Amana ADB1400AMS - Manual

1

Undercounter Dishwasher

Because Whirlpool Corporation policy includes a continuous commitment to improve

our products, we reserve the right to change materials and specifications without

notice.

Dimensions are for planning purposes only. For complete details, see Installation

Instructions packed with product. Specifications subject to change without notice.

PRODUCT MODEL

NUMBERS

ADB1400PY

ADB1500AD

ADB1300AF

ADB1100AW

ADB1400AG

ADB1400AM

ADB1500AM

Electrical Requirements:

120 V, 60 Hz, AC only, 15 A or 20 A. Fused electrical

supply. Copper wire only. A time-delay fuse or circuit breaker and separate

circuit is recommended.

If direct wiring dishwasher:

Use flexible,

armored, or nonmetallic sheathed copper wire

with grounding wire that meets the wiring

requirements for your home and local codes and

ordinances. Use a UL Listed or CSA Approved conduit connector.

If connecting dishwasher with a power supply cord:

Use power supply cord kit (Part Number 4317824)

marked for use with dishwashers. Follow the kit

instructions for installing the power supply cord.

Power supply cord must plug into a grounded 3 prong outlet

located in the cabinet next to the dishwasher opening. Outlet must

meet all local codes and ordinances.

Water Supply Requirements

: A hot water line with 20 psi to 120 psi

(138 kPa to 862 kPa) water pressure. Water temperature must be 120°F (49°C)

water at dishwasher. Use 3/8" (9.5 cm) O.D. copper tubing with compression

fitting or flexible braided water supply line.

NOTE:

1/2" (1.3 cm) minimum plastic tubing is not recommended.

Use a 90° elbow with 3/4" (9.5 cm) hose connection with rubber washer. (part

number W10273460). Do not solder within 6" (15.2 cm) from water inlet valve.

Drain Requirements:

A new drain hose is supplied with your dishwasher. If

this is not long enough, use a new drain hose with a maximum length of 12'

(3.7 m) (Part No. 3385556) that meets all current AHAM/IAPMO test standards,

is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of

the dishwasher.

Make sure to connect drain hose to waste tee or disposer inlet above drain trap

in house plumbing and

20" (50.8 cm) minimum above the

floor. It is recommended that the drain

hose either be looped up and securely

fastened to the underside of the

counter, or be connected to an air gap.

Make sure to use an air gap if the drain

hose is connected to house plumbing

lower than 20" (50.8 cm) above

subfloor or floor.

Use 1/2" (1.3 cm) minimum I.D. drain line fittings.

If required, the air gap should be installed in accordance with the air gap

installation instructions. When connecting the air gap a rubber hose (not

provided) will be needed to connect to the waste tee or disposer inlet.

PRODUCT DIMENSIONS

W11542836B

Air gap

*Insulation may be compressed

(not used on all models)

33

1

/

2

"

(85.1 cm)
minimum
with rear
leveling
legs
removed

24

1

/

2

"

(62.2 cm)

23

7

/

8

"

(60.6 cm)

3/4"

(1.9 cm)*

21"

(53.3 cm)