Page 2 - Visit our website for:; CUSTOMER CARE AND SERVICE
CONTENTS 1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 4. PRODUCT DESCRIPTION . ....
Page 4 - SAFETY INSTRUCTIONS; Installation
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard. • The operating water pressure (minimum and maxi- mum) must be between 0,5 bar (0,05 MPa) and 8 bar(0,8 MPa) • The ventilation openings in the base ...
Page 5 - TECHNICAL INFORMATION; Dimensions
Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new sup-plied hose-sets. Old hose sets mustnot be reused. • Before you connect the appliance to new pipes or pipes not used for a longtime, let the water flow until it...
Page 6 - PRODUCT DESCRIPTION
Level of protection against ingress of solid particlesand moisture ensured by the protective cover, ex-cept where the low voltage equipment has no pro-tection against moisture IPX4 Water supply pressure Minimum 0,5 bar (0,05 MPa) Maximum 8 bar (0,8 MPa) Water supply 1) Cold water Maximum load Cotton...
Page 7 - INTERIOR ACCESSORIES; Spanner; CONTROL PANEL
5. INTERIOR ACCESSORIES 1 2 4 5 3 1 Spanner To remove the transit bolts. 2 Plastic caps To close the holes on the rear sideof the cabinet after the removal ofthe transit bolts. 3 Sound barrier To decrease the noise while the ap-pliance operates. 4 Plastic hose guide To connect the drain hose on thee...
Page 8 - Programme knob; B C; Child lock
7.1 TOUCH SCREEN Do not wear gloves when youtouch the buttons.Make sure the touch screen andbuttons are always clean and dry. 7.2 AUTO Off button 1 Press this button to activate or deacti-vate the appliance. A tune sounds whenthe appliance is activated.The AUTO OFF function automaticallydeactivates ...
Page 10 - Memorise a programme; START PAUSE BUTTON; SHORTENED DURATION
G Extra rinsing The indicator bar fills accordingly the numbers of rinses. H Stains Prewash Soak The indicator bar fills accordingly to the set functions. I The default spin speed of the programme. _ _ _ No spin 1) Rinse hold 1) Only available for Spin/Drain programme. J The default temperature of t...
Page 11 - activate
7.10 EXTRA RINSE BUTTON 9 Touch button 9 to add rinsing phases to a programme.Use this function for persons allergic todetergents and in areas where the wateris soft. 7.11 STAIN, PREWASH AND SOAK BUTTON 10 Touch button 10 to set one of the these functions: STAIN Use this function for laundry with ha...
Page 12 - deactivate; PROGRAMMES; Programme
• To deactivate the function touch but- ton 8 and button 7 at the same time until the symbol goes off. 8. PROGRAMMES Programme Tempera-ture Type of loadWeight of load Programmedescription Functions Koch/Bunt- 95° - Cold White and col-oured cottonwith heavy levelof soil.Maximum load10 kg WashRinsesLo...
Page 13 - Daunen
Programme Tempera-ture Type of loadWeight of load Programmedescription Functions Wolle/Seide 40° - ColdRinsesShort spin Machine washa-ble wool as wellas for hand wash-able woollensand delicate fab-rics with «handwashing» caresymbol.Maximum load 2kg WashRinsesShort spin Spin ReductionSpülstopp Daunen...
Page 14 - Super Eco; Dampf Auffrischen
Programme Tempera-ture Type of loadWeight of load Programmedescription Functions Super Eco 0° Mixed fabrics(cotton and syn-thetic items) 8) . Maximum load 3kg WashRinsesLong spin Spin ReductionSpülstoppExtra Spülen BaumwolleEco 9) 60° or 40° White and fastcoloured cottonwith the normalsoil 10) . Max...
Page 15 - Woolmark Certificate; CONSUMPTION VALUES
Dampf Glätten 2) This programme helps to dew-rinkle the laundry. Cotton and synthetic items. up to 1.5 Kg Steam can be used for dried, washed or worn once laundry. These pro-grammes can reduce creases and odours and make your laundry moresmooth.Do not use any detergent. If necessary, remove stains b...
Page 16 - BEFORE FIRST USE; Language setting
Programmes Load (Kg) Energy con- sumption (kWh) Water con- sumption (li- tre) Approxi- mate pro- gramme duration (minutes) Remaining moisture (%) 1) Cottons 60°C 10 1.80 82 185 43 Cottons 40°C 10 1.10 82 185 43 Synthetics 40°C 4 0.60 55 100 35 Delicates 40°C 4 0.70 62 86 35 Wool/Handwash 30 °C 2 0.5...
Page 17 - Clock setting; USING THE APPLIANCE
Change the language after thefirst activation 1. Touch button 11 and button 10 at the same time for some seconds. 2. When display shows the languageset, turn the programme knob to setthe new language. 3. Touch button 6 to confirm the se- lection. 10.2 Clock setting After you set the language, the di...
Page 18 - LOADING THE LAUNDRY; MAX
13. LOADING THE LAUNDRY 1. Open the appliance door. 2. The display ( E ) shows the maximum programme load for the programme( MAX ) and the weight of the laun- dry ( KG ). The text bar on the display tells to add the laundry. 3. Put the laundry in the drum, oneitem at a time. Shake the items be-fore ...
Page 19 - FILLING THE DETERGENT AND ADDITIVES; This is the maximum level for the quantity of liquid additives.; Check the position of the flap
14. FILLING THE DETERGENT AND ADDITIVES The detergent compartment for the prewash phase and thesoak programme.Add the detergent for prewash and soak before the start of theprogramme. The detergent compartment for the washing phase.If you use a liquid detergent, put it immediately before you startthe...
Page 20 - Set the delay start; Steam; STARTING A PROGRAMME
3. To use powder detergent, turn theflap up. 4. To use liquid detergent, turn theflap down. With the flap in the positionDOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid deter- gent than the limit showed inthe flap. – Do not set the prewash phase.– Do not set the de...
Page 21 - To open the appliance door:; AT THE END OF THE PROGRAMME
The appliance adjust auto-matically the cycle time to thelaundry you have put in thedrum to have perfect washingresults in the minimum neces-sary time. After approximate-ly 15 minutes from the start ofthe programme, the displayshows the new time value. 16.1 Interrupt a programme 1. Touch button 6 . ...
Page 22 - HELPFUL HINTS AND TIPS; The laundry load
The washing programme iscompleted, but there is water in thedrum: – The drum turns regularly to prevent the creases in the laundry. – The door stays locked.– You must drain the water to open the door. To drain the water: 1. If necessary, decrease the spinspeed. 2. Touch button 6 . The appliance drai...
Page 23 - CARE AND CLEANING; Descaling
chines. In areas where the water hard-ness is soft it is not necessary to use awater softener.To know the water hardness in your area,contact your local water authority.Obey the instructions that you find onthe packaging of the products.Equivalent scales measure the waterhardness: • German degrees (...
Page 24 - Detergent dispenser; To clean the dispenser:
19.4 Door seal Regularly examine the seal and removeall objects from the inner part. 19.5 Drum Regularly examine the drum to preventlimescale and rust particles.Only use special products to remove rustparticles from the drum.To do this: • Clean the drum with special product for stainless steel. • St...
Page 25 - Drain pump; To clean the drain pump:
19.7 Drain pump Regularly examine the drainpump and make sure that it isclean. Clean the pump if:• The appliance does not drain the wa- ter. • The drum cannot turn.• The appliance makes an unusual noise because of the blockage of the drainpump. • The display shows an alarm code be- cause of the prob...
Page 26 - To clean the water inlet filters:
7. Remove fluff and objects from thepump. 8. Make sure that the impeller of thepump can turn. If this does not oc-cur, contact the service centre. 1 2 9. Clean the filter under the water tapand put it back in the pump into thespecial guides. 10. Make sure that you tighten correctlythe filter to prev...
Page 27 - TROUBLESHOOTING
4. Remove the inlet hose behind theappliance. 5. Clean the filter in the valve with astiff brush or a towel. 45° 20° 6. Install again the inlet hose. Makesure that the couplings are tight toprevent leakages. 7. Open the water tap. 19.9 Emergency drain Because of a malfunction, the appliancecannot dr...
Page 30 - INSTALLATION; Fixing plate kit
Problem Possible cause Possible solution The washing re-sults are not sat-isfactory. The detergent you usedwas not sufficient or cor-rect. Increase the detergent quantityor use a different one. You did not remove thestubborn stains beforeyou wash the laundry. Use special products to removethe stubbo...
Page 31 - Unpacking
21.2 Unpacking 1. Use the gloves. Remove the externalfilm. If necessary, use a cutter. 2. Remove the cardboard top. 3. Remove the polystyrene packagingmaterials. 4. Remove the internal film. 5. Open the door. Remove the poly-styrene piece from the door sealand all the items from the drum. ENGLISH 31
Page 34 - Positioning and levelling
14. Put the plastic caps in the holes.You can find these caps in the usermanual bag. WARNING! Remove all the packaging andthe transit bolts before you installthe appliance. We recommend that you keepthe packaging and the transitbolts for when you move the ap-pliance. 21.3 Positioning and levelling x...
Page 35 - The inlet hose; Water drainage
21.4 The inlet hose 20 O 20 O 20 O 45 O 45 O 45 O • Connect the hose to the appliance. Turn the inlet hose only left or right.Loose the ring nut to set it in the cor-rect position. • Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaksfrom th...
Page 37 - ENVIRONMENT CONCERNS
You can extend the drain hose tomaximum 400 cm. Contact theservice centre for the other drainhose and the extension. 22. ENVIRONMENT CONCERNS Recycle the materials with thesymbol . Put the packaging inapplicable containers to recycle it.Help protect the environment andhuman health and to recycle was...
