Akicon NX-E90-30-Warm - User Manual

Page 5 Venting Requirements • Vent system must terminate to the outside (roof or side wall). • Do not terminate the vent system in an attic or other enclosed area. • Do not use 4” (10.2 cm) laundry-type wall caps. • Use metal/aluminum vent only. Rigid metal/ aluminum vent is recommended. • Do not us...

IMPORTANT: • A minimum of 6” round (standard for this range hood) must be used to maintain maximum airflow efficien - cy. • Always use rigid type metal/aluminum ducts if available to maximize airflow when connecting to provided duct. • Please use Duct Run Calculation below to compute total available...

Page 7 Venting Methods • This power pack range hood insert is factory set for venting through the roof or wall. • NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or • Vent work can terminate either through the roof or wall. To vent through a wall, a ...

Venting Methods (Continued) Charcoal Filter Installation Round Duct Wall Cap Roof Cap Round Elbow Power Pack Range Hood Insert 24” to 30” Above Cooking Surface average of 1 to 2 hours of daily cooking time). Available at your local resellers.Re-install grease filters. NOTE: 1.Remove grease filters f...

Electrical Requirements IMPORTANT: Observe all governing codes and ordinances. (Please consult with a qualified electrician for 220-Volt 50 Hz voltage)It is the customer’s responsibility: To contact a qualified electrical installer. To assure that the electrical installation is adequate and in confo...

Installation Excessive Weight Require two or more person to move and install this range hood. Spinal or other bodi- ly injuries could occur if it is not followed. INSTALL THE HOOD Due to excessive weight, two or more person is recommended for this step. NOTE: DO NOT INSTALL THIS POWER PACK RANGE HOO...

This range hood is designed to remove smoke, cooking vapors and odors from the cook top area. For best results, start the range hood before cooking and allow it to operate several minutes after the cooking is completed to clear all smoke and odors from the kitchen. Button functions: • Power: Power O...

Controls: • Adjusting the timer function: • While the blower (motor) is not running, press and hold • Decrease Value button over 3 seconds to enter timer mode. Adjust to desired period of delay off timer by pressing Increase Value or Decrease Value button (minimum 1 minute to maximum 9 minutes). Thi...

Troubleshooting 1. If the range hood does not operate after installa - tion: • Check if the range hood has been plugged in, make sure that all power has been turned back on and all electrical wiring are properly connected. 2. The range hood vibrates when the blower is on: • The range hood might not ...

Use and Care Information WARNING — TO REDUCE THE RISK OF FIRE, ELEC - TRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Use this unit only in the manner in - tended by the manufacturer. If you have questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at ser...

WARNING Hazard of Burns! Light bulb become extremely hot when turned on. DO NOT touch bulb until switched off and cooled. Touching hot bulbs could cause serious burns. Maintenance SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating! For optimal operation, clean r...

Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and signature of the carrier’s agent and keep copy to support your claim. Upon acceptance of items, owner assumes responsibility for its safe arrival. Report damag...