AEG L9FSC969R- User Manual

Do not use an extension hose if the inlet hose is too short. Contact the service centre for the replacement of the inlet hose. 3.5 Water drainage The drain hose should stay at a height of not less than 60 cm and not more than 100 cm. You can extend the drain hose to maximum 400 cm. Contact the autho...

Make sure that the drain hose makes a loop to prevent particles going into the appliance from the sink. 6. Position the hose directly to a built- in drain pipe in the room wall and tighten it with a clamp. 4. PRODUCT DESCRIPTION 4.1 Special features Your new washing machine meets all modern requirem...

Salt Compartment for salt. Read carefully 'The Water Softener technology ( Soft Water)'. Maximum level for detergent/additives quantity. When selecting a prewash phase, put the detergent/ additive in a dosing ball inside the drum. After a washing cycle, if necessary, remove any detergent residue fro...

5.3 Pouring salt The water softener function acts through special resins present in the appliance.To regenerate the resins and make them ready to soften the water pour a special salt in the compartment Salt : 1. Open the detergent dispenser. M ax ▼ Max ▼ Ma x ▼ Sal t 2. Open the compartment Salt . M...

6. BEFORE FIRST USE 1. Make sure that all transit bolts have been removed from the appliance. 2. Make sure that the electrical power is available and the water tap is open. 3. Make sure that there is salt in the compartment marked by Salt and set the proper water hardness level. Refer to "How to...

13 Temperature touch button (Temp.) 7.2 Display MIX Maximum load indicator. The icon flashes during laundry load esti- mation (refer to "PROSENSE load detection" paragraph). Maximum laundry indicator. It flashes when the laundry load exceeds themaximum declared load of the selected programme...

MIX OKO MIX indicator. Steam phase indicator. Anti-crease phase indicator. Child safety lock indicator. Time saving indicator. Temperature indicator. The indicator appears when a cold wash is set. Spin speed indicator. Rinse hold indicator. Quiet indicator. Pre-wash indicator. Stain indicator. Extra...

When the display shows the indicators and , the appliance does not heat the water. 8.4 Spin When you set a programme, the appliance automatically selects the maximum spin speed.Touch this button repeatedly to: • Decrease the spin speed. The display shows only the spin speeds available for the set pr...

If the Extra Rinse is set as a default option and you select a compatible washing programme, the displayshows . In this case, by pressing the Extra Rinse button , it is possible to add just one rinse. 8.7 Plus Steam This option adds a steam phase followed by a short anti-crease phase at the end of t...

8.11 Delay Start With this option you can delay the start of a programme in a more convenient time.Touch the button repeatedly to set the required delay. The time increases by steps of 30 minutes up to 90' and from 2 hours up to 20 h.After touching the Start/Pause button,the display shows the indica...

Programme Default temperatureTemperature range Maximum spin speedSpin speed range Maximum load OKOPower 30 °C60 °C - 30 °C 1600 rpm1600 rpm - 400 rpm 5 kg Anti-Allergy 60 °C 1600 rpm1600 rpm - 400 rpm 9 kg 20 min. - 3 kg 30 °C40 °C - 30 °C 1200 rpm1200 rpm - 400 rpm 3 kg Outdoor 30 °C40 °C - Cold 12...

Cottons Synthetics ColourPro Delicates Wool/Silk Steam OKOPower Anti-Allergy 20 min. - 3 kg Outdoor Plus Steam 1) ■ ■ ■ Soft Plus ■ ■ ■ ■ ■ ■ 1) This option is not available with temperature lower than 40 °C. 2) This option is not available with a temperature lower than 30 °C. 3) If you set the shor...

• The appliance has a malfunction (sequence of short sounds for about 5 minutes). To deactivate/activate the acoustic signals when the programme is completed, touch the Extra Rinse and the Delay Start buttons simultaneously for about 6 seconds. If you deactivate the acoustic signals, they continue o...

1. Open the detergent dispenser. M ax ▼ Max ▼ Ma x ▼ Sal t 2. Put the powder detergent in thecompartment . If using liquid detergent, refer to 'Filling the liquid detergent'. M ax ▼ Max ▼ Ma x ▼ Sal t 3. If desired, pour the fabric softener inthe compartment . Ma x▼ Ma x▼ Ma x▼ Salt 4. Close the det...

In this case, for 30 seconds, it is possible to pause the appliance and remove the exceeding garments.Once removed the exceeding garments, touch the Start/Pause button to start the programme again. The ProSense phase can be repeated up to three times (see point 1). Important! If the laundry amount w...

Press the On/Off button to activate the appliance again. The display shows the end of the last set programme. Turn the programme dial to set a new cycle. If you set a programme or an option that ends with water in the drum, the Stand-by function doesn't deactivate the appliance to remind you to drai...

• Always start a washing programme with the maximum load of laundry allowed. • If you pre-treat the stains, you can use a stain remover when you set a programme with a low temperature. • To use the correct quantity of detergent, refer to the quantity suggested by the detergent producer. 13. CARE AND...

6. Insert the detergent drawer into the guide rails and close it. Run the rinsing programme without any clothes in the drum. M ax ▼ Max ▼ Ma x ▼ Sal t 13.7 Cleaning the drain pump WARNING! Disconnect the mains plug from the mains socket. Regularly check the drain pump filter and make sure that it is...

14. TROUBLESHOOTING WARNING! Refer to Safety chapters. 14.1 Introduction The appliance does not start or it stops during operation.First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. In case of major problems, the acoustic...

Problem Possible solution The appliance makes anunusual noise and vi-brates. • Make sure the levelling of the appliance is correct. Refer to 'Installation instruction'. • Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation instruction'. • Add more laundry in the...

CAUTION! Risk of burns! Make sure that the water temperature is not too high and the laundry is not hot. If necessary, wait until they cool down. CAUTION! Risk of injury! Make sure that the drum is not rotating. If necessary, wait until the drum stops rotating. Make sure that the water level inside ...

15. CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant stand- ards. Different causes can change the data: the quantity and type of laundry and ambient temperature. Water pressure, the supply voltage and the temperature of inlet water may also affect the washing pro-...

16. TECHNICAL DATA Dimension Width/ Height/ Depth/Total depth 600 mm/ 850 mm/ 630 mm/ 660 mm Electrical connection VoltageOverall powerFuseFrequency 230-240 V2200 W13 A50 Hz Level of protection against ingress of solid particlesand moisture ensured by the protective cover, ex-cept where the low volt...

using the correct stacking kit manufactured and approved by AEG . Verify the compatible stacking kit by checking the depth of your appliances. The stacking kit can be used only with the appliances specified in the leaflet provided with the accessory.Read carefully the instructions supplied with the ...