Page 3 - Table of; Introduction
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT © Copyright 2011, Alliance Laundry Systems LLCAll rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. 9002107 1 T...
Page 4 - Model Identification; Information in this manual is applicable to these
9002107 2 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Introduction Model Identification Information in this manual is applicable to these models: 18 HX018PVQM7HX018PVXM7HX18PVQM6HX18PVQM7HX18PVQU6HX18PVXM6HX18PVXM7HX18PVXU6NX018BVPA7NX018BVQA7 NX018BVXA7NX018BVXM7NX18BVPA6NX1...
Page 6 - Nameplate Location; Replacement Parts
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Introduction 9002107 4 Nameplate Location The nameplate is located at the rear of the machine. Always provide the machine’s serial number and model number when ordering parts or when seeking technical assistance. Refer to Figure 1 ....
Page 7 - Safety Information; Explanation of Safety Messages; DANGER
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 5 9002107 Safety Information Explanation of Safety Messages Precautionary statements (“DANGER,” “WARNING,” and “CAUTION”), followed by specific instructions, are found in this manual and on machine decals. These precautions are inte...
Page 8 - NOTE: The WARNINGS and IMPORTANT
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Safety Information 9002107 6 7. Do not allow children to play on or in the washer. Close supervision of children is necessary when the washer is used near children. This appliance is not intended for use by young children or infirm ...
Page 9 - IMPORTANT: Ensure that the recommended; Safety Decals; Safety decals appear at crucial locations on the; WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Safety Information 7 9002107 IMPORTANT: Ensure that the recommended clearances for inspection and maintenance are provided. Never allow the inspection and maintenance space to be blocked. Safety Decals Safety decals appear at crucia...
Page 10 - Operator Safety
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Safety Information 9002107 8 Operator Safety The following maintenance checks must be performed daily: 1. Verify that all warning signs are present and legible, replace as necessary. 2. Check door interlock before starting operation...
Page 11 - Operation
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 9 9002107 Operation WE-8 Control Panel (OPL Models) Figure 2 M172 1 Keypad 4 Key Switch 2 Display 5 Serial Port 3 Emergency Stop Button 3 1 5 4 2
Page 12 - Load the Machine
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 9002107 10 Load the Machine For 18 - 75 pound models: 1. Pull the door handle towards you to open the door. Some models may have a door handle with a button that must be pressed. 2. Load the drum to the specified capacity....
Page 13 - Special Options in Run Mode; Setup of the Chemical Hold Feature
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 11 9002107 Special Options in Run Mode High: The water level in step 1 that is programmed. 1. While the machine is running, press the “Display Temp” button. Level: 2.5 cm: Water level in the bath. If the machine is filling...
Page 14 - Stop the Machine
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 9002107 12 Stop the Machine 1. Press the “Stop” button. If there is water in the machine, the display will show “Waterlevel xx.x cm” while the machine is draining the water. If the machine is spinning, the display will sho...
Page 15 - Error Messages; Door Error
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 13 9002107 Error Messages Door Error If the door is closed after start, the control will try to lock the door. If the door will not lock, “Door error” will display. Possible Faults: • Wiring is not connected properly. • Co...
Page 16 - Drain Alarm
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 9002107 14 Fill Alarm (Continued) Possible Faults: • Wiring is disconnected. • Broken inlet valve. • Problem with water supply. • Inlet valves are blocked by dirt. • The water pressure hose is broken or not connected prope...
Page 17 - Temperature Sensor Error
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 15 9002107 Temperature Sensor Error The temperature was never reached in this cycle, indicating a problem with heating, and the control shows “Temperature sensor error”. Possible Faults: • Bad temperature probe. • Wiring t...
Page 18 - Cycle Memory Error; The cycle memory is corrupt and contains unknown
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 9002107 16 Cycle Memory Error The cycle memory is corrupt and contains unknown information.Possible fault: • Unknown component found in wash cycles. Cycle Memory error
Page 19 - Summary of Major Features
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 17 9002107 Operation B-Control Panel (Coin-Operated Models) Figure 3 Summary of Major Features Table 1 CHM482R CHM488R 1 Cycle 1 7 Cycle 7 2 Cycle 2 8 Cycle 8 3 Cycle 3 9 Down Edit/Change keypad 4 Cycle 4 10 Up Edit/Change keypad 5 ...
Page 20 - conditions that can shorten machine life.; Start a Program; NOTE: Perm Press Cold is the default cycle for
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 9002107 18 Load the Machine 1. Turn on main power at its source (circuit breaker). 2. Pull the door handle towards you to open the door. Some models may have a door handle with a button that must be pressed. 3. Load to cap...
Page 21 - Figure 6; When applicable; Figure 6
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation 19 9002107 7. Add liquid and/or powder supplies to supply dispenser. Refer to Figure 6 . a. Add detergent to compartment A. b. Add softener to compartment C. Figure 6 8. Add coins to machine. As each coin is added, the ven...
Page 22 - Maintenance; Daily; Beginning of day; CAUTION
9002107 20 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Maintenance Routine maintenance maximizes operating efficiency and minimizes downtime. The maintenance procedures described below will prolong the life of the machine and help prevent accidents. Daily Beginning of day 1. ...
Page 23 - Weekly
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Maintenance 21 9002107 End of day 1. Clean the fan of the AC drive box.2. Clean the entire cabinet of the machine regularly and remove all traces of soap, etc. 3. Remove all detergent residue in the soap dispenser with hot water. 4....
Page 24 - Yearly
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Maintenance 9002107 22 3. Remove back panel and check overflow hose and drain hose for leaks. 4. Clean inlet hose filter screen: a. Turn water off and allow valve to cool, if necessary. b. Unscrew inlet hose and remove filter screen...
