Amana MMW 2 - Installation Manual
Amana MMW 2 – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
HOW TO INSTALL MMW-2 WIRELESS WALL THERMOSTAT WITH AMANA K OR J SERIES PTC, HEC, DRY OR
PMC UNIT
Tools Needed:
¼” nut driver,
phillips screwdriver, paper clip
1.
Unplug Amana PTAC chassis unit and remove front cover by grasping on right and left sides and lifting up and
out to release the front cover from chassis unit. Set the front cover aside.
2.
Open MMW-2 wall thermostat box and lay out parts. See below for what you should be included in the box.
Drywall anchors and screws are in the back of the wall thermostat transmitter.
3.
Remove subbase (mounting plate on back of wall thermostat) from wall thermostat with finger at inset shown
below left and lift to release. Mount subbase on interior wall in middle of room, 4 to 5 feet above the floor,
oriented as shown below right with arrows pointing up, using supplied drywall anchors and screws shipped in the
subbase. Use integral bubble level to make sure it looks good.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
