Amana D7824703 - Manual
Amana D7824703 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Connect Water Supply Line; Caution; Install Water Inlet Tube
- Page 3 – Install Ice Maker; or
- Page 4 – Ice Maker Full One Year Warranty
Parts
Use listed part numbers only when ordering replacement
parts. Part number are not used in installation instructions.
1
2
3
8
9
7
4
10
5
6
11
12
13
Item
Description
Part num ber
1
Ice m aker
D7824703
2
Ice m aker cover
10519801
3
5
/
8
" long sheet m etal screw (to
secure ice m aker)
M0211118
4
Stainless steel clip
B5720302
5
Ice m aker wire harness clam p
10526701
6
Ice m aker wire harness
D7813004
7
Ice m aker arm
10884401
8
Button plug
M0311301
9
Oblong plug
A3124301
10
T herm al fuse clip (attached to
ice m aker)
10319801
11
Plastic clips (4)
M0104106
12
Ice storage bucket
10476201
13
Com pression nut and sleeve
10244904
N/S
W arning leve l (attached to side
of ice m aker)
A3036901
N/S
Diagnostic label (inside ice
m aker cover)
10834701
N/S
Installation Instructions
10527033
N/S= Not sho wn
Introduction
!
Recognize this symbol as a
safety precaution.
Read entire manual before installing kit. All necessary tools
and materials must be available prior to installation. Verify
all listed parts are included in kit. If parts are missing,
contact source from whom kit was purchased.
• Mechanical experience is required to install kit.
• If unable to solve a problem during installation, contact
an authorized Amana technician. Locate a Factory
Service Center or independent authorized technician by
calling 1-800-628-5782 inside U.S.A. and 1-319-622-
5511 outside U.S.A. Service is at owner’s expense.
Safety Instructions
!
WARNING
To avoid electrical shock which can cause severe
personal injury or death, unplug power cord or open
household circuit breaker to refrigerator before installing
kit. After installing kit, reconnect power.
!
Caution
To avoid property damage, observe the following:
• Confirm water pressure to water valve is at least 20
pounds per square inch.
• Start nuts by hand to avoid cross threading. Finish
tightening nuts using a wrench. Do not overtighten.
• Check carefully for water leaks prior to returning
refrigerator to normal location and 24 hours after
connection.
Before Connecting Ice Maker
Important
• Before connecting ice maker, contact a plumber to
connect copper tubing for refrigerator water supply to
household plumbing in compliance with local codes and
ordinances.
Use
1
/
4
" (6 mm) flexible copper tubing. Length of copper
tubing must reach from water supply connection plus an
additional 8' (2.5 m) for service loop behind refrigerator.
Tubing should be soft instead of rigid and ends should be
free of burrs.
Copper tubing route must be above 35°F (2°C) to prevent
water line from freezing.
IC8 Top and Bottom Freezer Refrigerator Ice Maker Kit
Installation and Operating Instructions
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Do not use piercing type or 3 / 16 " saddle valves! Both reduce water flow, become clogged with time and may cause leaksover time if repair is attempted. The correct type of shut-offvalve requires a 1 / 4 " hole to be drilled in the water supply pipe prior to valve attachement. • Amana Appli...
Clips Install Ice Maker 1. Remove any shelves that may obstruct installation ofice maker module.Models with ice service rackSlide ice service rack toward front of freezer untilscrews are in middle of mounting holes. Gently pull iceservice rack away from freezer. Remove screws usinga 1 / 4 " hex ...
! Caution To avoid property damage, all covers must be in place. 12. Plug in refrigerator and move refrigerator in place. Level if necessary. 13. Check for water leaks 24 hours after installation. Operating Instructions • Confirm ice bucket is in place and ice maker arm is down. Ice maker arm Off po...
