Page 2 - CUSTOMER CARE AND SERVICE
CONTENTS 1. SAFETY INFORMATION............................................................................................. 3 2. SAFETY INSTRUCTIONS.............................................................................................4 3. INSTALLATION.............................................
Page 4 - SAFETY INSTRUCTIONS; Installation
• The ventilation opening in the base (if applicable) must not be covered by a carpet, mat, or any floor covering. • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. • Old hose sets must not be reus...
Page 6 - INSTALLATION; Unpacking
3. INSTALLATION WARNING! Refer to Safety chapters. 3.1 Unpacking WARNING! Remove all the packaging and the transit bolts before installing the appliance. WARNING! Use the gloves. 1. Use a cutter to cut through external film. 2. Remove the external film. 3. Remove the cardboard top and the polystyren...
Page 9 - Water drainage
20 O 20 O 45 O 45 O Make sure that the inlet hose is not in vertical position. 3. If necessary, loose the ring nut to set it in the correct position. 4. Connect the water inlet hose to the cold water tap with 3/4" thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use ...
Page 10 - PRODUCT DESCRIPTION; Appliance overview
4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe. 5. Without the plastic hose guide: Put the drain hose in the spigot and tighten it with a clip. Refer to the illustration. Make sure that the drain hose makes a loop to prevent particles ...
Page 11 - CONTROL PANEL; Control panel description
1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for levelling the appliance 8 Drain hose 9 Inlet hose connection 10 Mains cable 11 Transit bolts 12 Hose support 5. CONTROL PANEL 5.1 Control panel description On/Off 95° 1600 1200 800 Stains Rins...
Page 12 - Display; DIAL AND BUTTONS; Introduction
5.2 Display A B E D C A The digital indicator can show:• Programme duration (e. g. ). • Delay time (e. g. or ). • Cycle end ( ).• Warning code ( ). B Extra rinse indicator. It lights on when this option is se-lected . C The indicator blink during the laundry load detec- tions. D Child safety lock in...
Page 13 - Spin; Options; Delay Start
6.3 Temp. When you select a washing programme, the appliance automatically proposes a default temperature.Set this option to change the default temperature. The indicator = cold water of the set temperature comes on (the appliance does not heat the water). 6.4 Spin When you set a programme, the appl...
Page 14 - PROGRAMMES; Programme Chart
Touch this button once to decrease the duration.In case of smaller load, touch this button twice to set an extra quick programme. The indicator of the option and the indicator of the set value are on. 6.8 Start/Pause Touch the Start/Pause button to start, pause the appliance or interrupt a running p...
Page 17 - SETTINGS; Child Lock; BEFORE FIRST USE
7.2 Woolmark Apparel Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments labelled as «hand wash» provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine. Follow the g...
Page 18 - DAILY USE
10. DAILY USE WARNING! Refer to Safety chapters. 10.1 Activating the appliance 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3. Press the On/Off button for a few seconds to activate the appliance. A short tune sounds (if activated). The programme dial is automatically set on ...
Page 19 - Setting a programme
1 2 3. To use powder detergent, turn the flap up. 4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. • Do not set the prewash phase. • Do not set ...
Page 21 - Opening the door
If the ProSense phase is already carried out and the water filling is already started, the new programme starts without repeating the ProSense phase . The water and the detergent are not drained out in order to avoid waste. 10.11 Opening the door If the temperature and level of the water in the drum...
Page 22 - HINTS AND TIPS; The laundry load
• After 5 minutes from the end of the washing programme Press the On/Off button to activate the appliance again. The display shows the end of the last set programme. Turn the programme dial to set a new cycle. If you set a programme or an option that ends with water in the drum, the Stand-by functio...
Page 23 - CARE AND CLEANING
11.4 Ecological hints • Set a programme without the prewash phase to wash laundry with normal soil. • Always start a washing programme with the maximum load of laundry allowed. • If you pre-treat the stains, you can use a stain remover when you set a programme with a low temperature. • To use the co...
Page 27 - TROUBLESHOOTING
45° 20° 12.9 Emergency drain If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain filter' paragraph. If necessary, clean the pump. 12.10 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° ...
Page 28 - Possible failures
WARNING! Deactivate the appliance before carrying out any check. 13.2 Possible failures Problem Possible solution The programme does not start. • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance door is closed.• Make sure that there is not a damaged fuse...
Page 30 - CONSUMPTION VALUES; TECHNICAL DATA
14. CONSUMPTION VALUES The data in this table are approximate. Different variables can affect the data: the quantity and type of laundry, the water and ambient tempera- ture. During the washing programme, the Prosense technology can vary the wash duration and the consumption values. For more details...
Page 31 - ACCESSORIES; Available in
Electrical connection VoltageOverall powerFuseFrequency 230-240 V2200 W13 A50 Hz Level of protection against ingress of solid particlesand moisture ensured by the protective cover, ex-cept where the low voltage equipment has no pro-tection against moisture IPX4 Water supply pressure 1) MinimumMaximu...
Page 32 - ENVIRONMENTAL CONCERNS
Verify the compatible stacking kit by checking the depth of your appliances. The stacking kit can be used only with the appliances specified in the leaflet provided with the accessory.Read carefully the instructions supplied with the appliance and with the accessory. WARNING! Do not put the tumble d...
