American Audio XLT1200 - Manual
American Audio XLT1200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – CAUTION
- Page 5 – Front Panel; Bridge Mode. Before powering down the amp, turn the gain control to
- Page 6 – Rear Panel; thing in front or obstruct these vents.
- Page 8 – Set Up; INPUTS; Unbalanced TS 1/4” Plug; Balanced TRS 1/4” Plug; Male XLR Pin Confi guration:; US ITT Standard
- Page 9 – quickly change out an amp. The Neutrik Speakon
- Page 11 – Mono Bridge Operation -; your amplifier output.
- Page 12 – RF; from the output and
- Page 14 – TYPICAL MONO BRIDGE SET-UP; TYPICAL STEREO OUTPUT CONNECTIONS; SPEAKERS
- Page 15 – TYPICAL PARALLEL SET-UP; OHM MINIMUM
- Page 16 – team on our toll free number.; Please contact American Audio; of warranty terms and conditions heretofore published.
- Page 17 – XLT Series SPECS
- Page 19 – Notes
User Instructions
AMERICAN AUDIO
®
6122 S. Eastern Ave.
Los Angeles Ca. 90040
1/12
Professional Power Amplifier
XLT Series
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. THERE ARE NO USER SERVICEABLE PARTS INSIDE. REFER ALL SERVICE TO YOUR AUTHORIZED AMERICAN AUDIO ® DEALER. CAUTION Do not open - risk of electric shock F O R O P T I M U M P E R F O R M A N C E A N D RELIABILITY DO NOT PRESENT TH...
1. Indicator LEDs - Channel Protect Indicator - The red Protect LED will begin to glow when the channel goes into protect mode. When the channel goes into protect mode all output for that channel will turn off. This is to protect any speakers connected to the channel.Channel Clip Indicator - This re...
Rear Panel XLT900 Figure 2 8 17 15 12 11 10 9 13 14 ©American Audio® - www.americanaudio.us - XLT Series Power Amplifier User Manual Page 6 8. Channels 1 & 2 Speakon Outputs - Optional speaker output connections. Use pins 1+ and 1- of this 4-pole Speakon connector to connect to your speak- er’s ...
