AIWA ADC-M105 - Manual - manualsarea.com

Page 2 - NOTE

Welcome Thank you for your purchasing this AIWA product. To optimize the performance of this unit, please readthrough this manual carefully. TABLE OF CONTENTS FEATURES .......................................................................................................................................

Page 3 - PRECAUTIONS; Notes on CDs

PRECAUTIONS • Do NOT install the unit in a location where it may be subjected to:— Direct sunlight or other sources of excessive heat — Fluid, rain or moisture— Excessive dirt or dust— Excessive vibration • This unit is designed to be operated on a 12-volt DC negative-ground electrical system only. ...

Page 4 - UNPACKING; Supplied mounting kit; Compact disc changer

UNPACKING a Brackets (1 pair) Supplied mounting kit for the compact disc changer The letters are keyed to those in the instructions.Use only the supplied mounting hardware for safe and secure installation. Compact disc changer e Adhesive label(1 sheet) d Nuts (4 ea.) c Plate brackets(2 ea.) b Washer...

Page 5 - INSTALLATIONS; Precautions; Removing the transport screws

INSTALLATIONS Precautions Select the mounting location very carefully,referring to the following points. • Make sure that there is no fuel tank, wiring or piping on the other side of the mounting surface. • Make sure that the installation of the unit will not hinder the movement of the deck lid or i...

Page 6 - Horizontal installation; Construction; Deciding the position

Horizontal installation 1 Construction For details on abc ..., see page 3. INSTALLATIONS 2 Deciding the position 3 Removing temporarily 4 Making holes in the carpet 5 Completion 5 ENGLISH Note If the mounting surface needs to be strengthened,secure the plate brackets c to the bottom surface of the c...

Page 7 - Vertical installation

2 Deciding the position 3 Removing temporarily 4 Making holes in the carpet 5 Completion Vertical installation 1 Construction For details on abc ..., see page 3. Notes • If the mounting surface needs to be strengthened, secure the plate brackets c to the bottom surface of the car trunk, etc. with th...

Page 8 - Suspended installation

2 Making holes Slanted installation Be sure to set them o u n t i n g a n g l esetting levers to the45° position. Suspended installation When installing the unit in the trunk below thepackage tray, observe the following.• Select the mounting location carefully so that the unit does not hinder the mo...

Page 9 - Caution; CONNECTIONS

Caution Be sure to disconnect the ground wire terminal ofthe car battery before making a connection inorder to prevent short circuiting. ENGLISH 8 This unit is designed only for AIWA brand carstereo. Therefore you cannot use the unit withother brand’s equipment. CONNECTIONS Compact disc changer to A...

Page 10 - How to use a compact disc magazine; HOW TO USE

How to use a compact disc magazine 1 2 3 4 HOW TO USE With the label side up, insert a disc all the way. To remove a disc, pull part A in the direction of the arrow as illustrated. Disc magazine To remove the magazine, press the z button and pull out the disc magazine. Insert the magazine (which has...

Page 11 - Notes on the disc magazine; SPECIFICATIONS

Notes on the disc magazine • Be sure to place a disc on the disc tray with the label side up. If a disc is not set properly, it maycause damage to the unit. • The disc tray may be taken off from the magazine if you pull the tray forcibly. If the tray is takenout, put it back into the magazine as ill...

AIWA ADC-M105 - Manual

Table of Contents:

Summary

Other AIWA Models