Aiphone KC-IFA - Manual
Aiphone KC-IFA – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
KC-IFA
Network Video Interface Adaptor
KCS-IFA Set includes:
KC-IFA, KC-DAR, PS-2420UL
- INSTRUCTIONS -
The KC-IFA is a network video interface adaptor that allows the Aiphone color video door station to be connected
through a video server (not supplied by Aiphone) to any PC connected to a LAN or WAN network. This provides
audio and video identification and access control for a person at the camera location, answered from a PC.
DOOR STATION INSTALLATION:
1. The KC-DAR should be mounted between 48-52" above finished floor, or at optimum height for the application.
(See illustrations below.)
2. Install KC-DAR to 1-gang box or ring, or directly to wall surface with appropirate hardware.
3. Use 2 conductor, 18AWG non-shielded wire from KC-DAR to KC-IFA. (Aiphone #871802)
Single-gang box
83.5mm
(3-5/16")
Back frame
Screws supplied (2)
KC-DAR
Tamperproof
screw & cover
Mounting height
250cm (8'3")
130cm (4'3")
50cm
(20")
Unit
center
150cm (5')
The KCS-IFA System interfaces with a Network Video Server.
Aiphone has evaluated and approved the following manufactures’ products for use with the KC-IFA:
BRAND:
MODEL:
NOTES:
Inscape Data
NVS-410
Two relay outputs (One for door release)
Software Included
http://www.inscapedata.com/pdf/nvs410.pdf
VCS
VIP 10
One relay output for door release
http://www.controlware.de/cwp/daten/PDFs/Datenblatt_VIP10.pdf
NOTE: RS232 programmable relay controller can be interfaced with most video servers to control
The Tilt function of the video door station. Contact Technical Support for more information.
VIP10
NVS-410
TERMINAL DEFINITIONS:
A1/A2:
KC-DAR Connection
+/-:
DC 24V Input
BNC Connector: Video Output
NO,NC,COM: Call-in Output
OUT/GND:
Audio Output
IN/GND:
Audio Input
UP:
Tilt Control Up (“Lo” active)
DN:
Tilt Control Down (“Lo” active)
GND:
Tilt Control Ground
SPECIFICATIONS:
Power Source:
24VDC, 1A
Consumption
400mA, Max.
Video Out:
NTSC, 1Vp-p
Audio In:
10k Ohm
Audio Out:
600 Ohm
Call-in Signal:
N/O – COM – N/C, 24V DC@ 1A
(Present at .5 sec.; adjustable to 30 sec.)
Tilt Up/Down:
TTL/CMOS low level control
Weight:
4.3 lbs
Dimensions:
1.7"H x 7.9"W x 9"D
KC-DAR to KC-IFA:
2 parallel wires, non-polarized (#871802)
22 AWG = 165', 18 AWG = 330'
Pg. 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
