Page 2 - CONTENTS; AEG Home app
CONTENTS 1. SAFETY INFORMATION...................................................................................... 3 2. SAFETY INSTRUCTIONS.................................................................................... 5 3. PRODUCT DESCRIPTION.....................................................
Page 3 - that your product fault is due to failure to adhere to this manual.; FOR PERFECT RESULTS; spend a few minutes reading to get the very best from it.; CUSTOMER CARE AND SERVICE; Always use original spare parts.; SAFETY INFORMATION; Before the installation and use of the appliance, carefully
IMPORTANT INFORMATION THAT MAY IMPACT YOUR MANUFACTURER'S WARRANTY Adherence to the directions for use in this manual is extremely important for health and safety. Failure to strictly adhere to the requirements in this manual may result in personal injury, property damage and affect your ability to ...
Page 4 - Children and vulnerable people safety
1.1 Children and vulnerable people safety • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance ...
Page 5 - SAFETY INSTRUCTIONS
• Do not exceed the maximum load of 9 kg (refer to the "Program chart" chapter). • The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa). • The ventilation opening in the base must not be covered by a carpet, m...
Page 7 - PRODUCT DESCRIPTION; Start enable you to start a cycle, to
2.6 Service • To repair the appliance contact the Authorised Service Centre. • Use original spare parts only. 2.7 Disposal WARNING! Risk of injury or suffocation. • Disconnect the appliance from the mains electrical and water supplies. • Cut off the mains electrical cable close to the appliance and ...
Page 8 - Appliance overview
3.2 Appliance overview 1 2 3 10 6 7 8 4 11 9 12 13 5 1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Internal light 6 Rating plate 7 Drain pump filter 8 Feet for levelling the appliance 9 Drain hose 10 Inlet hose connection 11 Mains cable 12 Transit bolts 13 Hose support 00000000 00A...
Page 11 - Spanner; Positioning and levelling
It is possible to see water flowing from the drain hose. This is due to the testing with water of the appliance in factory. 15. Remove the three bolts by using the spanner supplied with the appliance. 16. Pull out the plastic spacers. 17. Put the plastic caps, that you find in the user manual bag, i...
Page 14 - a sink spigot - Remove the plastic; Position the hose directly to a built-; Control panel description
5. Without the plastic hose guide, to a sink spigot - Remove the plastic membrane from the sink trap spigot. 6. Connect the drain hose to the spigot and tighten it with a clamp. ø16 1 W011 2 7. Position the hose directly to a built- in drain pipe in the room wall and tighten it with a clamp. 6. CONT...
Page 18 - Skipping phase button
If the Extra Rinse is set as a default option and you select a compatible washing program, the displayshows . In this case, by pressing the Extra Rinse button , it is possible to add just one rinse. 7.7 Plus Steam This option adds a steam phase followed by a short anti-crease phase at the end of the...
Page 21 - Program options compatibility
Program Default temperature Temperature range Reference spin speed Spin speed range Maximum load Steam - - 1 kg Anti-Allergy 60 °C 1400 rpm 1400 rpm - 400 rpm 9 kg 20 min. - 3 kg 30 °C 40 °C - 30 °C 1200 rpm 1200 rpm - 400 rpm 3 kg Outdoor 30 °C 40 °C - Cold 1200 rpm 1200 rpm - 400 rpm 2.5 kg 2) 1 k...
Page 23 - Installing and configuring
Max Power Wi-Fi 2.4 GHz: <20 dBm Wi-Fi 5 GHz: <23 dBm Bluetooth Low Energy 5.0: < 20 dBm Encryption WPA, WPA2 9.1 Installing and configuring "AEG Home" "AEG Home" allows you to control your laundry through a mobile device. It contains a large number of programs, useful featu...
Page 26 - Activating the appliance; Loading the laundry
relevant indicator comes on/goes off. This option adds two rinses and thedisplay shows . 11.4 Soft Plus Set the Soft Plus option to optimise the fabric softener distribution and improve the fabric softness.It is suggested when you use the fabric softener. This option increases slightly the program d...
Page 27 - Check the position of the
12.3 Filling the detergent and additives Before using the detergent dispenser, make sure that the folded tag in thecompartment has been removed. Refer to "Before first use" chapter. Compartment for prewash phase an soak program. Compartment for washing phase.Compartment for liquid additives ...
Page 30 - ProSense phase. The water; Adding garments
12.10 Interrupting a program and changing the options When the program is running, you can change only some options: 1. Touch the Start/Pause button. The related indicator flashes. 2. Change the options. The given information in the display changes accordingly. 3. Touch the Start/Pause button again....
Page 31 - The laundry load
12.14 Draining water out after end of cycle If you have chosen a program or an option that does not empty out the water of the last rinse, the program is completed, but: • The display shows the indicator , the option indicator or and the door locked indicator . The indicator of the running phase fla...
Page 33 - Ecological hints; CARE AND CLEANING; Periodic cleaning; Periodic cleaning helps to extend the
• hardness of the water used.Water hardness is classified by so-called "degrees" of hardness.Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority.You may have to try using the detergent quantity as per manufact...
Page 34 - cleaning draining system, allowing light; Cleaning the drum
14.2 Removing foreign objects Make sure that pockets are empty and all loose elements are tied up before running your cycle. Refer to 'The laundry load' in 'Hints and tips'. Remove any foreign objects (such as metal clip, buttons, coins, etc) that you may find in the door seal, the filters and the d...
Page 36 - Proceed as follows to clean the pump:
Regularly check the drain pump filter and make sure that it is clean. Clean the drain pump if: • The appliance does not drain the water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code . WARNING! • Do not ...
Page 39 - Alarm Codes and Possible failures
15.1 Alarm Codes and Possible failures The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the tables). WARNING! Deactivate the appliance before carrying out any check. With some problems, the display shows an alarm code and theStart/Pause...
Page 42 - opening; Risk of burns! Make sure
Problem Possible solution The display shows . All buttons are inactive, except the the On/Off . • The appliance is downloading any available updates. Wait un‐ til the update process is complete. If you deactivate the appli‐ ance during update, it resumes when you activate the appli‐ ance again. The ...
Page 43 - authorised dealer
CAUTION! Risk of injury! Make sure that the drum is not rotating. If necessary, wait until the drum stops rotating. Make sure that the water level inside the drum is not too high. If necessary, proceed with an emergency drain (refer to «Emergency drain» in «Care and cleaning» chapter). To open the d...
Page 46 - ENVIRONMENTAL CONCERNS
FOR SERVICE or to find the address of your nearest au‐ thorised service centre in Australia PLEASE CALL 1300 363 664 OR EMAIL [email protected] For the cost of a local call (Australia only) FOR SPARE PARTS or to find the address of your nearest spare parts centre in Australia PLEASE CALL 13 13 50 OR...
