A.O. Smith BTI-80 - Manual
A.O. Smith BTI-80 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FOREWORD; In the United States:; TOP VIEW
- Page 3 – TABLE OF CONTENTS; WARNING
- Page 4 – HIGH ALTITUDE INSTALLATIONS; CIRCULATING PUMP; INSTALLATION INSTRUCTIONS; REQUIRED ABILITY
- Page 5 – FLAMMABLE ITEMS; CLEARANCES; AIR REQUIREMENTS; UNCONFINED SPACE
- Page 6 – VENTING; FIGURE 2; VENT CONNECTION; MIXING VALVE APPLICATION FOR TWO TEMPERATURE WATER
- Page 7 – AND SPACE HEATING; CAUTION; RELIEF VALVE; GAS PIPING
- Page 8 – WIRING DIAGRAM AND SCHEMATIC - FIGURE 4; HEATER WIRING
- Page 9 – FIGURE 5 - GAS PIPING AND DIRT LEG INSTALLATION; PURGING; GAS PRESSURE REGULATOR; OPERATION; TO OPERATE THE HEATER
- Page 10 – FOR YOUR SAFETY READ BEFORE OPERATING; OPERATING INSTRUCTIONS; BEFORE OPERATING
- Page 11 – CHECKING VENTING; DANGER; FIGURE 6
- Page 12 – CHECKING GAS INPUT; VENT SYSTEM; SERVICE INFORMATION; MAIN BURNER AND IGNITER
- Page 13 – PREVENTIVE MAINTENANCE; FIGURE 8
- Page 14 – TANK CLEANOUT PROCEDURE; FIGURE 9
- Page 15 – CHECKLIST; NOT ENOUGH OR NO HOT WATER; CONDENSATION
- Page 16 – SERVICE AND REPAIR; TROUBLESHOOTING; WATER HEATING CYCLE
- Page 17 – PROBLEM
- Page 18 – WARNING: DO NOT BY-PASS ANY CONTROLS TO MAKE HEATER OPERATE.; TER HEA; LED STATUS
- Page 19 – Model BTI Limited Warranty
- Page 20 – REPLACEMENT PARTS
1
PRINTED IN U.S.A. 0803
MODELS BTI-80 AND 100
PLACE THESE INSTRUCTIONS ADJACENT TO HEATER
AND NOTIFY OWNER TO KEEP FOR FUTURE REFERENCE.
COMMERCIAL GAS WATER HEATER
Glass-Lined Tank-type Water Heater
PART NO.195086-000
• INSTALLATION • OPERATION • SERVICE • MAINTENANCE • LIMITED WARRANTY
Thank you for buying this energy efficient water heater
from A.O. Smith Water Products Company. We
appreciate your confidence in our products.
CAUTION
TEXT PRINTED OR OUTLINED IN RED CONTAINS INFORMATION
RELATIVE TO YOUR SAFETY. PLEASE READ THOROUGHLY
BEFORE INSTALLING AND USING THIS APPLIANCE.
A DIVISION OF A.O. SMITH CORPORATION
McBEE, SOUTH CAROLINA, USA
STRATFORD, ONTARIO, CANADA
www.hotwater.com
Series 110
Natural Gas Only
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 FOREWORD The design of models BTI-80 and 100 comply with the latest version ofANSI Z21.10.3/CSA 4.3 as automatic storage or automatic circulating tanktype water heaters. Installation diagrams are found in this manual. These diagrams will serveto provide the installer with a reference for the mater...
3 GENERAL SAFETY INFORMATION PRECAUTIONS DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER.Immediately call a qualified service technician to inspect the appliance andto replace any part of the control system and any gas control which hasbeen under water. IF THE UNIT IS EXPOSED TO THE FOLLO...
4 heater meets or exceeds the ASHRAE/IES 90.1b-1999 standards withrespect to insulation and standby loss requirement making an insulationblanket unnecessary. WARNING Should you choose to apply an insulation blanket to this heater, you shouldfollow these instructions. Failure to follow these instruct...