Page 2 - English; Precautions; Warning
2 English Precautions DO NOT DISASSEMBLE OR ALTER. Doing so may lead to accident, fire or electricshock. KEEP SMALL ARTICLES OUT OF THE REACH OF CHILDREN. If swallowed,consult a physician immediately. USE THE CORRECT AMPERE RATING WHEN REPLACING FUSES. Failure to doso may result in fire or electric ...
Page 3 - Contents; Page; Basic Operation
3 English Contents Page 4 ....................................................................... Precautions Basic Operation 5 ................................................................... Power ON/OFF5 ..................... Adjusting Volume/Balance/Fader/Subwoofer Equalizer/Surround Operatio...
Page 4 - Temperature; Direct sun and heat; Replacing Fuses
4 English Temperature Be sure the temperature inside the vehicle isbetween +60°C (+140°F) and –10°C (+14°F)before turning your unit on. Installation Location Make sure the ERA-G311 will not be exposedto: • Direct sun and heat • High humidity • Excessive dust • Excessive vibrations Replacing Fuses Re...
Page 5 - Note: Some functions or displays are limited
5 English Basic Operation Power ON/OFF The unit is turned OFF/ON from the head unit'sPower switch. Operating procedures for use withnon-Ai-NET Head Units Adjusting Volume/Balance/Fader/Subwoofer Make each adjustment on the Head Unit.For PHASE switching, press and hold the AudioControl button on the ...
Page 6 - Band Quantity Switching; surround cannot be used.; Dual Function; Note: In the dual equalizer mode, the surround
6 English Equalizer/SurroundOperation 1 7 Band 14 Band Front 7 BandRear 7 Band 1 Band Quantity Switching Press and hold the EQ SEL button for at least 4seconds to switch the equalizer band from 7 to14 bands. Note: In the 14 band equalizer mode, the surround cannot be used. Dual Function Press and ho...
Page 7 - Equalizer Presets; Press the EQ button to select the MALE setting.
7 English Equalizer/SurroundOperation 1 2 3 4 5 6 Frequency Level ↓ Frequency Level ↓ ↓ Frequency Level ↓ Frequency Level ↓ Frequency Level ↓ Frequency Level Equalizer Presets Six typical equalizer settings are preset at thefactory for a variety of musical source material. Setting 1: FLAT Press the ...
Page 8 - Dual mode; ) button to select the
8 English Equalizer/SurroundOperation 1 EQ FLAT Adjusting the EqualizerSettings You can modify the Equalizer settings to createa response curve more appealing to yourpersonal taste. Press the EQ (EQUALIZER) button repeatedlyto select the Equalizer setting preset which youwish to adjust. The EQ indic...
Page 9 - Selecting BBE Mode
9 English Equalizer/SurroundOperation 1 BBE 1 BBE 2 BBE 3 BBE OFF Selecting BBE Mode The BBE (Barcus Berry Electronics) processorinstalled in this unit is designed to correct thephase distortion inherent in most loudspeakerdesigns. Ensuring the phase integrity of thesignal driving the speakers impro...
Page 11 - All seats
11 English Equalizer/SurroundOperation Choosing the Listening Posi-tion Selector (L.P.S.) This feature gives the user the ability to adjustthe time delay of the 4 main speakers toprovide the ideal sound stage for each listenerin the car. The staging can be optimized for thefront passenger, driver, f...
Page 13 - DSP Surround Presets; Surround function can not be used.; STADIUM
13 English Equalizer/SurroundOperation DSP Surround Presets The ERA-G311 employs DSP (Digital SignalProcessing) to duplicate mathematically variouslistening environments. Six typical surroundsettings are provided for a variety of musicalsource material as follows.Note: If 14-band equalizer is select...
Page 16 - Switching Display; Normal mode; Example; Reverse mode
16 English Equalizer/SurroundOperation 2 1 Switching Display Press the DISP button to switch the display.Select one of the display patterns you like. Press and hold the DISP button for morethan 2 seconds. The display will togglebetween normal or inverted mode. Normal mode Example Reverse mode DISP D...
Page 17 - Pattern
17 English Equalizer/SurroundOperation Pattern EQ Pattern Spectrum Analizer Pattern Peak Hold Pattern Peak Value Increasing Pattern "i" Character Pattern Block Pattern Mirror Pattern Spectrum Dual Stack Pattern Scan Display(Repeats endlessly for 5 seconds fromPattern 2 to Pattern 8.) Display...
Page 18 - : Some functions or displays are limited; MALE
18 English Remote ControlOperation VISUAL SEL AUDIO SEL BANDPROG DEFEAT A.PROC MUTE SELECT A V CD/3D/6D PWR UP VOL DN REMOTE CONTROL UNIT RUE-4160 ENT RUE-4160 VOL PWR REMOTECONTROLUNIT BAND PROG SOURCE A. PROC CD/3D/6D RUE - 4180 RUE-4180 If an Alpine, Ai-Net compatible head unit isconnected to the...
Page 20 - Selecting the BBE Mode
20 English Remote ControlOperation Selecting the BBE Mode Press the A.PROC (Audio Processor) button toselect the BBE mode. ★ : Some functions or displays are limited depending on the Head Unit used. Press the Up ( 8 ) or Down ( 9 ) button to select the desired BBE mode. 1 RUE-4180 A. PROC Head Unit ...
Page 22 - LPS ALL
22 English Remote ControlOperation Choosing the ListeningPosition Selector (L.P.S.) Press the A.PROC button to select the L.P.S.mode. ★ : Some functions or displays are limited depending on the Head Unit used. Press the Up ( 8 ) or Down ( 9 ) button to select the desired listening position. 1 RUE-41...
Page 23 - is shown on the Head Unit
23 English Remote ControlOperation Turning the Defeat Mode Onor Off(RUE-4160/RUE-4162 only) Press the DEFEAT button to skip the BBE/Surround circuit and get flat equalizer setting.The display DEFEAT is shown on the Head Unit side. To cancel the DEFEAT mode, press theDEFEAT button a second time. 1 DE...
Page 25 - SR LEVEL ±0; SR TIME –1
25 English Remote ControlOperation 1 2 SR LEVEL ±0 ENT 3 SR LEVEL +3 ENT SR TIME –1 ENT Adjusting the SurroundSettings Select the surround mode to be adjusted. Referto page 19 "Selecting the Factory PresetSurround Modes". Press the ENT button to activate (for 5seconds) the adjustment mode. D...
Page 26 - Making the BBE by Yourself; While the BBE band is displayed, press the
26 English Remote ControlOperation Making the BBE by Yourself Select the BBE mode you desire to adjustreferring to the Page 20 "Selecting the BBEmode". Press the ENT button, and the BBE band willbe displayed for 5 seconds. While the BBE band is displayed, press the c or f button to display t...
Page 27 - Note: Each operation should be made within 5; MEMORY
27 English Remote ControlOperation 1 Storing Custom EqualizerSettings Customize the equalizer settings as describedon page 24 "Customizing the EqualizerSettings". Press and hold the ENT button at least 2seconds. Press the 8 or 9 button to select the curve to be stored from PRESET 1 to PRESET...
Page 28 - LPS F
28 English Remote ControlOperation Adjusting L.P.S. Select the L.P.S. mode to be adjusted. Refer topage 22 "Choosing the Listening PositionSelector (L.P.S.)". Press the ENT button to activate (for 5seconds) the L.P.S. adjustment mode. Press the 8 , 9 , c or f button to adjust for the desired...
Page 29 - Adjusting the Time Correction; Example 2; Rear Right; Example 1; Front Left
29 English Remote ControlOperation Adjusting the Time Correction Time Correction:The distance between the listener and thespeakers in a car vary widely due to the specialconditions of the mobile environment. Thisdifference in the distances from the speakers tothe listener creates a shift in the soun...
Page 31 - Storing the Time Correction; Press the; Note: Each operation should be made within; TC
31 English Remote ControlOperation Storing the Time Correction Adjust the time correction value referring topage 29 "Adjusting the Time Correction". Press and hold the ENT button at least 2seconds. Press the 8 or 9 button to select the time correction value to be stored from PRESET 1 toPRESE...
Page 34 - Symptom; No function or display.; Cause and Solution; Initial Turn-On After Installation
34 English Remote ControlOperation If you encounter a problem, please review theitems in the following checklist. This guide willhelp you isolate the problem if the unit is atfault. Otherwise, make sure the rest of yoursystem is properly connected or consult yourauthorized Alpine dealer. Symptom No ...
Page 35 - Specifications
35 English Remote ControlOperation English Specifications Number of Bands .......................................................................................................................... 14 Equalizer Center Frequency Range ..................................................... 50/80/140/200...
