Page 2 - Important Notices for Consumers and Servicers; WARNING; DANGER; I m p o r t a n t I n f o r m a t i o n
RS5320016 Rev. 0 2 Pride and workmanship go into every product to provide our customers with quality products. It is possible, however,that during its lifetime a product may require service. Products should be serviced only by a qualified servicetechnician who is familiar with the safety procedures ...
Page 3 - T a b l e o f C o n t e n t s
3 RS5320016 Rev. 0 T a b l e o f C o n t e n t s Important Information ................................................. 2Important Product Information .................................... 4Important Safety Information ...................................... 5Product Information Strirrer Blade .........
Page 4 - Earthing Instructions; Servicing of Earthed Products; WIRING; Important Product Information
RS5320016 Rev. 0 4 WARNING ! To avoid risk of electrical shock, personal injury ordeath; verify earthing instructions are followed. Earthing Instructions WARNING ! Do not remove earthing prong when installing earthedappliance in a home or business that does not havethree wire earthing receptacle, un...
Page 5 - Important Safety Information
Page 8 - P r o d u c t I n f o r m a t i o n
RS5320016 Rev. 0 8 Stirrer Blade Distributes microwave energy throughout the cavity. Blower/Fan Assembly Circulates cooling air throughout the convection ormicrowave oven compartment and cavity. Stirrer Cover Covers and protects the stirrer blade assembly. Door Interlock and Monitoring Switch NOTE: ...
Page 9 - Component Testing Procedures
Component Testing Procedures ! WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitor before servicing, unless testing requires power. RS5320016 Rev. 0 9 Illustration Component Test Results Thermal cutout Disconnect all wires from TCO. M...
Page 13 - Microwave Power Test
1 3 RS5320016 Rev. 0 ∆ T Cooking ∆ T Cooking ( ° C ) Power Output ( ° C ) Power Output 7 4 9 0 1 2 8 4 0 8 5 6 0 1 3 9 1 0 9 6 3 0 1 4 9 8 0 1 0 7 0 0 1 5 1050 1 1 7 7 0 T e s t M o d e s Temperature Chart ONE MINUTE, TWO SECONDS run time chart for units less than 1550 watts cooking power. Microwave...
Page 14 - T e s t M o d e s; Convection Temperature Test; Convection Temperature Calibration
RS5320016 Rev. 0 1 4 T e s t M o d e s Convection Temperature Test NOTE: It is absolutely necessary to own and use a thermocouple type oven tester to accuratelymeasure oven temperature. No other type ofthermometer can take its place. NOTE: Before testing an oven to check calibration, inspect the RTD...
Page 15 - Measurement With a Fully Assembled Oven; M i c r o w a v e L e a k a g e T e s t; Equipment
1 5 RS5320016 Rev. 0 Measurement With the Outer CaseRemoved DANGER ! To avoid risk of personal injury or death avoidcontacting any high voltage components. Whenever you replace the magnetron, measure forradiation leakage before the outer case is installed andafter all necessary components are replac...
Page 16 - D i s p l a y D i a g n o s t i c s; CAUTION; Error Codes
RS5320016 Rev. 0 1 6 D i s p l a y D i a g n o s t i c s CAUTION ! All repairs as described in this troubleshooting section are to be performed only after the caution procedures onethrough eight listed below have been followed.1. Check grounding before checking for possible causes.2. Be careful of t...
Page 17 - Service Test; To Enter Service Mode, oven door must be closed.
1 7 RS5320016 Rev. 0 Service Test STG COOK PREHEAT STANDBY ITEM POWER C M 1 2 34 QTY LEVEL NOT READY STG COOK PREHEAT STANDBY ITEM POWER C M 1 23 4 QTY LEVEL NOT READY STG COOK PREHEAT STANDBY ITEM POWER C M 12 3 4 QTY LEVEL NOT READY STG COOK PREHEAT STANDBY ITEM POWER C M 1 2 3 4 QTY LEVEL NOT REA...
Page 18 - TEMP
RS5320016 Rev. 0 1 8 To Exit Service Mode Press STOP RESET STG COOK PREHEAT STANDBY ITEM POWER C M 123 4 QTY LEVEL NOT READY STG COOK PREHEAT STANDBY ITEM POWER C M 1 23 4 QTY LEVEL NOT READY STG COOK PREHEAT STANDBY ITEM POWER C M 1 234 QTY LEVEL NOT READY STG COOK PREHEAT STANDBY ITEM POWER C M 12...
Page 19 - Troubleshooting; Power Up
1 9 RS5320016 Rev. 0 Troubleshooting Plug oven into power source. POWER UP CONDITION NORMAL Proceed to DISPLAY DIAGNOSTICS. 1. No line voltage.2. Inoperative power cord.3. Inoperative fuse. 4. Inoperative display board.5. Inoperative H.V. board.6. Broken or loose wire connection. NO Power Up Press B...
Page 20 - Microwave Condition
RS5320016 Rev. 0 2 0 Troubleshooting Open door, place cup of water in oven. Close oven door. Microwave Condition End of cycle tone sounds. Open door and remove water. 1 . I n o p e r a t i v e o r m i s a d j u s t e d 2 . I n o p e r a t i v e m a g n e t r o n . 3 . I n o p e r a t i v e t h e r m...
Page 21 - D i s a s s e m b l y; Inner Door Assembly; Outer Door
D i s a s s e m b l y 2 1 RS5320016 Rev. 0 To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitorsbefore following any disassembly procedure. ! WARNING Inner Door Assembly 1. Remove door handle. 2. Remove outer door. 3. Remove insulation pad...
Page 22 - Outer Case; Stirrer Cover; Top Touch Panel Assembly
D i s a s s e m b l y To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitorsbefore following any disassembly procedure. RS5320016 Rev. 0 2 2 ! WARNING Outer Case 1. Remove screws securing outer case to chassis, see illustration below. 2. Sl...
Page 23 - Interlock Switch Module; Side Touch Panel Assembly
D i s a s s e m b l y 2 3 RS5320016 Rev. 0 To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitorsbefore following any disassembly procedure. ! WARNING Interlock Switch Module 1. See “Component Location” Figure 2, for location. 2. Remove out...
Page 26 - Power Cord
D i s a s s e m b l y To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitorsbefore following any disassembly procedure. RS5320016 Rev. 0 2 6 ! WARNING To remove bulb,turn in directionshown. Power Cord 1. See “Component Location” Figure 3, f...
Page 27 - Component Location
D i s a s s e m b l y 2 7 RS5320016 Rev. 0 To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitorsbefore following any disassembly procedure. ! WARNING Component Location Figure 1 Touch Panels/ Displays/Triacs Figure 2 H.V. Board / I.S. Modu...
Page 30 - This page intentionally left blank.
D i s a s s e m b l y To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitorsbefore following any disassembly procedure. RS5320016 Rev. 0 3 0 ! WARNING This page intentionally left blank.
Page 31 - Appendix A
Page 32 - ownership, be sure this manual accompanies equipment.
RS5320016 Rev. 0 A–2 International Commercial Combination Microwave and Convection Oven Keep these instructions for future reference. If the equipment changes ownership, be sure this manual accompanies equipment. Owner's Manual
Page 33 - Model Identification; PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO; Contents
A–3 RS5320016 Rev. 0 Model Identification Any questions or to locate an authorized servicer, call1-319-622-5511 If an automated telephone system isreached, select Commercial Microwave Ovens category.Warranty service must be performed by an authorizedservicer. Amana also recommends contacting anautho...
Page 34 - IMPORTANT SAFETY INSTRUCTIONS; Recognize this symbol as a SAFETY message; SAVE THESE INSTRUCTIONS
RS5320016 Rev. 0 A–4 IMPORTANT SAFETY INSTRUCTIONS Recognize this symbol as a SAFETY message Recognize this symbol as a HOT SURFACE WARNING WARNING ! When using electrical oven, basic safety precautions should be followed to reduce risk of burns, electric shock,fire, or injury to persons or exposure...
Page 36 - Installation
RS5320016 Rev. 0 A–6 Installation WARNING ! To avoid risk of electrical shockor death, this oven must begrounded and plug must not bealtered. Earthing Instructions Oven MUST begrounded. Grounding reduces risk of electricshock by providing an escape wirefor the electric current if an electricalshort ...
Page 37 - Display and Features; PREHEAT NOT READY
A–7 RS5320016 Rev. 0 Display and Features A—Oven Door Handle (Lift to open.)B—Rack GuidesC—Top Control Panel Item flashes in display indicatingkeypads can be used and cookingentries can be made. Temperature is displayed in thetime field. Preheat not ready indicates the ovenis not at preheat temperat...
Page 39 - Start Pad; Cooking Display; Programming Display; Pr og; Temperature warnings
A–9 RS5320016 Rev. 0 Display and Features (cont’d) PREHEAT ON / OFF TIME TEMP POWER LEVEL STAGE PROGRAM SAVE PREHEAT NOT READY Start Pad The start pad is usedto begin a manualtime entry cookingcycle. STOP/RESET pad The STOP/RESET pad stops a cooking sequence inprogress, clears out anyremaining time,...
Page 40 - What is stage; Programming; Programming Multiple Stages; PROG
RS5320016 Rev. 0 A–10 Programming What is stage cooking? Stage cooking enables several different cooking cycles, orstages, to be used consecutivelywithout repeated input from the user.Stage cooking can be set to todefrost food initially, then cook it, andthen keep the food warm untilserving time. ST...
Page 41 - Convection Cooking Using; Convection Cooking with Programmed Pads; Convection Cooking; All the pad does is
A–11 RS5320016 Rev. 0 Convection Cooking CAUTION ! To avoid risk of burns, handle utensils, racks, and door with care. Allow oven, utensils, and racks to cool before cleaning. Oven, utensils, and racks, become hot during operation. To operate the oven for convection cooking only, you can use preprog...
Page 42 - Combination Cooking; Using manual time entry; Combination Cooking With
RS5320016 Rev. 0 A–12 CAUTION ! To avoid risk of burns, handle utensils, racks, and door with care. Allow oven, utensils, and racksto cool before cleaning. Oven, utensils, and racks, become hot during operation. Combination Cooking (microwave and convection) Combination Cooking The combination mode ...
Page 43 - User Options; Changing user options; Didn’t like an option?; My changes weren’t saved.; Numbered Pads
A–13 RS5320016 Rev. 0 User Options Changing user options Options such as single or double pad programming, beep volume, andmaximum cooking time can be changed to suit individual preferences. To change options oven STANDBY must display: 1. Press hidden pad.• Pad is unmarked and located to the direct ...
Page 44 - User Maintenance; Replacing Oven Light; Moving Oven Rack Guides; Oven Racks and Rack Hooks
RS5320016 Rev. 0 A–14 User Maintenance WARNING ! To avoid risk of burns orelectrical shock:• disconnect electrical supply to oven before changing light bulb. • before replacing light bulb make sure oven and bulb are cool. • do not operate oven without bulb and access cover in place. CAUTION ! Wear g...
Page 46 - Problem; ERR
RS5320016 Rev. 0 A–16 Troubleshooting WARNING ! To avoid risk of electrical shock which can cause severe personal injury or death, do not remove outer case atany time. Only authorized servicer should remove outer case. Problem Possible Cause Oven does not operate. Confirm oven is plugged into dedica...
Page 47 - Specifications
A–17 RS5320016 Rev. 0 2001 Amana Appliances Amana, Iowa 52204 Part No.12392766Printed in U.S.A.04/01 Amana Appliances Online • www.amanacommercial.com Specifications 19 1/4" o r 489 m m 18" or 457 mm 24 1/2" or 622 mm 40" o r 1016 mm MODEL ACE530, DS30E UCA2000NT, UACE530, UDS30E P...
