrants its Smart-UPS (Products) to be free from defects in materials and workmanship for a period of three (3) years, excluding the batteries, which are warranted for two (2) years from dat...

09/2011 990-3651C APC Worldwide Customer Support Customer support for this or any other APC product is available at no charge in any of the following ways: • Visit the APC Web site to access documents in the APC Knowledge Base and to submit customer support requests. – www.apc.com (Corporate Headqua...