Ampeg V-50H - Manual
Ampeg V-50H – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – 7: Footswitch Jack: Connect the supplied; V-50H Guitar Amplifier
- Page 3 – pueda danar el acabado.
- Page 4 – Ampeg is proudly Made in America.; 2dB Boost and Cut @ 6kHz
Owner’s Guide
for the
V-50H Guitar Amplifier
Made in the
U.S.A.
by
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
THE FRONT PANEL:1. Power switch is used to turn the amplifieron and off. 2. Power light indicates the amplifier isturned on by glowing an iridescent blue color. 3. Reverb controls the amount of reverbera-tion applied to the signal. With the control atthe “0” position there is no reverb applied; asth...
THIS EQUIPMENT HAS BEENDESIGNED AND ENGINEEREDTO PROVIDE SAFE AND RELI-ABLE OPERATION. IN ORDERTO PROLONG THE LIFE OF THEUNIT AND PREVENT ACCIDEN-TAL DAMAGES OR INJURY,PLEASE FOLLOW THESE PRE-CAUTIONARY GUIDELINES: CAUTION: TO REDUCE THERISK OF ELECTRIC SHOCK, DONOT OPEN CHASSIS; DO NOTDEFEAT OR REM...
Ampeg is proudly Made in America. ©1997 SLM Electronics, 1400 Ferguson Avenue, St. Louis, MO 63133 U.S.A. V-50H TECHNICAL SPECIFICATIONS: OUTPUT POWER RATING 50 Watts RMS @ 5 % THD 8 ohm load 120 VAC SIGNAL TO NOISE RATIO 70dB Typical POWER REQUIREMENTS 120 VAC, 60Hz, 110VA 100/115 VAC, 50/60Hz, 110...
