AEG LF7E8432B- User Manual

20º 20º 45º 45º Make sure that the inlet hose is not in vertical position. 3. If necessary, loose the ring nut to set it in the correct position. 4. Connect the water inlet hose to the cold water tap with 3/4" thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use an e...

The end of the drain hose must always be ventilated , i.e. the inner diameter of the drain pipe (min. 38 mm - min. 1.5") must be larger than the external diameter of the drain hose. 4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe. 5...

4.3 Stacking kit The tumble dryer can be stacked on the top of the washing machine only by using the correct stacking kit manufactured and approved by AEG . Verify the compatible stacking kit by checking the depth of your appliances. The stacking kit can be used only with the appliances specified in...

5.2 Appliance overview 1 2 3 9 5 6 7 4 10 8 11 12 1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for levelling the appliance 8 Drain hose 9 Inlet hose connection 10 Mains cable 11 Transit bolts 12 Hose support 6. CONTROL PANEL 6.1 Control pane...

1 Programme dial 2 Display 3 Eco touch button (Eco) 4 Time saving touch button (TimeSave) 5 Rinse touch button (Rinse) • Extra rinse option (Extra Rinse) • Skipping wash phase - Only Rinse option (Only Rinse) 6 Start/Pause touch button (Start/Pause) 7 Stain/Prewash touch button (Stains/Prewash) • St...

Washing phase indicator. It flashes during pre-wash and wash phase. Rinsing phase indicator. It flashes during rinse phase. When the Soft Plus option is activated, the indicator appears. Spinning and draining phase indicator. It flashes during spin and drainphase. Steam phase indicator. Anti-crease ...

7.3 Temp. When you select a washing programme, the appliance automatically proposes a default temperature.Touch this button repeatedly until the desired temperature value appears on the display.When the display shows the indicators and , the appliance does not heat the water. 7.4 Spin When you set a...

treat heavily soiled or stained laundry with stain remover. Pour the stain remover intocompartment . The stain remover will be added in the appropriate phase of the washing programme. This option is not available with a temperature lower than 40 °C. • Prewash Use this option to add a pre-wash phase ...

Set this option for slightly or normally soiled items washed at 30°C or higher temperatures.Water and energy consumption may depend on different causes, such as water pressure, its hardness and temperature, ambient temperature, type and quantity of laundry, the set options, spin speed and voltage fl...

Cottons Synthetics Delicates Wool/Silk Steam Anti-Allergy 20 min. - 3 kg Outdoor Duvet Sports Drain only ■ ■ ■ ■ ■ ■ ■ ■ ■ Spin only 1) ■ ■ ■ ■ ■ ■ ■ ■ ■ Stains 2) ■ ■ ■ ■ Prewash ■ ■ ■ ■ ■ Extra Rinse ■ ■ ■ ■ ■ Only Rinse ■ ■ ■ ■ ■ ■ ■ ■ ■ 3) ■ ■ ■ ■ Time Save 4) ■ ■ ■ ■ Delay Start ■ ■ ■ ■ ■ ■ ■ ■...

9. SETTINGS 9.1 Introduction When pressing a key combination, do not tilt your fingers downwards . The sensors of the underneath buttons are sensitive and may interfere with Your choice. 9.2 Child Lock With this option you can prevent that the children play with the control panel.• To activate/deact...

10. BEFORE FIRST USE During installation or before first use you may observe some water in the appliance. This is a residual water left in the appliance after a full functional test in the factory to ensure the appliance is delivered to customers in perfect working order and is no cause for concern....

1. If necessary, touch the Spin button to decrease the spin speed proposed by the appliance. 2. Touch the Start/Pause button: • If you have set , the appliance drains the water and spins. • If you have set , the appliance only drains the water. The option indicator or goes out, while the indicator f...

• Empty pockets and unfold the items. 12.2 Stubborn stains For some stains, water and detergent is not sufficient.We recommend that you pre-treat these stains before you put the items in the appliance.Special stain removers are available. Use the special stain remover that is applicable to the type ...

1 2 2. Remove the top part of the additive compartment to aid cleaning and flush it out under running warm water, to remove any traces of accumulated detergent. After cleaning, replace the top part in its position. 3. Make sure that all detergent residue is removed from the upper and lower part of t...

45° 20° 13.9 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain pump' paragraph. If necessary, clean the pump.When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres of...

• - The mains supply is unstable. Wait until the mains supply is stable. • - No communication between electronic elements of the appliance. Switch it off and switch on again. The programme was not finished properly or the appliance stopped too early. If the alarm code appears again, contact the Auth...

Problem Possible solution The washing results arenot satisfactory. • Increase the detergent quantity or use a different deter- gent. • Use special products to remove the stubborn stains before you wash the laundry. • Make sure that you set the correct temperature.• Decrease the laundry load. Too muc...

5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 15. CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant stand- ards. Different causes can change the data: the quantity and type of laundry and ambient temperature. Water pressure, t...

Programmes Load(kg) Energyconsump-tion (kWh) Waterconsump-tion (litre) Approxi-mate pro-grammeduration(minutes) Remain-ing mois-ture (%) 1) Standard 40°C cotton 4 0.50 42 230 52 1) At the end of spin phase. Off Mode (W) 0.30 Left On Mode (W) 0.30 The information given in the chart above is compliant...

17. QUICK GUIDE 17.1 Daily use 1 2 3 4 • Connect the mains plug to the mains socket. • Open the water tap. • Push the On/Off button to turn the appliance on (1). • Turn the programme dial to set the desired programme (2). • Set the desired options by means of the corresponding touch buttons (3). • P...

Programmes Load Product description Cottons 8 kg White cotton and coloured cotton. Standardprogrammes for the Energy Label consump-tion values. Synthetics 3 kg Synthetic items or mixed fabric items. Delicates 3 kg Delicate fabrics such as acrylics, viscose, poly-ester items. Wool/Silk 1.5 kg Machine...

19. ENVIRONMENTAL CONCERNS Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol with the household wast...