Amana W10130752B - Manual - manualsarea.com

Page 2 - RANGE SAFETY; You; DANGER; WARNING: Gas leaks cannot always be detected by smell.

2 RANGE SAFETY You can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don't follow All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what canhappen if the instructions are n...

Page 3 - INSTALLATION REQUIREMENTS; Tools and Parts; Tools needed; Location Requirements; WARNING; Tip Over Hazard

3 INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed Parts supplied Check that all parts are included. ■ Anti-tip bracket must be securely mounted to subfloor. ...

Page 4 - Mobile Home - Additional Installation Requirements; Mobile home installations require:; Product Dimensions

4 Mobile Home - Additional Installation Requirements The installation of this range must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When such standard is n...

Page 5 - Type of Gas

5 Electrical Requirements IMPORTANT: The range must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, latest edition. If codes permit and a separate ground wire is used, it is recommended that a ...

Page 6 - Gas Supply Line; Flexible metal appliance connector:; Gas Pressure Regulator

6 Gas Supply Line ■ Provide a gas supply line of ¾" (1.9 cm) rigid pipe to the range location. A smaller size pipe on longer runs may result in insufficient gas supply. With LP gas, piping or tubing size can be ½" (1.3 cm) minimum. Usually, LP gas suppliers determine the size and materials u...

Page 7 - INSTALLATION INSTRUCTIONS; Unpack Range; Excessive Weight Hazard

7 INSTALLATION INSTRUCTIONS Unpack Range 1. Do not use oven door handle to lift or move the range 2. Remove shipping materials, tape and film from range. Keep cardboard bottom under range. 3. Remove oven racks and parts package from inside oven. 4. To place range on its back, take 4 cardboard corner...

Page 8 - Make Gas Connection; Typical rigid pipe connection; Typical flexible connection; Explosion Hazard

8 7. Move range close enough to the opening to allow for final electrical connection. Remove shipping base, cardboard or hardboard from under range. 8. Open the broiler door. Use a ³⁄₈ " drive ratchet to lower the rear leveling legs one-half turn. Use a wrench or pliers to lower the front leveli...

Page 9 - Complete Connection; Verify Anti-Tip Bracket Location; Level Range; Electrical Shock Hazard

9 3. Use a combination wrench and pliers to attach the flexible connector to the adapters. Check that connector is not kinked. Complete Connection 1. Locate gas pressure regulator in the broiler. IMPORTANT: Do not remove the gas pressure regulator. 2. Check that the gas pressure regulator shutoff va...

Page 10 - Electronic Ignition System; Initial lighting and gas flame adjustments; If the low flame needs adjusting:; Check Operation of Oven/Broil Burner

10 Electronic Ignition System Initial lighting and gas flame adjustments Cooktop and oven burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to the “LITE” position, the system creates a spark to light the burner. This sparking continues until the con...

Page 11 - If the flame needs adjusting:; Complete Installation; If you need Assistance or Service:

11 If the flame needs adjusting: 1. Turn the oven off. Wait for the oven burner to cool down. 2. Open oven door and remove oven racks, oven tray, flame spreader and set aside. 3. Locate the air shutter near the rear wall of oven and loosen the shutter screw. 4. Adjust the air shutter. 5. Turn the ov...

Page 12 - GAS CONVERSIONS; LP Gas Conversion; To Convert Gas Pressure Regulator

12 GAS CONVERSIONS Gas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer. LP Gas Conversion To Convert Gas Pressure Regulator 1. Turn manual shutoff valve to the “closed” position. 2. Unplug range or disconnect power. 3. Open broiler door and ...

Page 14 - Complete Conversion; Natural Gas Conversion

14 Complete Conversion 1. Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply. 2. Turn the manual shutoff valve in the gas supply line to the open position. 3. Refer to “Check Operation” in the “Electronic Ignition System” section for proper burner ignition...

Page 16 - Refer to the “Make Gas Connection” section for properly; Turn the manual shutoff valve in the gas supply line to the

Complete Conversion 1. Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply. 2. Turn the manual shutoff valve in the gas supply line to the open position. 3. Refer to “Check Operation” in the “Electronic Ignition System” section for proper burner ignition, o...

Amana W10130752B - Manual

Table of Contents:

Summary

Other Amana Models