AIWA CSD-NS1 - Manual - manualsarea.com

Page 2 - ENGLISH; Precautions; Installation

2 ENGLISH Precautions Read the Operating Instructions carefully andcompletely before operating the unit. Be sure to keepthe Operating Instructions for future reference. Allwarnings and cautions in the Operating Instructions andon the unit should be strictly followed, as well as thesafety suggestions...

Page 3 - Specifications

ENGLISH 3 4 Extension cord - To help prevent electric shock, do not use a polarized AC power plug with an extensioncord, receptacle, or other outlet unless the polarizedplug can be completely inserted to prevent exposureof the blades of the plug. 5 When not in use - Unplug the AC power cord from the...

Page 4 - Power supply; Connecting antennas; Connect the AC cord as illustrated below.

4 ENGLISH Power supply Connecting antennas Connect the AM loop antenna to the AM LOOPterminals on the rear of the unit. Keep the antennaaway from metallic objects, electrical equipment andcords. For better FM reception, connect an outdoor antenna tothe FM 75 Ω terminals. Using on AC house current Co...

Page 5 - Remote control; Setting the clock; Press ENTER or

ENGLISH 5 POWER FUNCTION En Remote control Insert two R6 (size AA) batteries. • When the reach of the remote control signal is less than 5 meters (16 feet), replace the batteries. • Remove the batteries if the remote control is not going to be used for a long time. The remote control may not operate...

Page 6 - Press; For better reception; TUNER OPERATION; When an FM stereo broadcast contains noise

6 ENGLISH 1 Press * TUNER/BAND repeatedly toselect the desired band. FM AM The power is turned on and the previously tunedstation is received. * or BAND on the remote control 2 Press r , t (TUNING f - , + g ) to select a station. During FM stereo reception, “STEREO” isdisplayed. After listening, pre...

Page 7 - PRESETTING STATIONS; PAUSE/SET once so that; To listen to preset stations; SOUND ADJUSTMENT; ROCK; QSURROUND system

0-9, +10 MODE EQ a PAUSE VOLUME k , i s BAND DISPLAY r , t c PLAY ENGLISH 7 PRESETTING STATIONS You can preset up to 15 stations in each band. 1 Select a station. 2 Press * a PAUSE/SET once so that “MEMO” flashes to store the station. A station is assigned a preset number, beginningfrom 1 in consecu...

Page 8 - To remove the disc; CD OPERATION; To start play when the power is off,; NOTE

8 ENGLISH 1 Press CD. The power is turned on. 2 Press CD OPEN/CLOSE to open the disccompartment. Set a disc with the printedside up, then press CD OPEN/CLOSE toclose the disc compartment. Total number of tracks and total playing time aredisplayed. It will take about 15 seconds whenloading a CD-RW di...

Page 9 - PROGRAMMED PLAY; Repeat step 2 to program other tracks.; To check the program,

ENGLISH 9 0-9, +10 REPEAT a PAUSE MODE s STOP r , t c PLAY PROGRAMMED PLAY Up to 30 tracks can be programmed from the disc.Operate with the remote control. 1 In stop mode, press MODE repeatedlyuntil “MEMO” flashes in the display. 2 Press the numbered buttons 0-9 and +10to program a track. Example: T...

Page 10 - PLAYBACK; TAPE OPERATION; To set the tape counter to “0000”

Use Type I (normal) tapes only. PLAYBACK 1 Press TAPE/REV MODE. The power is turned on.If the tape has been inserted, play begins. 2 Press TAPE OPEN/CLOSE to open thecassette compartment and load a tapewith the exposed side facing forward. Press TAPE OPEN/CLOSE to close thecompartment. 3 Press d PLA...

Page 11 - RECORDING; Get ready to record from the source.; To record from a radio broadcast,; To record only the selected tracks of a CD; To pause recording; To insert blank spaces; To make blank spaces less than 4 seconds,

En To prevent accidental erasure Break off the plastic tabs on the cassette tape with ascrewdriver or other pointed tool after recording. To record on the tape again Cover the tab openings with adhesive tape, etc. Tab for side A Side A RECORDING 1 Load a tape with the side to be recordedon facing up...

Page 12 - TIMER OPERATION; TIMER PLAYBACK/RECORDING; ” or; To listen to a radio broadcast,

12 ENGLISH TIMER OPERATION D TIMER PLAYBACK/RECORDING The unit can be turned on at a specified time everyday with the built-in timer.Make sure the clock is set correctly. 1 Press TIMER twice for timer play or threetimes for timer recording so that “ 5 ” or “ 5 REC” flashes in the display. 2 Turn VOL...

Page 13 - Maintenance; SETTING THE SLEEP TIMER

En ENGLISH 13 Maintenance To clean the cabinet Use a soft cloth lightly moistened with milddetergent solution. Do not use strong solventssuch as alcohol, benzine or thinner. To clean the heads When the tape heads are dirty; - high frequency sound is not emitted- the sound is not adequately high- the...

Page 14 - Printed in Indonesia

NOTE This equipment has been tested and found to complywith the limits for a Class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmfulinterference in a residential installation.This equipment generates, uses, and can radiat...

AIWA CSD-NS1 - Manual

Table of Contents:

Summary

Other AIWA Models