AEG L72672NFL- User Manual

Read carefully the instructions supplied with the appliance and with the accessory. WARNING! Do not put the tumble dryer under the washing machine. 4. CONTROL PANEL 4.1 Control panel description 1 2 3 4 5 6 7 8 9 10 1 On/Off button Aan/Uit 2 Programme knob 3 Display 4 Start Pause button (Start/Pauze...

B Spin area: Spin speed indicator No Spin indicator 1) Rinse Hold indicator 1) Only available for Spin/Drain programme. C Display indicators: Washing phase Rinses phase Spin phase Child safety lock Door lockedYou cannot open the appliance door when the symbol is on.You cannot open the appliance door...

Programme TPM Vlekk- en 1) Extra Spoe- len 2) Tijd Bespa- ren 3) Star- tuit- stel Katoen + Voorwas ■ ■ ■ ■ ■ Extra Stil ■ ■ ■ ■ Synthetica ■ ■ ■ ■ ■ ■ Synthetica + Voorwas ■ ■ ■ ■ ■ Strijkvrij ■ ■ ■ ■ ■ Fijne Was ■ ■ ■ ■ ■ ■ Wol/Zijde ■ ■ ■ Centr./Pompen ■ ■ ■ Spoelen ■ ■ ■ ■ Gordijnen ■ ■ ■ ■ Jeans...

6. CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant stand- ards. Different causes can change the data: the quantity and type of laundry and ambient temperature. Water pressure, the supply voltage and the temperature of inlet water may also affect the washing pro- ...

Off Mode (W) Left On Mode (W) 0.48 0.48 The information given in the chart above is compliant with the EU Commission regulation1015/2010 implementing directive 2009/125/EC . 7. SETTINGS 7.1 Acoustic signals The acoustic signals operate when:• You activate the appliance. • You deactivate the applianc...

8.6 TPM With this option you can decrease the default spin speed.The display shows the indicator of the set speed. Additional spin options: No Spin • Set this option to remove all spin phases. • Set it for very delicate fabrics. • To compensate for the absence of spinning, the rinse phase uses more ...

10.3 Filling the detergent and additives Compartment for prewash phase,soak programme or stain remover.Compartment for washing phase.Compartment for liquid additives(fabric conditioner, starch).Maximum level for quantity of liquidadditives.Flap for powder or liquid detergent. Always follow the instr...

Press the button Aan/Uit to activate the appliance again. The display shows the end of the last set programme. Turn the programme knob to set a new cycle. If you set a programme or an option that ends with water in the drum, the AUTO Stand-by function doesn't deactivate the appliance to remind you t...

• If necessary, use a stain remover when you set a programme with a low temperature. • To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water hardness". 11.5 Water hardness If the water hardness in your area is high or moderate, we recomme...

13. TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The appliance does not start or it stops during operation.First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. With some problems, the acoustic signal...

Problem Possible solution You cannot set an op-tion. • Make sure that you press only the wanted touch button(s). After the check, activate the appliance. The programme continues from the point ofinterruption.If the problem occurs again, contact the Authorised Service Centre.If the display shows othe...