Agilent HP 16500 - Manual

Accessories Supplied The HP 16500H is shipped with the following accessories: • this Installation and Service Guide • a LAN Administrator’s and Service Guide • a LAN User’s Guide • screws and one cable to install the HP 16500H into the HP 16500Bmainframe • TORX 10 and TORX 15 wrenches If your HP 165...

LAN Support For information about the LAN protocols and file types supported by the HP16500H, refer to the LAN Administrator’s and Service Guide Introducing the HP 16500H Interface Module LAN Support 1–4

2 This chapter includes procedures to install the interface module intothe HP 16500B Logic Analysis System mainframe and to verify theinstallation.For detailed information on how to install the HP 16500B in one of thethree applications supported by the interface module, refer to thedocumentation for...

To Install the HP 16500H Hardware If you need instructions for removing and replacing parts of the HP 16500B,refer to the HP 16500B Logic Analysis System Service Guide . W A R N I N G SHOCK HAZARD Disconnect the power from the mainframe before performing the following procedures. After disconnecting...

To Verify the Installation 1 Check that "Ethernet" is available in the Communications menu ofthe mainframe System Configuration menu. When you power-up the mainframe, the Logic Analysis System performs thepower-up self-tests. After the self-tests are finished, the screen displays theSystem C...

Ethernet LAN Interface The LAN interface provides a network-based interface between the HP16500B Logic Analysis System and personal computers and workstations overa 10Base-T Ethernet LAN. Detailed information on installing andtroubleshooting in the LAN environment is covered in the HP 16500H LAN Adm...

3 Verify connectivity with an echo request. In most network environments, an echo request is accomplished using the ping utility. For the exact syntax for the ping or other echo request utility, refer to your network documentation. A normal response to multiple echorequests is 9, 10, or possibly 11 ...

HP 16501A Expansion Frame Interface The interface port for the HP 16501A Expansion Frame permits you toquickly and easily connect an expansion frame to the HP 16500B mainframe.With an expansion frame connected to the mainframe, a total of ten16500-series measurement modules can be configured and uti...

3 Verifying the Interface Module Performance 3-2 Performance verification procedure 3-3 Troubleshooting an HP 16501A Expansion Frame 3-7 Troubleshooting in an Ethernet LAN Environment 3-8 Troubleshooting in the HP 16505A Prototype AnalyzerEnvironment 3-9 Removing and Replacing the HP 16500H Interfac...

Verify the Interface Module Performance Before starting the interface module performance verification, check allcables and connectors to ensure that all cables are properly connected. The interface module performance verification (self-test) is divided into twosections. The first section tests the p...

Procedure This procedure verifies the performance of the interface module. To verifyperformance of the HP 16500B Logic Analysis System or the optionalmeasurement modules, refer to the Service Guides for those products. 1 If the screen appears blank, the interface module or cable may bedefective. a R...

6 Touch Test System, then select Mainframe Test in the pop-up menu.The screen will display the Mainframe Test menu. 7 Select Option Board Test, then select Run. If an HP 16501A expansion frame is not connected, then expect a "NoExpansion Card Present" message to appear when you run the Optio...

8 Verify that the tests pass. If all of the tests pass, then go to the step 9. If any of the tests fail, then LAN hardware or the interface module issuspect. • To verify the LAN hardware, perform the following checks: Check that the LAN cable is properly seated at both the interfacemodule and at the...

Troubleshooting an HP 16501A Expansion Frame For details on troubleshooting a system that is connected to an HP 16501AExpansion Frame, refer to the HP16500B/16501A Logic Analysis System Service Manual. If you suspect that the HP 16500H Interface Module is defective, use the procedures in this chapte...

Troubleshooting in an Ethernet LAN Environment For details on troubleshooting a system that is connected to an EthernetLAN, refer to the HP16500H LAN Administrator’s and Service Guide . If you suspect that the HP 16500H Interface Module is defective, use theprocedures in this chapter to verify the i...

Removing and Replacing the HP 16500H InterfaceModule 1 If the HP 16500B Logic Analysis System is connected and mounted toa LAN, then unmount the HP 16500B file system. Unmounting from a LAN You must unmount the HP 16500B before power is removed from it. Then, youcan mount the HP 16500B 15 seconds af...

5 Remove the screws connecting the interface module to themainframe. Two screws through the top of the interface module connect it to thesheetmetal plate, and four screws connect the rear plate of the interfacemodule to the rear panel of the mainframe (see the figure below). Removing the Interface M...

6 Install the new interface module by reversing this procedure. 7 Test the performance of the interface board. Refer to "Verifying the interface module performance" in this chapter for theperformance verification test procedure. 8 Reconnect the HP 16505A or HP 16501A to the interface board, ...

Returning Parts Before shipping the module to Hewlett-Packard, contact your nearestHewlett-Packard sales office for additional details. 1 Write the following information on a tag and attach it to the part tobe returned. • Name and address of owner • Model number • Description of service required or ...

Ordering Replaceable Parts Parts listed To order a part on the list of replaceable parts, quote the Hewlett-Packardpart number, indicate the quantity desired, and address the order to thenearest Hewlett-Packard Sales Office. Parts not listed To order a part not on the list of replaceable parts, incl...

Replaceable Parts List HP 16500H Interface Module Replacment Parts Designator HP Part Number QTY Description A3 16500-66514 1 Interface Board H2 0515-0372 6 Machine Screw W1 16500-61613 1 10/40 Cable* W2 16500-61614 1 Mainframe CPU-Interface BoardCable * This cable is only used if the HP 16500H is i...

Index A accessories,1-3 C cables connecting,3-11orientation,2-2 connections,1-3 D direct mail order system,3-14 E echo request,2-5Ethernet installation,2-5expansion frame,2-7 F faulty cable or HP 16500H performance verification,3-3 H HP 16501A Expansion Frame,2-7HP 16505A Prototype Analyzer,2-8 I in...

DECLARATION OF CONFORMITY according to ISO/IEC Guide 22 and EN 45014 Manufacturer’s Name: Hewlett-Packard Company Manufacturer’s Address: Colorado Springs Division1900 Garden of the Gods RoadColorado Springs, CO 80907 U.S.A. declares, that the product Product Name: Prototype Analyzer Model Number(s)...