AEG L60688- User Manual

Main features of your washing machine • Programme and temperature setting using the programme selector. • Stain programme for effectively treating stained washing. • Energy saving programme for normally soiled cotton items. • Speed for the final spin can be reduced to 700, 600 or 400 rpm. • RINSE HO...

Description of the appliance Front view 53 Waschmittelschublade Bedienblende Einfülltür Flusensieb höhenverstellbare Füße 95 60 50 4030 60 50 40 40 FRIO 30 40 FRIO 30 FRIO 40 FRIO ECONOMIA CENTRIF. DELICADOCENTRIFUGADODESCARGASUAVIZANTESACLARADOS L 60688 LAVAMAT FACIL DE PLANCHAR 850700 600400 PRELA...

Control panel A = Option buttonsB = Spin speed buttonC = DisplayD = Delay start buttonE = START/PAUSE buttonF = Programme progress displayG = Programme selector dial Programme selector dial The programme selector determines the type of washing cycle (e.g. waterlevel, drum movement, number of rinses)...

Programme Option buttons Depending on the programme, different functions can be combined.These must be selected after choosing the desired programme and beforedepressing the START/PAUSE button.When these buttons are pressed, the corresponding pilot lights come on.When they are pressed again, the pil...

By depressing at the same time buttons PRELAVADO and MANCHAS theacoustic signal at the end of programme is switched off. SPIN SPEED Press this button to reduce the maximum speed of the finalspeed proposed by the machine for the selected programmeor to select option AGUA EN LA CUBA (RINSE HOLD).The m...

Programme progress display By selecting the wash programme, the pilot lightscorresponding to the various phases making upthe programme come on.After the machine has started, only the run-ning phase pilot light stays on. When the pro-gramme has finished, the END (FIN) pilot lightcomes on. When the pr...

Cancelling a programme To cancel a programme which is running, turn the programme selectordial to the RESET O position. Warning! After a programme which ends with water in the drum (RINSE HOLD option), turn the selector dial first to O and then to the DRAIN programme DESCARGA. Altering a programme w...

Detergent dispenser drawer Compartment for prewash or soak detergent and stain remover. The prewashor soak detergent is added at the beginning of the wash programme. The stainremover is added during the STAIN-Action phase in the main wash. Compartment for powder or liquid detergent used for main was...

Preparing the wash cycle Sorting out and preparing the laundry • Sort out the laundry according to type of fabrics and care labels (see “Types of fabric and care labels”). • Empty pockets. • Remove any metal parts (safety pins, clips, etc.). • To prevent the laundry from getting damaged and forming ...

Weight of laundry Types of fabric and care labels The labels on garments help you to select the most suitable wash pro-gramme. The laundry should be sorted out according to the type of fab-ric and the instructions indicated on care labels.Temperatures indicated on labels are always maximum temperatu...

Detergents and additives Which detergent and additive? Use only detergents and additives for washing machines. Follow themanufacturer’s instructions. How much detergent? The quantity depends on: • the load: if the manufacturer does not provide any indications on the amount ofdetergent for small load...

How to wash Load the laundry Open the door. Place the laundry in the drum, one item at a time. Distribute laundry asevenly as possible. Close the door. Add detergent and additives Pull the drawerout till it stops. Pour the mainwash detergentinto compartment . If you wish to per-form a prewash, aSOAK...

EXTRA RINSE This appliance is designed for saving water. However, for people with avery delicate skin (allergic to detergents) it may be necessary to rinsethe laundry using an extra quantity of water (extra rinse). The extra rinse is available only with the cotton, synthetics or delicateprogramme. S...

Starting the programme 1. Check that the water tap is open. 2. Press START/PAUSE to start the programme.If the Delay Start option has been selected the programme will start atthe end of the countdown.If the door light PUERTA is red and flashing at the start of the pro-gramme it indicates that the do...

If the light SOBREDOSIFICACION (OVERDOSAGE) comes on it indicatesthat too much detergent has been used. At the next wash carefully fol-low the detergent manufacturer’s instructions. Measure out detergentaccording to amount, type, degree of soil of fabrics and water hardness. This light could come on...

Programme chart Wash programmes In compliance with EC directive 92/75, the consumption figures indicated on theenergy label refer to the 60°C wash programme for cotton with a load of 5 kg. * The consumption data shown on this chart is to be considered purely indicative, as it may vary depending on t...

Programme chart Special programmes * The consumption data shown on this chart is to be considered purely indicative, as it may vary depending on the quantity and type of laundry, onthe inlet water temperature and on the ambient temperature. It refers to aload of 5 kg for cotton items. 71 Programme D...

Cleaning and maintenance After each wash At the end of the wash programme, pull the dispenser drawer out a lit-tle to let it dry. Leave the door ajar to allow air to circulate. If the machine is not used for a prolonged period: Close the water tap and unplug the appliance. Periodical cleaning Exteri...

Something not working? If during the spin cycle the machine makes an unusualwhistling noise, different from the noise made by tradi-tional washing machines, this is due to a new type ofmotor. If water is not visible in the drum, this is dueto the modern technology of new washingmachines that use les...

Unsatisfactory washing results If the laundry looks grey and lime scale is found in the drum • Too little detergent has been used. • An unsuitable detergent has been used. • Stubborn stains have not been treated prior to washing. • The programme/temperature has not been correctly selected. If grey s...

Technical data Height x Width x Depth 85x60x60 cm Depth with door opened 101 cm Height adjustment ± 13 mm approx. Load (depending on programme) 6 kg max. Use domesticDrum speed during washing max. 55 rpm Drum speed during spinning 850/700/600/400 rpm Water pressure 50-800 kPa This appliance complies...

Service In the section “Something not working?” some problems that can besolved by yourself are listed. Read this section in the event of problems.If you are not able to find a solution, contact the Service centre.(Addresses and telephone numbers are given on the enclosed leaflet).In all cases, expl...

Instructions for installation and electrical connection Safety instructions for the installer • This appliance is heavy, care should be taken when moving it. • When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the retailer. • All internal packing must...

Dimensions of the appliance Front view and side view Rear view 82 90 600 835 10 95 60 50 4030 60 50 40 40 FRIO 30 40 FRIO 30 FRIO 40 FRIO ECONOMIA CENTRIF. DELICADOCENTRIFUGADODESCARGASUAVIZANTESACLARADOS L 60688 LAVAMAT FACIL DE PLANCHAR 850700 600400 PRELAVADO LAVADO ACLARADOS ACLARADO ADICIONAL C...

Installation Unpacking All transit bolts and packing must be removed before using the appli-ance. Using a spanner, unscrew and remove therear right-hand bolt and lay the machine onits back, taking care not to squash the hoses.This can be avoided by placing one of thecorner packing pieces between the...

Positioning Install the machine on a flat hard floor.Make sure that air circulation around the machine is not impeded by car-pets, rugs etc.• Before placing it on small tiles, apply a rubber coating.• Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar ma...

Water drainage The end of the drain hose can be positionedin three ways: Hooked over the edge of a sink using theplastic hose guide supplied with themachine. In this case, make sure the end can- not come unhooked when the machine isemptying.This could be done by tying it to the tap witha piece of st...

Permanent connection In the case of a permanent connection it is necessary that you install adouble pole switch between the appliance and the electricity supply(mains), with a minimum gap of 3 mm between the switch contacts andof a type suitable for the required load in compliance with the currentel...