AEG SANTOU66040I- User Manual

7 Installation Installation Location The appliance should be set up in a well ventilated, dry room.Energy use is affected by the ambient temperature.The appliance should therefore– not be exposed to direct sunlight;– not be installed next to radiators, cookers or other sources of heat;– only be inst...

1 1 2 3 4 5 8 Re-install the grid to the base of the appliance by pushing on to the clasps (a) until they click. ☞ a a Reversing the door The side at which the door opens can be changed from the right side(as supplied) to the left side, if the installation site requires. To reverse the opening direc...

9 3 10 11 9 12 13 Warning! After completion of the door reversing opera-tion, check that the doorgasket adheres to the cabi-net. If the ambient temper-ature is cold (i.e. in Winter),the gasket may not fit per-fectly to the cabinet. In thatcase, wait for the naturalfitting of the gasket oraccelerate ...

10 Installation kit ☞ Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. ☞ 600 550 min. 600 1 1xA 12 1xB 2xC 2 2 1 1 2 Two cabinet securing bracketsare supplied with the installa-tion pack. They need to beass...

15 Refit the covering strip. ☞ 13 A Fitting the plinth Important! For the efficient operation of the appliance, it is important that theoriginal ventilation grid is used.• For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. T...

Power supply A correctly installed, earthed socket is required for the electrical sup-ply. The supply must have a fuse rating of at least 10 Amps. If thesocket is not accessible once the appliance is built in, the electricalinstallation must include suitable means of isolating the appliancefrom the ...

18 ➀ Butter/cheese compartment ➁ Sliding shelf ➂ Bottle shelf ➃ Vegetable drawers ➄ Storage shelves ➅ Thermostat ➆ Frozen food storage/freezing food, icemaking. Prior to Initial Start–Up Please clean the appliance interior and all accessories prior to initial start-up (see section: “Cleaning and Car...

19 Starting up and temperature regulation Connect the appliance to the mains electricity supply.When the refrigerator compartment door is opened, the internal light-ing is switched on.The temperature selector knob is located on the right hand side of therefrigerator compartment. Setting “0” means: O...

Interior Accessories Storage shelves Various glass storage shelves are included with your appliance. The height of the storage shelves can be adjusted:To do this pull the storage shelf forward until it can be swivelled upwards or downwards and removed.Please do the same in reverse to insert the shel...

Freezing and storing frozen food The freezer compartment is for freezing and storing food. Important! • The temperature in the freezer compartment must be –18°C or col- der before freezing fresh food or storing food already frozen. • Do not freeze too large a quantity at any one time (max. 2 kg per ...

Preparation of Ice Cubes Fill the ice cube tray 3/4 full with cold water, place it in the freezer compartment and leave to freeze.To loosen the frozen cubes, either bend the ice cube tray or hold it under running water for a few seconds. Important! Never try to free an ice tray that is frozen to the...

23 Remove frozen food, wrap it in several layers of newspaper and store it, covered, in a cool place.Switch off the appliance and unplug it, or disconnect from the elec-tricity supply.Remove the stopper from the meltwater outlet and place a bowl underneath it to catch the meltwater. Tip: You can spe...

25 Energy Saving Tips • Do not install the appliance near boilers, radiators or other sources of heat. High ambient temperatures cause longer, more frequent operation of the compressor. • Ensure sufficient air circulation and exhaust at the appliance base and at the back wall of the appliance. Never...

27 Changing the light bulb Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it, or disconnect from the power supply.Light bulb data: 220-240 V, max. 15 WTo switch off the appliance, turn the thermostat knob to position "0".Unplu...

28 Service & Spare Parts In the event of your appliance requiring service, or if you wish to pur-chase spare parts, contact your local AEG Service Force Centre by tele-phoning: 08705 929 929 Your call will be automatically routed to the Service Centre coveringyour post code area.For the address ...

29 Guarantee Conditions Standard guarantee conditions We, AEG, undertake that if within 24 months of the date of purchasethis AEG appliance or any part thereof is proved to be defective byreason only of faulty workmanship or materials, we will, at our optionrepair or replace the same FREE OF CHARGE ...

• This guarantee relates to you and cannot be transferred to another user. • Your new home is within European Community (EC) or European Free Trade Area. • The product is installed and used in accordance with our instructions and is only used domestically, i.e. a normal household. • The product is i...

31 Technical terminology • Refrigerant Liquids that can be used to a generate a cooling effect are known asrefrigerants. They have a relatively low boiling-point, indeed so low,that the warmth from the food stored in the fridge or freezer cancause the refrigerant to boil and vaporise. • Refrigerant ...