Alliance PT120S- User Manual

Alliance PT120S

Alliance PT120S– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
78 Page 78
79 Page 79
80 Page 80
81 Page 81
82 Page 82
Page: / 82

Table of Contents:

  • Page 3 – Table of Contents; Section 1 – Safety Information
  • Page 5 – DANGER; • Failure to install, maintain and/or operate; WARNING
  • Page 6 – • Never start the tumbler with any guards/
  • Page 7 – Model Identification; Information in this manual is applicable to these models:; Includes models with the following control suffixes (7; Gas
  • Page 8 – Customer Service
  • Page 9 – Safety Warnings and Decals
  • Page 10 – Notes
  • Page 11 – reconnected to ensure that the tumbler is properly grounded.; Section 3; MOTOR DOES NOT START
  • Page 12 – MOTOR OVERLOAD PROTECTOR CYCLES REPEATEDLY
  • Page 13 – GAS BURNER DOES NOT IGNITE
  • Page 14 – BURNER IGNITES AND GOES OUT REPEATEDLY
  • Page 15 – BURNER REPEATEDLY CYCLES OFF ON HIGH LIMIT THERMOSTAT
  • Page 16 – CLOTHES DO NOT DRY
  • Page 17 – BURNERS NOT BURNING PROPERLY - GAS MODELS
  • Page 18 – Incorrect installation of steam piping.
  • Page 19 – TUMBLER WILL NOT START, TIME ON DRYING TIMER, DOOR CLOSED
  • Page 20 – MOTOR RUNS BUT WILL NOT HEAT
  • Page 23 – Section 4; GROUNDING INSTRUCTIONS
  • Page 25 – Section 5; BOX
  • Page 27 – IGNITION RESET SWITCH
  • Page 29 – COOL DOWN AND HEAT TIMERS
  • Page 30 – TEMPERATURE CONTROL BOARD
  • Page 32 – LOADING DOOR ASSEMBLY
  • Page 35 – LOADING DOOR HINGE LUG
  • Page 36 – LINT PANEL SWITCH; b. Remove screws from switch cover and remove
  • Page 38 – STOVE HIGH LIMIT THERMOSTAT; a. Remove four screws holding access panel to
  • Page 41 – DRIVE GUARD COVER; a. Support drive guard cover and remove screws
  • Page 43 – STEP PULLEY ASSEMBLY
  • Page 44 – Critical Torques
  • Page 46 – initial tensioning 6.0 pounds
  • Page 47 – TRUNNION BEARINGS; e. Loosen the front and rear adjusting screws.
  • Page 48 – FAN MOTOR DRIVE AND FAN ASSEMBLY
  • Page 50 – TRUNNION SHAFT ASSEMBLY
  • Page 51 – CYLINDER DRIVE MOTOR
  • Page 52 – REVERSING CONTACTOR
  • Page 53 – Contactor Box
  • Page 55 – Section 6; a. Check the front to rear level by rotating the
  • Page 56 – MAIN GAS BURNER AIR INLET; c. To adjust the air inlet shutter, loosen locking; CAUTION; INSUFFICIENT AIRFLOW
  • Page 57 – LOADING DOOR STRIKE
  • Page 61 – DRIVE BELT TENSION
  • Page 62 – initial tensioning 7.0 pounds
  • Page 63 – Section 7
Loading the manual

D55

SERVICE MANUAL

INDUSTRIAL DRYERS

PUBLICATION DATE:

1

0/0

3

70276001

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - Table of Contents; Section 1 – Safety Information

70276001 1 (continued) Table of Contents Section 1 – Safety Information Locating An Authorized Service Person .................4 Section 2 – Introduction Model Identification ................................................5Customer Service ....................................................6Serial...

Page 5 - DANGER; • Failure to install, maintain and/or operate; WARNING

70276001 3 Section 1 Safety Information Throughout this manual and on machine decals, you will find precautionary statements (“CAUTION”, “WARNING”, and “DANGER”) followed by specific instructions. These precautions are intended for the personal safety of the operator, user, servicer, and those maint...

Page 6 - • Never start the tumbler with any guards/

4 70276001 Section 1 Safety Information IMPORTANT INFORMATION: During the lifetime of a tumbler, it may require service. The information contained in this manual was written and is intended for use by qualified service technicians who are familiar with the safety procedures required in the repair of...

Other Alliance Models